ABS NISSAN TITAN 2016 2.G User Guide

WARNING
●Operating the engine with the air
cleaner removed can cause you or oth-
ers to be burned. The air cleaner not
only cleans the air, it stops the flame if
the engine backfires. If it isn’t there, and
the engine backfires, you could be
burned. Do not drive with the air cleaner
removed, and be careful when working
on the engine with the air cleaner
removed. ●
Never pour fuel into the throttle body or
attempt to start the engine with the air
cleaner removed. Doing so could result
in serious injury.
To remove the filter from the air cleaner, push the
tabs and pull the cover upward.
The viscous paper type filter element should not
be cleaned and reused. Replace the air filter
according to the maintenance log shown in the
“Maintenance” section of this manual.
When replacing the air filter, wipe the inside of
the air cleaner housing and the cover with a damp
cloth.
NOTE:
After installing a new air cleaner, make
sure the air cleaner cover is seated in the
housing and latch the tabs.
For additional information on the Cummins 5.0L
engine air cleaner, refer to the “Titan Diesel Own-
er’s Manual”.
IN-CABIN MICROFILTER
The in-cabin microfilter restricts the entry of air-
borne dust and pollen particles and reduces
some objectionable outside odors. The filter is
located behind the glove box. For additional in-
formation on change intervals, refer to “Standard
maintenance” in the “Maintenance” section of this
manual.
If replacement is required, it is recommended that
you visit a NISSAN dealer for this service.
VK56VD engine
LDI2960
AIR CLEANER
Do-it-yourself8-17

WARNING
Properly adjust the weight distributing
hitch so the rear of the bumper is no
higher than the measured reference
height when the trailer is attached. If the
rear bumper is higher than the measured
reference height when loaded, the vehicle
may handle unpredictably which could
cause a loss of vehicle control and cause
serious personal injury or property
damage.
Sway control device
Sudden maneuvers, wind gusts, and buffeting
caused by other vehicles can affect trailer han-
dling. Sway control devices may be used to help
control these affects. If you choose to use one,
contact a reputable trailer hitch supplier to make
sure the sway control device will work with the
vehicle, hitch, trailer and the trailer’s brake sys-
tem. Follow the instructions provided by the
manufacturer for installing and using the sway
control device.
Class I hitch
Class I trailer hitch equipment (receiver, ball
mount and hitch ball) can be used to tow trailers
of a maximum weight of 2,000 lb (907 kg) .
Class II hitch
Class II trailer hitch equipment (receiver, ball
mount and hitch ball) can be used to tow trailers
of a maximum weight of 3,500 lb (1,587 kg).
Class III hitch
Class III trailer hitch equipment (receiver, ball
mount and hitch ball) can be used to tow trailers
of a maximum weight of 5,000 lb (2,268 kg).
Class IV hitch
Class IV trailer hitch equipment (receiver, ball
mount and hitch ball) can be used to tow trailers
of a maximum weight of 10,000 lb (4,535 kg). A
weight distributing hitch should be used to tow
trailers that weigh over 5,000 lb (2,268 kg).
Your vehicle may be equipped with Class IV
trailer hitch equipment that has a 10,000 lb
(4,535 kg) maximum weight rating, but your ve-
hicle is only capable of towing the maximum
trailer weights shown in the “Towing
Load/Specification” chart in this section.
5th wheel/gooseneck
A 5th wheel or gooseneck trailer can be towed by
installing a 5th wheel or gooseneck trailer hitch.
These types of hitches are mounted in the bed of
the pick-up. A professional trailer equipment sup-
plier should install these hitches as it is veryimportant to mount the hitch correctly to distrib-
ute the king pin weight for the proper load carry-
ing and sway control performance.
The king pin weight should be 15% of the fully
loaded trailer. Make sure the king pin weight does
not cause the gross vehicle weight to exceed the
Gross Maximum Weight Rating or the rear axle
weight to exceed the Rear Gross Axle Weight
rating. For additional information, refer to “Maxi-
mum load limits” in this section.
The weight of the trailer should not exceed the
maximum towing capacity for the vehicle. For
additional information, refer to “Towing
Load/Specification” chart in this section.
Make sure the trailer design allows for the correct
vehicle to trailer clearances before purchasing a
5th wheel trailer.
WARNING
●
The hitch should not be attached to or
affect the operation of the impact-
absorbing bumper.
● Do not use axle-mounted hitches.
● Do not modify the vehicle exhaust sys-
tem, brake system, etc. to install a
trailer hitch.
10-38Technical and consumer information

