tow Oldsmobile Cutlass Supreme 1996 s Service Manual
[x] Cancel search | Manufacturer: OLDSMOBILE, Model Year: 1996, Model line: Cutlass Supreme, Model: Oldsmobile Cutlass Supreme 1996Pages: 356, PDF Size: 18.48 MB
Page 264 of 356

~ - ~~~~~ ~~ ~~~
~ ~
~ ~~~~~ ~~ ~ -
Tire Inspection and Rotation
Tires should be inspected every 6,000 to 8,000 miles
(10
000 to 13 000 km) .for any signs of unusual wear.
If unusual wear is present, rotate your tires as soon as
possible and check wheel alignment. Also check for
damaged tires or wheels. See “When It’s Time for New
Tires” and “Wheel Replacement” later in this section for
more information.
- ~ ~~ ~~ ~~ ~ ~~ ~ ~~~~~ ~~~ ~
When rotating your tires, always use the correct rotation
pattern shown here.
Don’t include the compact spare tire in your tire rotation.
After the tires have been rotated, adjust the front and
rear inflation pressures as shown on the Tire-Loading Information label. Make certain that all wheel nuts are
properly tightened.
See “Wheel Nut Torque” in
the Index.
The purpose of regular rotation is to achieve more
uniform wear for all tires on the vehicle. The first
rotation
is the most important. See “Scheduled
Maintenance Services” in the Index for scheduled
rotation intervals.
A CAUTI, :
Rust or dirt on a wheel, or on the parts to which
it is fastened, can make wheel nuts become loose
after
a time. The wheel could come off and cause
an accident. When you change
a wheel, remove
any rust or dirt from places where the wheel
attaches to the vehicle. In an emergency, you can
use
a cloth or a paper towel to do this; but be
sure to use a scraper or wire brush later, if you
need to, to get all the rust or dirt
off. (See
“Changing a Flat Tire” in the Index.)
6-44
Page 271 of 356

Using Foam-Type Cleaner on Fabric
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11. Vacuum
and brush the area to remove any
loose dirt.
Always clean a whole trim panel or section. Mask
surrounding trim along stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner following
the directionson the container label.
Use suds only and apply with a clean sponge.
Don’t saturate the material.
Don’t rub it roughly.
As soon as you’ve cleaned the section, use a sponge
to remove the suds.
Rinse the section with a clean, wet sponge.
Wipe
off what’s left with a slightly damp paper
towel or cloth.
Then dry it immediately with a blow dryer.
Wipe with a clean cloth.
I
Using Solvent-Qpe Cleaner on Fabric
First, see if you have to use solvent-type cleaner at all.
Some spots and stains will clean
off better with just
water‘ and mild soap.
lr you need to use a solvent:
0
0
Gently scrape excess soil from the trim material with
a clean, dull knife or scraper. Use very little cleaner,
light pressure and clean cloths (preferably
cheesecloth). Cleaning should start at the outside of
the stain, “feathering” toward the center. Keep
changing to a clean section
of the cloth.
When you clean a stain
from fabric, immediately dry the
area with a blow dryer to help prevent a cleaning ring.
6-51
Page 275 of 356

Cleaning the Outside of Your
Oldsmobile
The paint finish on your vehicle provides beauty, depth
of color, gloss retention and durability.
Washing Your Vehicle
The best way to preserve your vehicle’s finish is to keep \
it
clean by washing it
often with lukewarm or cold water.
Don’t wash your vehicle in the direct rays of the sun.
Don’t use strong soaps or chemical detergents. Use
. liquid hand, dish or car washing (mild detergent) soaps.
Don’t use cleaning agents that
are petroleum based, or
that contain acid or abrasives. All cleaning agents
should be flushed promptly and not allowed to dry on
the surface, or they could stain.
Dry the finish with a
soft, dean chamois or a 100% cotton towel to avoid
surface scratches and water spotting.
High pressure car washes may cause water to enter
your vehicle.
Finish Care
Occasional waxing or mild polishing of your
Oldsmobile by hand may- be necessary to remove
residue from the paint finish.
You can get GM-approved cleaning products
from your retailer. (See “Appearance
Care and Materials” in the Index.)
Your Oldsmobile has a “basecoatklearcoat” paint finish. The\
clearcoat gives more depth and gloss to the colored basecoat.
Always use waxes and polishes that are non-abrasive and
made for
a basecoatklearcoat paint finish.
NOTICE:
Machine compounding or aggressive polishing on a basecoat/clearcoat paint finish may dull the
finish
or leave swirl marks.
Foreign materials such as calcium chloride and other salts,
ice melting agents, road oil and tar, tree sap, bird
droppings, chemicals from industrial chimneys, etc., can
damage your vehicle’s finish
if they remain on painted
surfaces. Wash the vehicle as soon as possible. If
necessary, use non-abrasive cleaners that
are marked
safe for painted surfaces to remove foreign matter.
Exterior painted surfaces
are subject to aging, weather
and chemical fallout that can take their toll over a period
of years. You can help to keep the paint finish looking
new
by keeping your Oldsmobile garaged or covered
whenever possible.
Page 276 of 356

