warning light Peugeot 207 CC 2012 Owner's Manual

2
CONTENTS
Instrument panels 20
Indicator and warning lamps 21
Indicators 28
Adjustment buttons 32
Screens without audio
equipment 33
Screens with audio equipment 35
16/9 colour screen (Peugeot
Connect Navigation) 40
Trip computer 42■
■
■
■
■
■
■
■
Ventilation 45
Heating 47
Manual air conditioning 47
Rear screen demist - defrost 49
Digital air conditioning 50
Seats 52
Steering wheel adjustment 54
Mirrors 55
Interior fi ttings 57
Windstop 62■
■
■
■
■
■
■
■
■
■
COMFORT 45 Î 64
Remote control key 65
Alarm 69
Window controls 71
Doors 73
Boot 76
Fuel tank 77
Misfuel prevention (Diesel) 79■
■
■
■
■
■
■
ACCESS 65 Î 79
Lighting control stalk 80
Static directional lighting 83
Headlamp adjustment 83
Wiper control stalk 84
Courtesy lamp 85■
■
■
■
■
VISIBILITY 80 Î 85
Conventional child seats 86
ISOFIX child seats 90■
■
CHILD
SAFETY 86 Î 92 FAMILIARISATION 4 Î 17
INSTRUMENTS
and CONTROLS 20 Î 445
4
3
2
1
ECO-DRIVING 18 Î 19

4
FAMILIARISATION
EXTERIOR

Retractable roof

This system enables you to change the
vehicle from "coupé" to "cabriolet" con-
fi guration and vice versa with a single
action.



6



Static directional lighting

This additional lighting automatically
provides extended visibility when
turning.



83



Visual and audible rear parking
sensors
This system provides a warning when
reversing by detecting obstacles locat-
ed behind the vehicle.



114



Under-inflation detection

This system monitors the pressure in
each tyre and warns you of a punc-
ture or drop in pressure.



95



Turbulence prevention
net (Windstop)
In "cabriolet" confi guration, this
system reduces the wind turbu-
lence in the front seats.



61



Temporary tyre repair kit

This kit is a complete system, con-
sisting of a compressor and an inte-
gral sealant, for the temporary repair
of a tyre.



123

15
FAMILIARISATION
MONITORING

Instrument panel
Switch panel


A.
With the ignition on, the fuel gauge
needle should rise.

B.
With the engine running, the associ-
ated low level warning lamp should
switch off.

C.
With the ignition on, the oil level in-
dicator should display "OIL OK"
for
a few seconds.
If the levels are not correct, top up the
level which is low.



20
Lighting of the indicator lamp indicates
the status of the corresponding func-
tion.


A.
Deactivation of the ESP/ASR system.



97

B.
Central locking.



74

C.
Deactivation of the interior volumetric
protection alarm.



69



1.
With the ignition on, the orange and
red warning lamps come on.

2.
With the engine running, these
warning lamps should switch off.
If a warning lamp remains on, refer to
the page concerned.



21



Warning lamps

1
!
INSTRUMENTS and CONTROLS
21









Indicator and warning lamps

Visual indicators informing the driver that a system is in operation (operation or
deactivation indicator lamps) or of the occurrence of a fault (warning lamp).

When the ignition is switched on
Certain warning lamps come on for a few seconds when the vehicle's ignition is
switched on.
When the engine is started, these same warning lamps should go off.

If they remain on, before moving off, refer to the information on the warning lamp concerned.


Associated warnings
The illumination of certain warning lamps may be accompanied by an audible sig-
nal and a message in the multifunction screen. The warning lamps may come on
continuously (fi xed) or fl ash.
Certain warning lamps may come
on in two different modes. Only by
relating the type of illumination to
the operating status of the vehicle
can it be ascertained whether the
situation is normal or whether a
fault has occurred.

Operation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the correspond-
ing system has come into operation.



Warning lamp



is on



Cause



Action/Observations




Left-hand
direction
indicato

r


fl ashing with
buzzer. The lighting stalk is pushed
down.


Right-hand
direction
indicator


fl ashing with
buzzer. The lighting stalk is pushed
up.


Dipped beam
headlamps


fi xed. The lighting stalk is in the
"Dipped beam headlamps"
position.


Main beam
headlamps


fi xed. The lighting stalk is pulled
towards you. Pull the stalk to return to dipped beam
headlamps.

