TRANSMISSION ASSEMBLY
MT-59
D
E
F
G
H
I
J
K
L
MA
B
MT
Revision: 2006 November2007 350Z
CAUTION:
Do not hold control lever housing to prevent bushing of control lever housing from deformation
when moving transmission assembly.
22. Apply gear oil to return spring plungers.
23. Install return spring plungers and return springs into the rear
extension, apply recommended sealant to threads of return
spring plugs, and then tighten return spring plugs to the speci-
fied torque. Refer to MT-26, "
Shift Control Components" .
Use Genuine Silicone RTV or an equivalent. Refer to GI-
45, "RECOMMENDED CHEMICAL PRODUCTS AND SEAL-
ANTS" .
CAUTION:
The right and left return springs and return spring plungers are different, so make sure they are
installed correctly.
Remove old sealant and oil adhering to threads.
24. Install shift check pin as a one unit with the control bracket to
rear extension and then tighten mounting bolts to the specified
torque. Refer to MT-26, "
Shift Control Components" .
25. Install plunger to the rear extension, and then screwing Park/
Neutral position (PNP) switch and back-up lamp switch to the
rear extension with 1-2 pitches. Apply recommended sealant to
threads of switches, and tighten switches to the specified
torque. Refer to MT-22, "
Case Components" .
Use Genuine Silicone RTV or an equivalent. Refer to GI-
45, "RECOMMENDED CHEMICAL PRODUCTS AND SEAL-
ANTS" .
CAUTION:
Remove old sealant and oil adhering to threads.
26. Install brackets to rear extension and then tighten bracket mounting bolts to the specified torque. Refer tp
MT-22, "
Case Components" .
27. Install boot and control rod to striking rod.
28. Install retaining pin into the control rod, using a pin punch.
CAUTION:
Do not reuse retaining pin.
29. Install boot to control rod.
CAUTION:
Fit the boot to the groove on the control rod.
Region Return spring identification mark Plunger groove
RH Brown No
LH Blue Yes
SCIA1607E
PCIB1346E
SCIA1437E
