reset Peugeot 206 CC 2003 Owner's Manual

30-06-2003
PEUGEOT SERVICING21
Resetting the service indicator
Your PEUGEOT dealer carries out this operation after each service.
However, if you carry out the service yourself, the reset procedure is asfollows:
- Switch off the ignition. - Press and hold button 1.
- Switch on the ignition. The display begins a 10 second countdown.
- Keep button 1pressed for
10 seconds.
The display shows [=0]and the
service symbol disappears.

30-06-2003
INSTRUMENTS AND CONTROLS31
HAZARD WARNING LIGHTS
Press the button, the direction indi- cators flash. They can operate with the ignition
off. Automatic lighting of hazard warning lights*
When braking in an emergency, depending on the force of decelera-tion, the hazard warning lights come
on automatically. They switch offautomatically the first time youaccelerate.
It is also possible to switch them off by pressing the button.
* According to destination.
Total distance recorder Briefly pressing button
1alternates
between the total distance and trip distance displays.
To reset the trip recorder to zero, when it is displayed press and holdthe reset button for just over 3 sec-onds. Lighting rheostat With the lights on, press the button to vary the intensity of the lighting ofthe instruments and controls. Whenthe lighting reaches the minimum (ormaximum) setting, release the but-ton then press it again to increase(or reduce) the brightness. As soon as the lighting is of the required brightness, release the but-ton.

30-06-2003
YOUR 206 CC IN DETAIL
82
TRIP COMPUTER
Pressing the button on the end of the wash/wipe stalkenables the following data to
be displayed:
Display B
- the range
- the distance travelled
- the average consumption
- the current consumption
- the average speed Zero reset Press the stalk for more than two seconds. Display C
- the current consumption and the range,
- the average consumption, the distance travelled and the
average speed calculated over a period "1",
- the average consumption, the distance travelled and the average speed calculated over a period "2".
Periods "1"and "2"are defined by the frequency of the
zero reset. They allow, for instance, daily calculations over period "1"and monthly calculations over period "2".
Zero reset When the required period is displayed, press the stalk for more than two seconds.

30-06-2003
YOUR 206 CC IN DETAIL83
Range The display shows the distance that can still be covered with the fuelremaining in the tank. Note:
this figure may rise if there is
a change in driving style or road sur- face, causing a significant drop incurrent fuel consumption. If there are less than 3 litres of fuel in the tank, only three segments willbe displayed.
Current fuel consumption This gives the fuel consumption recorded during the last two
seconds. This function is only dis-played when the vehicle is travellingat more than 12 m.p.h. (20 km/h).
Average consumption This is the ratio between the amount of fuel consumed and the distancetravelled since the computer waslast reset to zero.
Average speed This is obtained by dividing the dis- tance travelled by the period of timethe vehicle has been in use (with theignition on), since the computer waslast reset to zero. Distance travelled This shows the distance travelled since the computer was last reset tozero. After the trip computer has been reset to zero, the range databecomes meaningful only after thevehicle has been in use for a certainperiod. If horizontal segments are displayed instead of figures when driving, con-
tact a PEUGEOT dealer.