ROAD WHEEL AND TYRE ASSEMBLY
WT-5
C
D
F
G
H
I
J
K
L
MA
B
WT
c. If calculated balance weight value exceeds 50 g (1.76 oz), install
two balance weight pieces in line with each other as shown in
the figure.
CAUTION:
Do not install one balance weight sheet on top of another.
3. Start tyre balance machine again.
4. Install drive-in balance weight on inner side of road wheel in the
tyre balance machine indication position (angle).
CAUTION:
Do not install more than two balance weights.
5. Start tyre balance machine. Make sure that inner and outer
residual unbalance values are 10 g (0.35 oz) each or below.
If either residual unbalance value exceeds 10 g (0.35 oz), repeat installation procedures.
RotationBES0004J
Follow the maintenance schedule for tyre rotation service inter-
vals. Refer to MA-8, "
PERIODIC MAINTENANCE" .
Do not include the spare tyre when rotating tyres.
CAUTION:
When installing wheels, tighten them diagonally by divid-
ing the work two to three times in order to prevent the
wheels from developing any distortion.
Be careful not to tighten wheel nut at torque exceeding
the criteria for preventing strain of disc rotor.
Maximum allowable unbalanceDynamic (At rim flange) Less than 10 g (0.35 oz) (one side)
Static (At rim flange) Less than 20 g (0.71 oz)
SMA056D
Tightening torque of wheel nut:
108 N·m (11 kg-m, 80 ft-lb)SMA829C
WW-34
FRONT WIPER AND WASHER SYSTEM
Removal and Installation of Front Wiper Arms, Adjustment of Wiper Arms Stop
Location
BKS003W6
REMOVAL
1. Turn front wiper switch ON to operate wiper motor, then turn front wiper switch OFF (auto stop).
2. Open hood, remove front wiper arm caps, and remove front wiper arm nuts.
3. Raise front wiper arms, and remove front wiper arms from the vehicle.
INSTALLATION
1. Clean up the pivot area as shown in the figure. This will reduce
possibility of front wiper arm nuts looseness.
2. Prior to front wiper arms installation, turn front wiper switch ON
to operate wiper motor, and then turn front wiper switch OFF
(auto stop).
3. Lift the blade up and then set it down onto windshield glass sur-
face to set the blade center to clearance “L1” & “L2” immedi-
ately.
4. Tighten front wiper arm nuts to specified torque.
5. Spray washer fluid. Turn on wiper switch ON to operate wiper
motor, and then turn front wiper switch OFF (auto stop).
6. Make sure that wiper blades stop within clearance “L1” & “L2”.
7. Install wiper arm caps.
Removal and Installation of Front Wiper Drive AssemblyBKS003W7
REMOVAL
1. Remove front wiper arms. Refer to WW-34, "REMOVAL" .
2. Remove cowl top covers (RH, LH). Refer to EI-21, "
COWL TOP" .
3. Disconnect wiper motor connector (1).
4. Remove front wiper drive assembly mounting bolts (A), and
remove front wiper drive assembly (2) from the vehicle.
SEL024J
Front wiper arm nuts : 23.5 N·m (2.4 kg-m, 17 ft-lb)
Clearance “L1” : 27.6 ± 7.5 mm (1.087 - 0.295 in)
Clearance “L2” : 36.1 ± 7.5 mm (1.421 - 0.295 in)
PKIA9951E
PKID0309E
