key Peugeot 206 CC 2003 User Guide

30-06-2003
YOUR 206 CC IN DETAIL73
Make a careful note of the number on each key. The key number is
coded on the label attached to the key. If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.
The high frequency remote control is a sensitive system; do not operate itwhile it is in your pocket as there is a possibility that it may unlock your vehicle,without you being aware of it. The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except for reprogramming. Driving with the doors locked may make access to the passenger compart-
ment by the emergency services more difficult in an emergency. As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time. Do not repeatedly press the button of your remote control out of range of your vehicle.
You run the risk of stopping it from working and the remote control would have to be reprogrammed. When purchasing a second-hand vehicle:
- ensure that you are given the confidential card;
- have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOT
dealer on the system. This code ishidden by a film, which should be
removed only if necessary. Keep your card in a safe place, never inside the vehicle.ELECTRONIC ENGINE IMMOBILISER This locks the engine management system as soon as the ignition has
been switched off and therefore pre-vents starting of the vehicle by any-
one who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode is recognised and starting ispossible. If the system does not function correctly , contact a PEUGEOT
dealer as soon as possible.

30-06-2003
YOUR 206 CC IN DETAIL73
Make a careful note of the number on each key. The key number is
coded on the label attached to the key. If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.
The high frequency remote control is a sensitive system; do not operate itwhile it is in your pocket as there is a possibility that it may unlock your vehicle,without you being aware of it. The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except for reprogramming. Driving with the doors locked may make access to the passenger compart-
ment by the emergency services more difficult in an emergency. As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time. Do not repeatedly press the button of your remote control out of range of your vehicle.
You run the risk of stopping it from working and the remote control would have to be reprogrammed. When purchasing a second-hand vehicle:
- ensure that you are given the confidential card;
- have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOT
dealer on the system. This code ishidden by a film, which should be
removed only if necessary. Keep your card in a safe place, never inside the vehicle.ELECTRONIC ENGINE IMMOBILISER This locks the engine management system as soon as the ignition has
been switched off and therefore pre-vents starting of the vehicle by any-
one who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode is recognised and starting ispossible. If the system does not function correctly , contact a PEUGEOT
dealer as soon as possible.

30-06-2003
Deadlocking Deadlocking of the doors is an additional security device. It disables the exterior and interior door controls. There are two methods of deadlocking :
- with the ignition key, from the driver's door;
- with the remote control, which has two buttons :A. deadlocking/locking of the doors and boot lid.
B. unlocking.
Using the ignition key Deadlocking , turn the key towards the rear of the vehicle.
Locking , within 5 seconds of deadlocking, turn the key again towards the rear
of the vehicle.Unlocking , turn the key towards the front of the vehicle. Using the remote controlDeadlocking
, press button Aonce
to deadlock the vehicle.This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds.
Press button A again within
5 seconds of deadlocking; this changes deadlocking to normal loc-
king. This is confirmed by fixed ligh-ting of the direction indicators forapproximately two seconds. Unlocking Press button Bto unlock the vehicle.
This is confirmed by the rapid fla- shing of the direction indicators.
To unlock the boot lid Place the ignition key in the boot lock and turn it anti-clockwise.
SPECIAL FEATURES
128

30-06-2003
Important After deadlocking the vehicle, the doors can only be unlocked fromthe outside of the vehicle; if anyo-ne is inside the vehicle, it is impos-sible to unlock the vehicle from theinside. If the battery is disconnected:- the deadlocking remains activa- ted
- it is possible to open one of the front doors using the ignition
key, but the key only opens the
corresponding door.
CENTRAL LOCKING Pressing button Aallows you to lock
or unlock the doors from the inside. Note: on vehicles fitted with this
control, the door handles only ope- rate the door concerned.
SPECIAL FEATURES 129
Warning: it is dangerous to activate the deadlocking ifanyone is inside the vehicle Make a careful note of the
number of the key.
If the key is lost or stolen you will
then be able to obtain a new key. Check that the batteries are not flat.

