reset NISSAN TIIDA 2007 Service Owner's Guide

VTL-20
< ON-VEHICLE REPAIR >[AUTOMATIC AIR CONDITIONER]
INTAKE DOOR MOTOR
INTAKE DOOR MOTOR
Removal and InstallationINFOID:0000000001696288
REMOVAL
1. Remove the instrument lower finisher and instrument lower cover (LH) for LHD only. Refer to IP-11,
"Removal and Installation".
2. Remove the glove box assembly and instrument lower cover (RH) for RHD only. Refer to IP-11, "
Removal
and Installation".
3. Disconnect the intake door motor connector (A).
4. Remove the intake door motor screws (B), and then remove the
intake door motor (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installing door motor, perform door motor starting position reset by following self-diagnosis
STEP-3. Refer to HAC-213, "
Front Air Control Self-Diagnosis".
SJIA0692E

AIR MIX DOOR MOTOR
VTL-21
< ON-VEHICLE REPAIR >[AUTOMATIC AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
MA
B
VTL
N
O
P
AIR MIX DOOR MOTOR
Removal and InstallationINFOID:0000000001696289
REMOVAL
1. Remove the instrument lower finisher and instrument lower cover (LH) for LHD only. Refer to IP-11,
"Removal and Installation".
2. Remove the glove box assembly and instrument lower cover (RH) for RHD only. Refer to IP-11, "
Removal
and Installation".
3. Remove the console box assembly. Refer to IP-11, "
Removal and Installation".
4. Remove the instrument stay nuts (A) and harness clamps (B),
and then remove instrument stay (1).
5. Remove the air mix door motor screws (A), and then pull out the
air mix door motor (1).
6. Disconnect the air mix door motor connector and remove the air
mix door motor (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installing door motor, perform door motor starting position reset by following self-diagnosis
STEP-3. Refer to HAC-213, "
Front Air Control Self-Diagnosis".
SJIA0646E
SJIA0695E

VTL-22
< ON-VEHICLE REPAIR >[AUTOMATIC AIR CONDITIONER]
MODE DOOR MOTOR
MODE DOOR MOTOR
Removal and InstallationINFOID:0000000001696290
REMOVAL
1. Remove the glove box assembly and instrument lower cover (RH) for LHD only. Refer to IP-11, "Removal
and Installation".
2. Remove the instrument lower finisher and instrument lower cover (LH) for RHD only. Refer to IP-11,
"Removal and Installation".
3. Remove the mode door motor screws (A), and then pull out the
mode door motor (1).
4. Disconnect mode door motor connector and remove the mode
door motor (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installing door motor, perform door motor starting position reset by following self-diagnosis
STEP-3. Refer to HAC-213, "
Front Air Control Self-Diagnosis".
SJIA0694E