11 Index
4WD.......................5-44
4WDwarninglight...............2-20
4-Wheel Drive.................5-44
A
Aiming control, headlights ...........2-53
Air bag (See supplemental restraint
system) .....................1-45
Air bag system Front (See supplemental front impact air bag
system) ...................1-52
Airbagwarninglabels.............1-57
Airbagwarninglight...........1-58,2-26
Air bag warning light, supplemental . .1-58, 2-26
AirCleaner ...................8-17
Air cleaner housing filter ............8-17
Air conditioner Air conditioner operation ..........4-36
Air conditioner specification label ....10-14
Air conditioner system refrigerant and
oil recommendations ............10-8
Air conditioner system refrigerant
recommendations ..............10-8
Heater and air conditioner (automatic)
(if so equipped) ...............4-41
Heater and air conditioner controls ....4-42
Servicing air conditioner ..........4-44
Airflowcharts..................4-37
Anchor point locations .............1-30
Antenna .....................4-82
Antifreeze ....................5-63 Anti-lock brake warning light
..........2-20
Anti-lock Braking System (ABS) ........5-54
Apps .......................4-83
AroundView®Monitor.............4-16
Audible reminders ...............2-29
Audio system ..................4-45
AMradioreception.............4-45
Bluetooth®audio..........4-78,4-79
Bluetooth® streaming audio ....4-78,4-79
Compact disc (CD) player . .4-55, 4-61, 4-68
FM/AM radio with compact disc (CD)
player ....................4-53
FM/AM/SAT radio with compact disc (CD)
player.................4-57,4-63
FMradioreception.............4-45
iPod® Player .............4-73,4-75
iPod® player operation .......4-73,4-75
Radio ....................4-45
Steering wheel audio control switch . . .4-81
USB interface ............4-69,4-71
USB (Universal Serial Bus) Connection
Port .....................4-71
Autolight switch .................2-51
Automatic Automatic drive positioner .........3-36
Automatic power window switch .....2-82
Driving with automatic transmission ....5-17
Automatic anti-glare inside mirror . . .3-27, 3-28
Automatic door locks ..............3-7
Automatic drive positioner ...........3-36
Automatic transmission fluid temperature
gauge.......................2-9
AUXjack ....................4-69 B
Back button ....................4-7
Battery ..................5-63, 8-13
Charge warning light ............2-22
Battery replacement ..............8-23
Keyfob ...................8-23
NISSAN Intelligent Key® ..........8-24
Before starting the engine ...........5-14
Belt (See drive belt) ..............8-15
Blind Spot Warning (BSW) warning
system......................5-22
Block heater Engine ....................5-64
Bluetooth® audio ............4-78,4-79
Bluetooth® hands-free phone
system.................4- 114, 4-127
Boosterseats..................1-42
Brake Anti-lock Braking System (ABS) ......5-54
Brake fluid ..................8-11
Brakelight(Seestoplight).........8-28
Brake system ................5-53
Brakewarninglight.............2-21
Brakewearindicators........2-29,8-19
Parking brake operation ..........5-22
Self-adjusting brakes ............8-19
Brake fluid ....................8-11
Brakes ......................8-19
Brake

system ..................5-53
Break-inschedule ...............5-42
Brightness/contrast button ...........4-9

INSPECTION
Inspect the fuel filter housing and module for
cracks, passage blockages, and other damage. If
damage is found, replacement is mandatory.
It is recommended that you visit a NISSAN dealer
for this service.
INSTALLATION
CAUTION
Do not pre-fill the fuel filter with fuel.
Pre-filling the filter can result in debris
entering the fuel system and damaging
fuel system components.
10. Lubricate the inner seal of the fuel filter ele- ment with petroleum jelly or white lithium
grease.
11. Install a new o-ring on the housing. Lubricate the o-ring with petroleum jelly or white
lithium grease. NOTE:
If you are using a new fuel filter housing
that has not had fuel in it, lubricate the lip
seal at the bottom of the fuel filter element
with petroleum jelly or white lithium grease
before placing it into the housing.
12. Install the fuel filter element into the fuel filter
housing and make sure the four tabs
Fare
properly seated into the four slots
G.
13. Install the fuel filter housing on the module.
Fuel filter housing tightening torque: 21 ft-lb (28 N·m)
14. Connect the wiring harness to the water-in- fuel sensor.
15. Connect the batteries.
16. Prime the fuel system. For additional infor- mation, refer to “Fuel system priming” in this
section.
LDI2897
6-12Do-it-yourself