30-06-2003
The alarm Setting and deactivating the alarm system Switching off the siren. The alarm completes the security
equipment for your vehicle. It offerstwo types of protection. -external protection: when it is
set, the alarm sounds if one of
the doors, the boot lid or the bonnet is opened ;
- internal protection: when it is
set, the alarm sounds if the sen-
sors detect air movement in thepassenger compartment (a bro-ken window) or movementwithin the car .
Note: the internal protection does
not operate when the vehicle roof isopen or is not closed properly (e.g.catches unlocked). The alarm also has an anti-tamper function. If there is an attempt to tamper with the wires to the siren, control unit or
the battery,the siren sounds and thedirection indicators light. Setting the alarm (external andinternal protection)
Switch the ignition off and get out of the vehicle. Deadlock the vehicle.The doors lock.The direction indicators light for two seconds. The red light on the switch flashes once a second.
5 seconds later, internal protection is set.
45 seconds later, external protection is set. Note:
when the alarm is triggered,
the siren sounds for thirty seconds. After the thirty seconds it stops, butthe alarm remains set.
Warning: When the alarm is trigge-
red, if a door, the boot lid, roof or
bonnet are not closed correctly, thesiren sounds for a moment. If thevehicle is closed correctly in the fol-lowing 45 seconds, the alarm is acti-vated and the direction indicatorsremain on for two seconds. In allcases, the alarm is activated after 45seconds. Disarming the alarm (internal and external protection) Press the release button of the
remote control key. The doors unlock.The direction indicators flash for two seconds. The red light on the switch goes out. Note:
if the warning light continues
to flash after de-activation of the alarm, it is a sign that the alarm has
been triggered. The flashing willstop when the ignition is switchedon.
SPECIAL FEATURES
130

30-06-2003
Emergency cut-off (If the remote control is not working)
Unlock the doors with the key.
Open the door.The alarm is triggered.
- Turn on the ignition.
- The locking system recognisesthe key.
- The siren stops and the alarm is disarmed. Selection of the type of protection
To set the alarm to external
protection only. If you want to leave a window par- tially open, or a pet inside thevehicle, you need to select externalprotection only:
- Switch off the ignition.
- Within the next ten seconds,
press the internal protection but- ton 1 until the warning light comes
on continuously. Get out of thevehicle.
- Deadlock the vehicle.
- The doors lock.
- The direction indicators light for two seconds.
- The red light on the switch flashes once a second.
To de-activate external protection only Press the release button on the remote control. The doors unlock.The direction indicators flash for two seconds. The red light on the switch goes out. To lock the vehicle without setting the alarm It is the remote control which sets the alarm. Therefore, to lock the vehicle without setting the alarm: use the
key.
To recharge or replace the battery:
- Turn on the ignition.
- You have 10 seconds after turning
on the ignition to press the inter- nal protection switch 1and hold it
down for two seconds.
- The warning light flashes rapidly for three seconds.
- You can now disconnect the battery.
After reconnecting the battery:
- Deadlock, then unlock the vehicle using the remote control.
The alarm will be set after the next deadlocking operation.
SPECIAL FEATURES 131
In no circumstances must you carry out modificationsto the alarm.

30-06-2003
YOUR 206 CC IN DETAIL
74
Opening the doors from outside
DOORS
Opening the doors from inside
LOCKING AND UNLOCKING THE BOOT Lock the boot using the key (turn
the key from Ato C) or the remote
control. Unlock it using the key (turn the key
from Ato B).
The lighting is controlled by opening the boot.
Locking from the inside
To lock, press button A.
Locking one of the front doors locks the doors and the boot. Unlocking from the inside
To unlock, pull button Aor the han-
dle. ''Door open'' alert
With the engine running an audi-
ble signal and a message or dia- gram locating the problem on themultifunction screen, warns you thata door is not properly closed. Also, when the vehicle is moving ,
with the courtesy light button in the "lighting on opening a door" position,the courtesy light flashes.

