belt Oldsmobile Achieva 1995 s Workshop Manual

Care of Safety Belts
Keep belts clean and dry.
Glass
Glass should be cleaned often. GM Glass Cleaner (GM
Part No. 1050427) or a liquid household glass cleaner
will remove normal tobacco smoke and dust films.
Don't use abrasive cleaners on glass, because they may
cause scratches. Avoid placing decals
on the inside rear
window, since they may have to be scraped off later.
If
abrasive cleaners are used on the inside of the rear
window, an electric defogger element may be damaged.
Any temporary license should not be attached across the
defogger grid.
Cleaning the Outside of the
Windshield and Wiper
Blades
If the windshield is not clear after using the windshield
washer,
or if the wiper- blade chatters when running, wax
or- other nuterial may be 011 the blade 01- windshield.
Clean the outside
of the windshield with GM
Windshield Cleaner, Bon-Ami Powder"." (GM Part No.
105001 1). 'The wir~dshield is clean if beads do not for111
when yo~t rinse it with watel.
Clean the blade
by wiping vigorously with a cloth
soaked
in full strength windshield washer solvent. 'rhen
rinse the blade with water.
Wiper blades should be checked
011 a regular basis and
replaced when worn.
Weatherstrips
Silicone grease on weatherstrips will tnake the111 last
longer, seal better,
and not stick 01' squeak. Apply
silicone grease
with a clean cloth at Ica~t ever-y six
months. During very cold,
darnp weather 11w-e frequent
application
may be required. (See "Kttco~nnletlded
Fluids
and Lubricants" in the I~ldex.)

Maintenance Schedule
I Schedule I Definition I
Follow Maintenance Schedule I if any one of these is
true for your vehicle:
Most trips are less than 5 to 10 miles (8 to 16 km).
This is particularly important when outside
temperatures are below freezing.
0 Most trips include extensive idling (such as frequent
driving
in stop and go traffic).
0 Most trips are through dusty areas.
You frecp~ently tow a trailer or use a carrier on top of
your vehicle. (With some models, you should never
tow
a trailer. See “Towing a Trailer“ in the Index.)
Schedule
I should also be followed if the vehicle is used
for delivery service, police, taxi, or other commercial
application.
I Schedule I Intervals I
Every 3,000 Miles (5 000 km) or 3 Months,
Whichever Occurs First
Engine Oil and Filter Change
Every 6,000 Miles (10 000 km) or 6 Months,
Whichever Occurs First
Chassis Lubrication
At 6,000 Miles (10 000 km) - Then Every
12,000 Miles (25
000 km)
Every 15,000 Miles (25 000 km)
Tire Rotation
Air Cleaner Filter Inspection, if driving in dusty
conditions
Every 30,000 Miles (50 000 km)
Air Cleaner Filter Replacement
Spark Plug Replacement (except 2.3L Code
D engine)
Spark Plug Wire Inspection (except 2.3L
Fuel
Tmk, Cap and Lines Inspection
Engine Accessory Drive Belt Inspection (or every
Cooling System Service (or every 24 months,
Code
D engine)
24 months, whichever occurs first)
whichever occurs first)
Every 50,000 Miles (83 000 km)
Every 100,000 Miles (166 000 km)
Automatic Transaxle Service (severe conditions only)
Spark Plug Replacement (2.3L Code
D engine only)
7-4

Maintenance Schedule
Follow Schedule I1 only if none of the conditions from
Schedule
I is true.
Every 7,500 Miles (12 500 km)
Engine Oil and Filter Change (or every 12 months.
Chassis Lubrication (or every 12 months, whichever
whichever
occurs first)
occ~~rs
first)
At 7,500 Miles (12 500 km) - Then Every
15,000 Miles
(25 000 km)
Every 30,000 Miles
(50 000 knl)
Tire Rotation
Engine Accessory Drive Belt Inspection (or every
Cooling System Service (or every
24 months.
Spark Plug Replacement (except 2.3L
Code D engine)
Spark Plug Wire Inspection (except 2.3L Code
D engine)
Air Cleaner Filter Replacement
Fuel
Tank. Cap and Lines Inspection
Automatic Transaxle Service (severe conditions only)
Spark Plug Replacement
(2.3L Code D engine only)
24 months, whichever occurs first)
whichever occurs
first)
Every 50,000 Miles (83 000 km)
Every 100,000 Miles (166 000 km)
7-5

