wheel OLDSMOBILE INTRIGUE 1998 User Guide

To stop the window while it is lowering, press the
switch.
To raise the window, press and hold the switch.
Tilt Steering Wheel
The driver’s window
controls also include
a
lock-out switch. Press
LOCK to stop front and
rear passengers from using
their window switches.
The driver can still control all windows with the lock on.
Press the other side of the
LOCK switch for normal
window operation. A tilt steering wheel allows you to adjust the steering
wheel before you drive.
You can also raise it to the
highest level to give your legs more room when
you exit
and enter the vehicle.
To tilt the wheel, hold the steering wheel and pull the
lever. Move the steering wheel to
a comfortable level,
then release the lever to lock
the wheel in place.
2-30
ProCarManuals.com

Windshield Wipers
You can control the windshield wipers by turning the
band with the wiper symbol on it. This lever is located
on the right-hand side of the steering wheel. For
a single wiping cycle, turn the band to MIST. Hold
it there until the wipers start, then let go. the wipers will
stop after one cycle. If you want more cycles, hold the
band on MIST longer.
You can set the wiper speed for a long delay or short
delay between wipes. This can be very useful in light
rain or snow. Push the lever up to INT (intermittent),
then turn the band, located on the lever,
to adjust the
delay time. Rotate the band down for a longer delay,
up
for a shorter delay. The wiper speed can only be
adjusted when the lever is in INT position, not in HI
or
LO.
Be sure to clear the ice and snow from the wiper blades
before using them.
If they’re frozen to the windshield,
carefully loosen or thaw them.
If your blades do become
damaged, get new blades or blade inserts.
Heavy snow or ice can overload your wipers.
A circuit
breaker will
stop them until the motor cools. Clear away
snow or ice to prevent an overload.
2-33
ProCarManuals.com

Windshield Washer At the end of the right-hand lever on the steering wheel,
there
is a wiper symbol. To spray washer fluid on the
windshield, push the button
on the end of the lever. The
wipers will run
for several sweeps and then either stop
or return to your preset speed.
I-
CAUTION:
In freezing weather, don’t use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking
your vision.
2-34
ProCarManuals.com

Cruise Control
With cruise control, you can maintain a speed of about
25 mph (40 km/h) or more without keeping your foot on
the accelerator. This can really help on long trips. Cruise
control does not work at speeds below about
25 mph
(40 km/h).
When you apply your brakes, the cruise control
shuts
off.
A CAU‘ [ON:
I
Setting Cruise Control
Cruise control can be dangerous where you
can’t drive safely
at a steady speed. So,
don’t use your cruise control on winding
roads or in heavy traffic.
slippery roads. On such roads, fast changes
in tire traction can cause needless wheel
spinning, and you could lose control. Don’t
use cruise control on slippery roads.
Cruise control can be dangerous on
If you leave your cruise control switch on when
you’re not using cruise, you might hit
a button
and go into cruise when you don’t want to. You
could be startled and even lose control. Keep the
cruise control switch off until you want to use it.
I I
1. Push the cruise control
button on the instrument
panel to turn it on.
2. Get up to the speed you want.
2-35
ProCarManuals.com

3. Push the COAST/SET
button on your steering wheel and release it. Once
you’re going about
25 rnph (40 km/h)or more,
press the RES/ACCEL
button on your steering
wheel. You’ll go right back
up to your chosen speed and
stay there.
4. Take your foot off the accelerator.
The CRUISE light on the instrument panel cluster will
come on after the cruise control has been set to the
desired speed.
It will go off when you:
step lightly on the brake pedal,
0 press CLEAR on the steering wheel or
0 press the CRUISE button on the instrument panel.
Resuming a Set Speed
Suppose you set your cruise control at a desired speed
and then you apply the brake. This, of course shuts off
the cruise control. But you don’t need to reset
it.
Increasing Speed While Using Cruise Control
There are two ways to go to a higher speed:
0
0
Use the accelerator pedal to get to the higher speed.
Press the COAST/SET button on the steering wheel,
then release the button and the accelerator pedal.
You’ll now cruise at the higher speed.
Press the RES/ACCEL button on the steering wheel.
Hold it there until you get up to the speed you want
and then release the switch. (To increase your speed
in very small amounts, press the RES/ACCEL
button for less than half a second and then release it.
Each time you do this, your vehicle will
go 1 mph
(1.6 km/h) faster.)
2-36
ProCarManuals.com