30-06-2003
YOUR 206 CC IN DETAIL75
BONNET STRUT Secure the strut to hold the bonnet open. Before closing the bonnet, replace the strut in its housing.
To close Lower the bonnet and release it at the end of its travel. Check that thebonnet is locked.
OPENING THE BONNET Inside the vehicle:
pull the handle
on the left-hand side, under the fascia. Outside the vehicle: lift the catch
and raise the bonnet. FILLING THE FUEL TANK The tank must be filled with fuel with the engine switched off
.
Insert the key then turn it to the left. Remove the cap.
A label indicates which type of fuel to use. If you fill your tank, do not continue
after the third cut-off of the pump
nozzle. This could result in vehiclemalfunctions. The capacity of the tank is approximately 10.3 gallons (47 litres).

30-06-2003
YOUR 206 CC IN DETAIL77
Closing the roof Never switch the ignition off during operation of the roof. 
Ensure that the screen 1is hoo-
ked on (no object must be placed on the screen; if there is luggagein the boot, this must not push thescreen upwards).
 Close the boot correctly.
 With the vehicle stationary and
the handbrake applied, turn theignition key to position M.
 Press switch 3until your hear a
signal which confirms that theroof closing operation is complete.
When carrying out this operation,the front windows and then the rearquarter panel windows open, themoving parcel shelf folds up, theboot lid opens, the roof unfolds andpositions itself, then the boot lidcloses again.  Only then, lock the two hooks 2.
Note: The control buttons for the
windows become operational again at the end of the roof operation. Operating malfunction: If the cycle does not begin, check that the screen is pulled correctly
and that the boot is closed correctly. If movement of the roof stops, a con- tinuous audible signal sounds: 
Release switch 3, then press it
again to finish closing the roof.
If the problem persists, contact a
PEUGEOT dealer to have the sys-tem checked. When the vehicle is moving, if a con- tinuous audible signal can be heard,this means that the roof or the bootlid, or both, are not locked:  Stop the vehicle and apply the handbrake,
 Open the roof and close it again
completely, in accordance withthe procedure.
If the problem persists, contact a
PEUGEOT dealer to have the system checked.
The roof must not be oper- ated when a loaded lug-gage carrier is fitted to theboot lid.
During roof opening and closingoperations, to avoid any risk of
injury, ensure that there is no-onein the proximity of the movingparts. Never release button 3 for more than five minutes when the roofis in an intermediate position(neither completely open or
closed). However, in the event
of danger, release the controlknob and the operation will stop
instantly. You can resume thecycle before the audible signalceases.
In the case of an electric or hydraulic malfunction of the roof, itis possible to close the roof manu-
ally. When the side windows no longer
open completely, it is impossible tooperate the roof; however it is pos-sible to close it by using a specialprocedure. Please consult the breakdown procedure described at the endof this handbook.

30-06-2003
YOUR 206 CC IN DETAIL
78
THE LIGHTS STALK Front and rear lights Selection is by turning ring
A.
Lights off Side lights Dipped/main beam headlamps
Automatic switchingon of lights
Dipped/Main beam change Pull the stalk towards you. Note: with the ignition off, if the dri-
ver's door is open, a buzzer sounds if you have left your lights on. Front fog lamps and rear fog lamp Rotate the ring Bforwards to switch
on and backwards to switch off. The status is confirmed by the light onthe instrument panel.
Front fog lamps (1st for-wards turn of the ring)
The front fog lamps operate with theside lights and dipped headlamps. When the main beam headlamps are switched on, the front fog lamps are
switched off. They are switched onagain when the main beam head-
lamps are switched off. Front fog lamps and rearfog lamp (2nd forwardsturn of the ring)
Note: to switch off the rear fog lamp
and the front fog lamps, turn the ringtwice backwards.
In good or rainy weather, both day and night, thefront fog lamps and therear fog lamp are dazzling
and are prohibited. Do not forget to switch them off when they are no longer needed.
Note: when the lights are switched
off automatically or when the dipped
headlamps are switched off manual-
ly, the front fog lamps, the rear foglamp and the side lights will remainon (turn the ring backwards to swit-
ch off the front fog lamps. The side
lights will then be switched off). "Follow me home" lighting In poor light or at night, if you leave your vehicle, the side lights and dip-ped headlamps can be left on forapproximately one minute.
To do this:
- place the key in the STOPposition,
- place the lights stalk in the 0posi-
tion,
- flash the headlamps,- get out of the vehicle and lock it.