battery location OLDSMOBILE AURORA 2003 Owners Manual

Remote Keyless Entry System
Your keyless entry system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada.
This device complies with Part
15 of the FCC Rules.
Operation
is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation of the device.
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
I. This device may not cause interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation of the device.
Changes or modifications to this system by other than
an authorized service facility could void authorization to
use
his equipmeni. At
times you may notice a decrease in range. This is
normal for any remote keyless entry system. If the
transmitter does not work or
if you have to stand closer
to your vehicle for the transmitter to work, try this:
Check the distance. You may be too far from your
vehicle. You may need to stand closer during
rainy or snowy weather.
Check the location. Other vehicles or objects may
be blocking the signal. Take a few steps to the
left or right, hold the transmitter higher, and
try again.
Check to determine
if battery replacement is
necessary. See “Battery Replacement” under
Remote Keyless Entry System Operation on
page
2-6.
If you are still having trouble, see your dealer or a
qualified technician for service.
2-5
ProCarManuals.com

Battery Replacement
Under normal use, the battery in your remote keyless
entry transmitter should last about four years.
You can tell the battery is weak if the transmitter won’t
work at the normal range in any location.
If you have
to get close to your vehicle before the transmitter works,
it’s probably time to change the battery.
Notice: When replacing the battery, use care not to
touch any
of the circuitry. Static from your body
transferred to these surfaces may damage the
transmitter. To
replace the battery, do the following:
1. Insert a coin, or similar object, into the notch near
the key ring. Turn it counterclockwise to separate
the two halves of the transmitter.
2. Once the transmitter is separated, use a pencil
eraser to remove the old battery.
Do not use a
metal object.
3. Replace the battery as the instructions under the
cover indicate. Use a Duracella battery,
type
DL-2032, or a similar type.
no moisture can enter.
4. Snap the transmitter back together tightly to be sure
5. Check the operation of the transmitter.
2-9
ProCarManuals.com

4. Open the hood on the other vehicle and locate the
positive
(+) and the negative (-) terminal locations
on that vehicle.
Open the hood on your vehicle and find the remote
positive
(+) terminal located in the engine
compartment on the passenger side
of the vehicle.
5. To access the remote
positive
(+) terminal,
remove the cover. You will not see the battery
of your vehicle under
the hood. It is located under the rear passenger
seat. You will not need to access the battery
for jump starting. The remote positive
(+) terminal
is for that purpose.
An electric fan can start up even when the
engine
is not running and can injure you. Keep
hands, clothing and tools away from any
underhood electric fan.
I
Your vehicle has a remote negative (-) terminal,
III~IKWJ UIAU, ~utiaiecj rear iile puwer sieering
fluid reservoir.
- ..I. - .I unr. ~n 11 I
See Engine Compartment Overview on page 5-14
for more information on location.
5-45
ProCarManuals.com

Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected from
short circuits by a combination of fuses and circuit
breakers. This greatly reduces the chance of fires
caused by electrical problems.
Look at the silver-colored band inside the fuse.
If the
band is broken or melted, replace the fuse. Be sure you
replace a bad fuse with a new one of the identical
size and rating. If a MaxiFuse@ should blow, see your
dealer for service immediately.
If you ever have a problem on the road and don’t have
a spare fuse, you can “borrow” one that has the
same amperage. Pick some feature of your vehicle that
you can get along without
- like the radio or cigarette
lighter
- and use its fuse, if it is the correct amperage.
Replace it as soon as you can. You will find a fuse puller
clipped in both
of the fuse blocks. Snap the wide end
of the fuse puller at the side indentations and pull
the fuse out.
The MaxiFuses@ are located in two fuse blocks, one
located in the engine compartment and the other under
the rear seat. If a MaxiFuse@ should blow, have your
vehicle serviced by your dealer immediately.
Engine Compartment Fuse Block
The engine compartment
fuse block is located near
the front on the
Comparfment Oiewiew on
page 5-14 for more
information on location.
Lift the cover to gain access. Fuse
22 or 23 can be
moved
to the outer position to provide continuous power
to the accessory power outlet or cigarette lighter
when the ignition is not on. See your dealer for
additional assistance,
if needed.
Leaving an accessory on for a long period of time can
drain the vehicle’s battery.
5-92
ProCarManuals.com