Maintenance Schedule I
30,000 Miles (50 000 km)
0 Change engine oil and filter (or every
3 months, whichever occurs first).
An Emission Control Service.
and transaxle shift linkage (or every
6 months, whichever occurs first).
0 Inspect engine accessory drive belt (or
every
24 months, whichever occurs first).
An Emission Control Service
0 Drain, flush and refill cooling system (or
every
24 months, whichever occurs first).
See “Engine Coolant” in the Index for what
to use. Inspect hoses. Clean radiator,
condenser, pressure cap and neck. Pressure
test the cooling system and pressure cap.
An Emission Control Sewice.
0 Replace spark plugs (except 2.3L Code D
engine). An Emission Control Sewice.
17 Lubricate the suspension, steering linkage
0 Inspect spark plug wires (except 2.3L Code
D engine). An Emission Control Sewice.
0 Replace air cleaner filter. Replace filter
more often under dusty conditions.
An Emission Control Service.
0 Inspect fuel tank, cap and lines for damage
or leaks. Inspect
fuel cap gasket for any
damage. Replace parts as needed.
An Emission Control Service.?
0 Rotate tires. See “Tire Inspection and
Rotation’’ in the Index for proper rotation
pattern and additional information.
DATE
SERVICED BY: ACTUAL MILEAGE
L- -
7-11

Maintenance Schedule I
60,000 Miles (100 000 km)
0 Change engine oil and filter (or every
3 months, whichever occurs first).
An Emission Control Service.
and transaxle shift linkage (or every
6 months, whichever occurs first).
0 Inspect engine accessory drive belt (or
every
24 months, whichever occurs first).
An Emission Control Service.
0 Drain, flush and refill cooling system (or
every
24 months, whichever occurs first).
See "Engine Coolant"
in the Index for what
to use. Inspect hoses. Clean radiator,
condenser, pressure cap and neck. Pressure
test the cooling system and pressure cap.
An Emission Control Service.
0 Lubricate the suspension, steering linkage
U Replace spark plugs (except 2.3L Code D
engine). An Emission Control Service.
0 Inspect spark plug wires (except 2.3L Code
D engine). An Emission Control Servic.e."f
0 Replace air cleaner filter. Replace filter
more often under dusty conditions.
An Emission Control Service.
0 Inspect fuel tank, cap and lines for damage
or leaks. Inspect fuel cap gasket for any
damage. Replace parts as needed.
An Emission Control Service.?

1 Maintenance Schedule I 1
87,000 Miles (145 000 km)
0 Change engine oil and filter (or every
3 months, whichever occurs first).
An Emission Control
Service.
DATE SERVICED BY ACTUAL MILEAGE
90,000 Miles (150 000 km)
0 Change engine oil and filter (or every
3 months, whichever occurs first).
An
Emission Control Service.
and transaxle shift linkage (or every
6 months, whichever occurs first).
0 Inspect engine accessory drive belt (or
every 24 months, whichever occurs first).
An
Emission Control Service.
0 Drain, flush and refill cooling system (or
every 24 months, whichever occurs first).
See “Engine Coolant” in the Index for what
to use. Inspect hoses. Clean radiator,
condenser, pressure cap and neck. Pressure
test the cooling system and pressure cap.
An Emission Control
Service.
0 Replace spark plugs (except 2.3L Code D
engine). An Emission Control Service.
0 Lubricate the suspension, steering linkage
(Continued)
7-22

30,000 Miles (50 000 km)
0 Change engine oil and filter (or every
12 months, whichever occurs first).
An Emission Control Service.
and transaxle shift linkage (or every
12 months, whichever occurs first).
0 Inspect engine accessory drive belt (or
every
24 months, whichever occurs first).
An Emission Control Service.
0 Drain, flush and refill cooling system (or
every
24 months, whichever occurs first).
See “Engine Coolant’’ in the Index for what
to use. Inspect hoses. Clean radiator,
condenser, pressure cap and neck. Pressure
test the cooling system and pressure cap.
An Emission Control Service.
0 Replace spark plugs (except 2.3L Code D
engine). An Emission Control Service.
0 Lubricate the suspension, steering linkage
0 Inspect spark plug wires (except 2.3L Code
D engine). An Emission Control Service.?
Replace air cleaner filter. An Emission
Control Service.
0 Inspect fuel tank, cap and lines for damage
or leaks. Inspect fuel cap gasket for any
damage. Replace parts as needed.
An Emission Control Sewice.?
DATE ACTUAL MILEAGE SERVICED BY
7-28

