wiper NISSAN TIIDA 2009 Service Manual PDF

OK >> Replace BCM. Refer to
BCS-18, " Removal and Installa-
tion of BCM " .
NG >> Replace rear wiper motor. Refer to WW-32, " Removal
and Installation " .
Only Rear Wiper Does Not Operate INFOID:0000000004306943OK >> Replace BCM. Refer to
BCS-18, " Removal and Installation of BCM " .
NG >> Check the wiper switch. Refer to BCS-3, " System Description " .
Only Rear Wiper Intermi ttent Does Not Operate INFOID:0000000004306944OK >> Replace BCM. Refer to
BCS-18, " Removal and Installation of BCM " .
NG >> Check the wiper switch. Refer to BCS-3, " System Description " .
Wiper Does Not Wipe When Rear Washer Operates INFOID:0000000004306945OK >> Replace BCM. Refer to
BCS-18, " Removal and Installation of BCM " .
NG >> Check the wiper switch. Refer to BCS-3, " System Description " .
Removal and Installation INFOID:0000000004306946
REAR WIPER ARM
Removal 2 - Ground : Battery voltage should exist.

WW
N
O P
1. Raise wiper arm cover (1), and remove the rear wiper arm nut
(A).
2. Remove the wiper arm.
3. Remove wiper blade.
Installation 1. Operate rear wiper motor one full c ycle, then turn "OFF" (Auto Stop).
2. Clean pivot area as shown. This will reduce the possibility of wiper arm looseness.
3. Install wiper blade.
4. Install wiper arm so that the arm rests in the stopper and tighten rear wiper arm nut.
5. Install wiper arm cover.
REAR WIPER MOTOR SEL024J

Removal and Installation " .
5. Disconnect the rear wiper motor connector (B).
6. Remove the bolts (A) and remove the rear wiper motor (1).
Installation
Installation is in the reverse order of removal.
CAUTION:
Do not drop the wiper motor or cause it to contact other parts.
REAR WASHER TUBE LAYOUT
NOTE:
Connect the check valve (2) to the washer fluid tube (1) so that the
directional arrow on the check valve (2) points towards the washer
nozzle tube (3).
REAR WASHER NOZZLE WKIA4242E

WW
N
O P
Removal
1. Remove the back door window garnish. Refer to EI-38, " Removal and Installation " .
2. Disconnect rear washer tube from rear washer nozzle.
3. Release retaining clips and remove washer nozzle.
Installation Installation is in the reverse order of removal.
NOTE:
Inspect rear washer nozzle for proper spray pattern, adjust as necessary. Refer to WW-35, " Washer Nozzle
Adjustment " .
WASHER FLUID RESERVOIR Refer to WW-23, " Removal and Installation of Washer Tank " .
WIPER AND WASHER SWITCH Refer to WW-23, " Removal and Installation of Front Wiper and Washer Switch " .
WASHER MOTOR Refer to WW-24, " Removal and Installation of Front Washer Motor " .
Washer Nozzle Adjustment INFOID:0000000004306947
Adjust the washer nozzle to specification using suitable tool as
shown.
• Rear washer nozzle (1)
• Back glass (2)
• Center line (A)
• 148 mm (5.83 in) (B)
• 27 mm (1.06 in) (C)
• 35 mm (1.38 in) (D)
• Black printed area (E)
• Spray target area (F) WKIA6042E