1
i
INSTRUMENTS and CONTROLS
31






Coolant temperature indicator

System which informs the driver of the
changes in the temperature of the en-
gine coolant while driving.
With the engine running, when the nee-
dle is:


- in zone A
, the temperature is correct,

- in zone B
, the temperature is too
high; the max temperature warning
lamp 1
and the central STOP
warn-
ing lamp come on, accompanied by
an audible signal and a message in
the multifunction screen.

You MUST stop as soon as it is safe
to do so.

Contact a PEUGEOT dealer or a quali-
fi ed workshop. After driving for a few minutes, the tem-
perature and pressure in the cooling
system increase.
To top up the level:


)
wait for the engine to cool,

)
unscrew the cap by two turns to al-
low the pressure to drop,

)
when the pressure has dropped, re-
move the cap,

)
top up the level to the "MAX" mark
(circular line). On petrol engines, the cooling of the
engine is managed electronically to
reduce fuel consumption. Conse-
quently, the coolant temperature
levels are no longer simply linked
with the external ambient conditions
and the use of the vehicle.
For example, in town, it is normal
for the coolant temperature to be
slightly higher in cold weather than
in hot weather (normal operation
may lead to a temperature of over
100 °).

1INSTRUMENTS and CONTROLS
37
MONOCHROME SCREEN C
Main menu

Displays on the screen

This displays the following information:


- time,

- date,

- ambient temperature * (this fl ashes if
there is a risk of ice),

- status of the openings (doors, boot...),

- audio sources (radio, CD...),

- trip computer (refer to the end of the
section).
Warning messages (e.g.: "Emission
control system faulty") or information
messages (e.g.: "Automatic headlamp
lighting activated") may appear tempo-
rarily. These can be cleared by pressing
the "ESC"
button.


"Audio functions" menu

With the Peugeot Connect Sound
switched on, once this menu has been
selected you can activate or deactivate
the functions linked with use of the ra-
dio (RDS, REG, RadioText) or the CD
(introscan, shuffl e, CD repeat).
For more information on the "Audio func-
tions" application, refer to the Peugeot
Connect Sound part of the "Audio and
Telematics" section.


Controls

From your Peugeot Connect Sound
control panel, you can:


)
press the "MENU"
button to gain
access to the main menu
,

)
press the " 
" or " 
" buttons to scroll
through the items on the screen,

)
press the "MODE"
button to change
the permanent application (trip com-
puter, audio source...),

)
press the " 
" or " 
" buttons to
change a setting value,

)
press the "OK"
button to confi rm,
or

)
press the "ESC"
button to abandon
the operation in progress.


)
Press the "MENU"
button to gain
access to the main menu
:


- audio functions,

- trip computer,

- personalisation-confi guration,

- telephone (hands-free kit).

)
Press the " 
" or " 
" buttons to se-
lect the menu required, then confi rm
by pressing the "OK"
button.


*
With air conditioning only.

3
i
ACCESS
66
The vehicle will relock automati-
cally after thirty seconds unless
a door is opened. This system
prevents unintentional unlocking.
The folding and unfolding of the
door mirrors can be deactivated by
a PEUGEOT dealer.

Folding the key


)
First press button A
to fold the key.







Locating your vehicle



)
Press the closed padlock to locate
your locked vehicle in a car park.
This is indicated by lighting of the cour-
tesy lamp and fl ashing of the direction
indicators for a few seconds.
Electronic engine immobiliser
The key contains an electronic chip
which has a special code. When the
ignition is switched on, this code must
be recognised in order for starting to be
possible.
This electronic engine immobiliser locks
the engine management system a few
minutes after the ignition is switched off
and prevents starting of the engine by
anyone who does not have the key.












Anti-theft protection

In the event of a fault, you are
informed by illumination of this
warning lamp, an audible signal
and a message in the screen.
In this case, your vehicle will not start;
contact a PEUGEOT dealer as soon as
possible.
Keep safely the label attached to the
keys given to you on acquisition of the
vehicle.


)
Press the boot unlocking but-
ton on the remote control for
more than 2 seconds. The
boot opens slightly.



Unlocking and partially opening
the boot

3
i
i
ACCESS
76
BOOT

Opening



)
After unlocking the boot or the vehi-
cle using the remote control or the
key, pull the handle and raise the
boot lid.


Unlocking and partially opening
the boot


)
Press the boot unlocking
button on the remote control
for more than two seconds.
The boot opens slightly.

If a battery failure occurs, the boot
is locked. Contact a PEUGEOT
dealer or a qualifi ed workshop.