The accelerate feature will only work after you set the
cruise control speed by pressing the COAST/SET button
on the steering wheel.
Reducing Speed While Using Cruise Control
There are two ways to reduce your speed while using
cruise control:
Press the COAST/SET button on the steering wheel
until
you reach the lower speed you want, then
release it.
To slow down in very small amounts, press the
COASTBET button on the steering wheel for less
than a half second. Each time you do this, you’ll go
1 mph (1.6 km/h) slower.
Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot
off the pedal, your vehicle will slow
down to the cruise speed you set earlier.
Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load and the steepness of the hills.
When going up steep hills, you may have to step on the
accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear
to keep your speed down. Of course, applying the brake
takes you out
of cruise control. Many drivers find this to
be too much trouble and don’t use cruise control on
steep hills.
Ending Cruise Control
There are three ways to cancel the cruise control:
0 Step lightly on the brake pedal,
0 Press CLEAR on the steering wheel or
Press the CRUISE button on the instrument panel.
Erasing Cruise Speed Memory
When you turn off the cruise control or the ignition,
your cruise control set speed memory is erased.
ProCarManuals.com

Exterior Lamps
The lamp controls are located on the multifunction
lever on the left
of the steering wheel. They control
these systems:
Headlamps
Taillamps
Parking Lamps
License Lamps
0 Sidemarker Lamps
0 Instrument Panel Lights
Turn the end of the lever to this symbol to turn on
the headlamps and other operating lamps.
zoo=
- Turn the end of the lever to this symbol to turn
on the parking and other operating lamps without the
headlamps.
Turn the end of the lever to
OFF to turn off the lamps.
A warning chime will sound if you open the driver’s
door when you turn the ignition switch to
OFF or ACC
with the lamps on.
2-38
ProCarManuals.com

Enhanced Traction System Warning Light
(If Equipped)
TRAC
OFF
If the warning light stays
on, or comes on when
you’re driving, there may
be a problem with your
Enhanced Traction System
and your vehicle may
need service. The
Enhanced Traction System warning light may come
on for the following reasons:
e
0
When this warning light is on, the system will not limit
wheel spin. Adjust your driving accordingly.
0
If you turn the system off by pressing the button on
the console, the warning light will come on and stay
on.
To turn the system back on, press the button
again. The warning light should
go off. (See
“Enhanced Traction System” in the Index
for
more information.)
The warning light will come on when you set your
parking brake with the engine running, and it will
stay on if
your parking brake doesn’t release fully. If
the system is turned on and the warning light stays
on after your parking brake is
fully released, it
means there’s a problem with the system.
If the traction control system is affected by an
engine-related problem, the system will turn
off and
the warning light will come on.
If the Enhanced Traction System warning light comes
on and stays on for an extended period
of time when the
system is turned on and the parking brake is fully
released, your vehicle needs service.
2-58
ProCarManuals.com

Low Traction Light
LOW
TRAC
When your anti-lock system
is adjusting brake pressure
to help avoid a braking skid,
this light will come on.
If you have
the Enhanced Traction System, this light will
also come on when the system is limiting wheel spin. You
may feel or hear the system working, but this is normal.
Slippery road conditions may exist if the low traction light
comes on,
so adjust your driving accordingly. The light
will stay
on for a few seconds after the anti-lock system
stops adjusting brake pressure or the Enhanced Traction
System stops limiting wheel spin.
If the light doesn’t come on then, have it fixed so it will
be there to tell you when the anti-lock brake system or
Traction Control System is active.
Slippery road conditions may exist
if the low traction
light comes on,
so adjust your driving accordingly.
Engine Coolant Temperature Gage
\C
You have a gage that shows
the engine coolant
temperature. If
the gage
moves into the red area,
your engine
is too hot.
The low traction light also comes on briefly when you
turn the ignition key to ON. If the light doesn’t come on
then, have
it fixed so it will be there to tell you when the
anti-lock brake system or Enhanced Traction System
is active.
For the optional Traction Control System, the low
traction light comes on briefly when you turn the
ignition to ON. That
reading means the same thing
as the warning light.
It means that your engine coolant has overheated. If you
have been operating your vehicle under normal driving
conditions, you should pull
off the road, stop your
vehicle and
turn off the engine as soon as possible.
In “Problems on the Road,” this manual shows what to
do. See “Engine Overheating” in the Index.
ProCarManuals.com

Section 3 Comfort Controls
In this section, you’ll find out how to operate the comfort control and audio systems offered with your vehicle. Be
sure to read about the particular systems supplied with your vehicle.
3-2
3-2
3-4
3
-4
3 -4
3-9
3
-9
3- 10
3- 14
Comfort Controls Air Conditioning with Electronic Controls
Heating
Ventilation
Defogging and Defrosting
Rear Window Defogger Setting
the Clock
AM-FM Stereo with Cassette Tape Player
and Automatic Tone Control
AM-FM Stereo with Cassette Tape and
Compact Disc Player with Automatic Tone
Control (If Equipped) 3-20
3 -23
3-25
3-25
3-26
3 -27
3-28
3-28
3-28
Trunk Mounted CD Changer (If Equipped)
Theft-Detement Feature
Audio Steering Wheel Controls (If Equipped)
Understanding Radio Reception
Tips About Your Audio System
Care of Your Cassette Tape Player
Care of Your Compact Discs
Care of Your Compact Disc Player
Backglass Antenna
(If Equipped)
ProCarManuals.com