Aluminum Wheels (If So Equipped)
Keep your wheels clean using a soft clean cloth with
mild soap and water. Rinse with clean water. After
rinsing thoroughly,
dry with a soft clean towel. A wax
may then be applied.
The surface of these wheels is similar to the painted
surface of your vehicle. Don’t use strong soaps, chemicals,
abrasive polishes, abrasive cleaners or abrasive cleaning
brushes on them because you could damage the surface.
Don’t take your vehicle through an automatic car wash
that has silicon carbide tire cleaning brushes. These
brushes can also damage the surface
of these wheels.
Tires
To clean your tires, use a stiff brush with a tire cleaner.
NOTICE:
When applying a tire dressing always take care to
wipe
off any overspray or splash from all painted
surfaces on the body or wheels
of the vehicle.
Petroleum-based products may damage the
paint finish.
Sheet Metal Damage
If your vehicle is damaged and requires sheet metal
repair or replacement, make sure the body repair shop
applies anti-corrosion material to the parts repaired or
replaced to restore corrosion protection.
6-56
Page 294 of 356

.Maintenance Schedule
I Short Trip/City Definition I
Follow the Short TripKity Maintenance Schedule if any
one of these conditions is true for your vehicle:
Most trips are less than 5 to 10 miles (8 to 16 km).
This is particularly important when outside
temperatures are below freezing.
driving in stop-and-go traffic).
Most trips include extensive idling (such as frequent
0 Most trips are through dusty areas.
0 You frequently tow a trailer or use a carrier on top of
your vehicle.
If the vehicle is used for delivery .service, police, taxi
or other commercial application.
One of the reasons you should follow this schedule ifyou
operate your vehicle under any
of these conditions is that
these conditions cause engine oil to break down soonez
Short TriplCity Intervals
Every 3,000 Miles (5 000 km): Engine Oil and Filter
Change (or
3 months, whichever occurs first).
Every 6,000 Miles (10 000 km): Chassis Lubrication
(or
6 months, whichever occurs first).
At 6,000 Miles (10 000 km) -- Then Every
12,000 Miles
(20 000 km): Tire Rotation.
Every 15,000 Miles (25 000 km): Air Cleaner Filter
Inspection, if 'driving in dusty conditions.
Every 30,000 Miles (50 000 km): Air Cleaner Filter
Replacement. Fuel Tank, Cap and Lines Inspection.
Every '50,000 Miles (83 000 km): Automatic Transaxle
Service (severe conditions only).
Every 60,000 Miles (100 000 km): Engine Accessory
Drive Belt Inspection.
At 60,000 Miles (100 000 km) -- Then Every
15,000 Miles
(25 000 km): Camshaft Timing Belt
Inspection (3.4L Code
X engine only);
Every 100,000 Miles (166 000 km): Cooling System
Service (or every
60 months, whichever occurs first).
Spark.Plug Wire Inspection. Spark Plug Replacement.
These intervals only summarize maintenance services.
Be sure to follow the complete rnainten.ance schedule on
the following pages.
7-4
Page 305 of 356

Short TriplCity Maintenance Schedule -
50,000 Miles (83 000 km) I,
0 Change automatic transaxle fluid and filter
if the vehicle is mainly driven under one or
I more of these conditions:
. - In heavy city traffic where.the outside
temperature regularly reaches
90 OF
.(32"C) or higher.
- Inhilly or mountainous terrain.
I - When doing frequent trailer towing.
- Uses such as found in taxi, police or
. If you do not use your vehicle under any of these
'delivery service.
conditions, the fluid and filter do not require changing.
I 51,000 Miles (85 000 I km)
0 Chage engine oil 'md filter (or every
. . 3 months, whichever occurs first).
An Emission Control Service.
,
DATE .ACTUAL MILEAGE SERVICED BY:
7-15 f'
DATE ' ACTUAL MILEAGE SERVICED BY:
I
I I I
Page 315 of 356