60,000 Miles (100 000 kt)
0 Change engine oil and filter (or every
12 months, whichever occurs first).
An Emission Control Service.
and transaxle shift linkage (or every
12 months, whichever occurs first).
0 Inspect engine accessory drive belt (or
every 24 months, whichever occurs first).
An Emission Control Service.
0 Drain, flush and refill cooling system (or
every 24 months, whichever occurs first).
See “Engine Coolant” in the Index for what
to use. Inspect hoses. Clean radiator,
condenser, pressure cap and neck. Pressure
test the cooling system and pressure cap.
An Emission Control Service.
0 Replace spark plugs (except 2.3L Code D
engine). An Emission Control Service.
0 Lubricate the suspension, steering linkage
0 Inspect spark plug wires (except 2.3L Code
D engine).
An Emission Control Service. 7
0 Replace air cleaner filter. An Emission
Control Service.
0 Inspect fuel tank, cap and lines for damage
or leaks. Inspect fuel cap gasket for any
damage. Replace parts as needed.
An Emission Control Service. 7

I Maintenance Schedule I1 I
82,500 Miles (137 500 km)
0 Change engine oil and filter (or every
12 months, whichever occurs first).
An Emission Control Service.
0 Lubricate the suspension, steering linkage
and transaxle shift linkage (or every
12 months, whichever occurs first).
0 Rotate tires. See “Tire Inspection and
Rotation”
in the Index for proper rotation
pattern and additional information.
~ ~~ ~~~ ~~
DATE SERVICED BY ACTUAL MILEAGE
90,000 Miles (150 000 km)
0 Change engine oil and filter (or every
12 months, whichever occurs first).
An Emission Control Service.
0 Lubricate the suspension, steering linkage
and transaxle shift linkage (or every
12 months, whichever occurs first).
Cl Inspect engine accessory drive belt (or
every
24 months, whichever occurs first).
An Emission Control Sewice.
U Drain, flush and refill cooling system (or
every
24 months, whichever occurs first).
See “Engine Coolant”
in the Index for what
to
use. Inspect hoses. Clean radiator,
condenser, pressure cap and neck. Pressure
test the cooling system and pressure cap.
An Emission Control Service.
(Continued)
7-33

Part C: Periodic Maintenance
Inspections
Listed below are inspections and services which should
be performed at least twice
a year (for instance, each
spring and fall). You should
let your GM retailer’s
service department or other qualified service center do
these jobs. Make sure any necessary repairs are
completed at once.
Restraint Systems
Now and then, make sure all your belts, buckles, latch
plates, retractors, anchorages and reminder systems are
working properly. Look for any
loose parts or damage.
If you see anything that might keep a restraint system
from doing its job, have it repaired.
Steering, Suspension and Front-Wheel-Drive
Axle Boot and Seal Inspection
Inspect the front and rear suspension and steering
system for damaged, loose or missing parts, signs of
wear, or lack of lubrication. Inspect the power steering
lines
and hoses for proper hookup, binding, leaks,
cracks, chafing, etc. Clean and then inspect the drive
axle boot seals for damage, tears or leakage. Replace
seals if necessary.
Exhaust System Inspection
Inspect the complete exhaust system. Inspect the body near
the exhaust system. Look for broken, damaged, missing or
out-of-position parts
as well as open seams, holes, loose
connections, or other conditions which could cause a heat
build-up in the floor pan or could
let exhaust fumes into
the vehicle. See “Engine Exhaust” in the Index.
Throttle Linkage Inspection
Inspect the throttle linkage for interference or binding, and
for damaged or missing parts. Replace parts as needed.
Accelerator and cruise control cables should not be
lubricated.
Manual Transaxle
Check the transaxle fluid level; add if needed. See
“Manual Transaxle”
in the Index. A fluid loss may
indicate
a problem. Check the system and repair if needed.
Brake System Inspection
Inspect the complete system. Inspect brake lines and hoses
for proper hookup, binding, leaks, cracks, chafing, etc.
Inspect disc brake pads for wear and rotors for surface
condition.
Also inspect drum brake linings for wear and
cracks. Inspect other brake parts, including drums, wheel
cylinders, calipers, parking brake, etc. The parking brake is self-adjusting and
no manual adjustment is required. You
may need to have your brakes inspected more often if your
driving habits or conditions result
in frequent braking.
7-40