jacking NISSAN TITAN 2008 1.G Quick Reference Guide

FRONT sEAT ADJ usTMENT s
With manual seats (if so equipped):
 Pull up on the lever under the front of the seat and slide
backward or forward; release.
 Lift the lever 01 on
the side of the seat to adjust your
seatback backward or forward; release when you have
found a comfortable angle and the seat belt fits properly.
With power seats (if so equipped):
 Move the control 02 forward
or backward to adjust the
seat cushion forward or backward.
 Pull up on the control 02 to
raise the seat cushion;
press down to lower the cushion.
 Push the switch 03 forward
to move the seatback
forward; push it back to move the seatback backward.
L u MBAR suPPORT
(if so equipped)
Your driver’s seat has a lumbar support; adjust it by moving
the lever
04 up
or down.
0302
01
04
FOLDIN g THE REAR BENCH sEAT
To fold the rear bench seat for storage capacity behind the front seats, or to remove the
jacking tools from the storage area:
 Lift up on the lever 01, located on the side of the seat, while lifting the front of the
seat cushion up.
 Fold the bottom of the seat cushion toward the back of the vehicle until it locks in place.
 Repeat this process to raise and secure the seat cushion on the other side of the
vehicle for maximum storage capacity.
01
HOMELINK® u NIVER sAL TRAN sCEIVER (if so equipped)
SYST eM OP eR aTIN g TIPS
 Garage doors, electrical gates, entry doors, etc. will be activated during programming.
To avoid injury, make sure that people and objects are clear of all doors or gates
during programming. Your vehicle’s engine should be turned off while programming
the HomeLink
® Transceiver. Refer to your Owner’s Manual for complete details.16