I Short Trip/City Maintenance Schedule I
100,000 Miles (166 000 km)
0 Drain, flush and refill cooling system
(or every
60 months since last service,
whichever occurs first). See “Engine
Coolant’’ in the Index for what to use.
Inspect hoses. Clean radiator, condenser,
pressure cap ,and neck. Pressure test cooling
system and pressure cap.
An Emission Control,.Service,
0 Inspect spark plug wires.
0 Replace spark plugs.
An Emission Control Service.
.An Emission Control Service.
0 Change automatic transaxle fluid and filter
if the vehicle is mainly driven under one or
more of these conditions:
- In heavy city traffic where the outside
temperature regularly reaches
90 OF
(32 O C) or higher.
- In hilly or mountainous terrain.
- When doing frequent trailer towing.
- Uses such as found in taxi, pdlice or
If you do not use your vehicle under any of these
conditions, the fluid andfilter do not require changing.
delivery service.
DATE
SERVICED BY: ACTUAL MILEAGE
7-25
Page 319 of 356

Long TriplHighway Maintenance Schedule I I
CI Change engine oil and. filter (or every
12 months, whichever occurs first);
0 Lubricate steering ball j:oints (or every
6 -months, whichever oecurs first).
An Emission Control Service.
DATE ACTUAL MILEAGF SERVICED BY:
I I I I ..
,"
50,000 Miles (83 000 km)
?- - '
0 Change automatic transaxle fluid ,and filter ' :.:.I ,. ,
if the vehicle is mainly driven under one or ,
more of these conditions:
- In heavy city traffic where the outside
' - temperature regulariy .reaches 90°F
(32* C) or higher.
- ~n hilly or mountainous terrain.
- When doing frequent trailer towing.
- Uses such as found in taxi, police or
If yo; do not use your vehicle ,under any of these I
conditions, the9uid andfilter do not require changing.
delivery service. . .
.::
.
' DATE ACTUAL MILEAGE , SERVICED BY:
..
Page 325 of 356

Long Tripmighway Maintenance Schedule 1
0 Change automatic transaxle fluid and filter
if the vehicle is mainly driven under one or
more
of these conditions:
- In heavy city traffic where the outside
temperature regularly reaches
90 OF
(32°C) or higher.
- In hilly or mountainous terrain.
- When doing frequent trailer towing.
- Uses such as found in .taxi,.police or
delivery service.
If you do not use your vehicle under any of these
conditions, the fluid andfilter do not require changing.
I DATE I ACTUALMILEAGE ISERVICED BXI
7-35
Page 337 of 356

For prompt assistance, please have the following
information available to give the Customer
Assistance Representative:
0
0
0
0
0
Your name, address, home and business
telephone numbers
Vehicle Identification Number (This is available
from the vehicle registration or title, or the plate at
the top
left of the instrument panel and visible
through the windshield.)
Retail facility name and location
Vehicle delivery date and present mileage
Nature of concern
We encourage you to call us
so we can give your inquiry
prompt attention. However, if you wish to write
Oldsmobile, write to:
Customer Assistance Representative
Oldsmobile Central Office
920 Townsend Street
P.O. Box 30095
Lansing, MI 48909 Refer
to your Warranty and Owner Assistance
Information booklet for addresses of Canadian and
GM Overseas offices.
When contacting Oldsmobile, please remember that
your concern will likely be resolved in the retail facility,
using the retailer’s facilities, equipment and personnel.
That is why we suggest you follow Step One first if you
have a concern.
Customer Assistance for Text
Telephone
(TTY) Users
To assist customers who are deaf, hard of hearing, or
speech-impaired and who use Text Telephones (TTYs),
Oldsmobile has TTY equipment available at its
Customer Assistance Center. Any TTY user
can communicate with Oldsmobile by dialing:
1-800-833-OLDS. (TTY users in Canada can dial
1-800-263-3830.)
8-3
-