Boot anti-theft protection

The boot is designed to remain secure,
even in the "cabriolet" confi guration.
So, when the vehicle is locked and the
roof is open, the boot cannot be un-
locked:


- by means of the interior door opening
control, when the key is not in the
ignition switch,

- by pressing the manual centralised
control A
, when the key is not in the
ignition switch.


- when the engine is running
,
this warning lamp comes on,
accompanied by a message
on the multifunction screen for
a few seconds,

- when the vehicle is moving
(speed
above 6 mph (10 km/h)), this warn-
ing lamp comes on, accompanied
by an audible signal and a message
on the multifunction screen for a few
seconds.



Closing



)
Lower the boot lid using the interior
grab handle.
If the boot lid is not closed correctly:
Automatic locking of the boot
In the "cabriolet" confi guration, with
the vehicle locked, if you unlock the
boot by pressing the boot unlock-
ing button on the remote control,
it will lock automatically when you
close it again.
In this case, if you inadvertently
leave the key in the boot, press the
manual centralised control A
im-
mediately to unlock the boot and
retrieve the key.

4
!
82
VISIBILITY
In fog or snow, the sunshine sensor
may detect suffi cient light. There-
fore, the lighting will not come on
automatically.
Do not cover the sunshine sensor,
coupled with the rain sensor and
located in the centre of the wind-
screen behind the rear view mirror;
the associated functions would no
longer be controlled.

Coupling with the "Guide-me-home"
lighting
Association with the automatic illumina-
tion of headlamps provides the "guide-
me-home" lighting with the following
additional options:


- selection of the lighting duration to
15, 30 or 60 seconds in the vehi-
cle parameters in the multifunction
screen confi guration menu,

- automatic activation of "guide-me-
home" lighting when automatic illumi-
nation of headlamps is in operation.











Automatic illumination of headlamps

The sidelamps and dipped beam head-
lamps are switched on automatically, with-
out any action on the part of the driver, when
a low level of external light is detected (sen-
sor behind the rear view mirror) or when the
windscreen wipers are switched on.
As soon as the brightness returns to a suf-
fi cient level or after the windscreen wipers
are switched off, the lighting is switched off
automatically.

"Guide-me-home" lighting

The dipped beam headlamps remain on
temporarily, after switching off the vehi-
cle's ignition, to make the driver's exit
easier in poor light.

Activation


)
With the ignition off, activate a
"headlamp fl ash" using stalk B
.

)
A second "headlamp fl ash" switches
the function off again.


Switching off
The "guide-me-home" lighting is
switched off automatically following the
door locking command, after a given
time.


Activation


)
Turn ring A
to the " AUTO
" position.
The automatic illumination of head-
lamps is accompanied by a mes-
sage in the multifunction screen.


Deactivation


)
Turn ring A
to a position other than
" AUTO
". Deactivation is accompa-
nied by a message in the multifunction
screen.

Operating fault
In the event of a malfunction of
the brightness sensor, the light-
ing comes on accompanied by
the service warning lamp, an
audible signal and a message on the
multifunction screen.
Have it checked by a PEUGEOT dealer
or a qualifi ed workshop.

4
i
VISIBILITY
STATIC DIRECTIONAL
LIGHTING
When the dipped or main beam head-
lamps are on, this function enables the
beam to light the inside of the turn with an
additional angle of approximately 30°.
The use of this lighting is optimum above
all at low and average speed (city driving,
winding roads, ...).

with directional lighting


without directional lighting



Programming

Switching on

The system is switched on from a cer-
tain speed and a certain angle of rota-
tion of the steering wheel.


Operating fault

The function is activated or
deactivated via the multi-
function screen confi gura-
tion menu.
This function is activated
by default.
In the event of a malfunction,
this warning lamp fl ashes on
the instrument panel, accom-
panied by a message on the
multifunction screen.
Have it checked by a PEUGEOT dealer
or a qualifi ed workshop.
HEADLAMP ADJUSTMENT

The initial setting is position "0"
. To avoid causing a nuisance to other
road users, the height of the headlamps
should be adjusted in relation to the
load in the vehicle.

0.
1 or 2 people in the front seats.

-.
3 people.

1.
4 people.

2.
4 people + maximum authorised load.

3.
Driver + maximum authorised load.


Switching off

The system is switched off below a certain
angle of rotation of the steering wheel.
It is switched off when reverse gear is
engaged.