headlamp Peugeot 208 2017 Owner's Manual

2
.
Instrument panels 7
W arning and indicator lamps 1 0
Indicators
23
Trip computer

3
0
Date and time adjustment

3
3
Lighting dimmer

3
4Remote control

3
6
Doors
3
6
Locking – Key
3
7
Central locking
4
0
Boot
4
0
Alarm

41
Electric windows
4
3
PE UGEOT i- Cockpit 4 5
Steering wheel adjustment 4 6
Mirrors
46
Front seats

4
8
One-piece bench seat
5

3
2/3 – 1/3 split rear bench seat

5
3
Head restraints

5
4
Recommendations for ventilation
and air conditioning

5
5
Heating
5

6
Manual air conditioning
5

6
Dual-zone automatic air conditioning
5

7
Recirculation of interior air

6
0
Demisting – defrosting

6
0
Courtesy lamp

6
1
Interior ambient lighting
6

2
Sunroof blind

6
3
Interior fittings

6
3
Boot fittings

6
5
Rear shelf
6 5 L

ighting control stalk
6
7
Direction indicators
6
8
Automatic illumination of headlamps
6
9
Daytime running lamps/Sidelamps
7
1
Headlamp adjustment
7
1
Cornering lighting
7
1
Wiper control stalk
7
2
General safety recommendations 7 5
Hazard warning lamps 7 6
Emergency or assistance call
7

6
Electronic stability control (ESC)

7
8
Seat belts
8

1
Airbags


84
Child seats

8
8
Deactivating the passenger's front airbag
8

9
ISOFIX mountings and child seats
9

7
Child lock

1
03
Dashboard instrumentsAccess
Over view
Ease of use and comfort Lighting and visibility
Safety
Instruments and controls 4
Contents

6
Central switch panel
Central locking
Hazard warning lamps
Side switch panel
(Depending on version.)Activation of Park Assist
or Deactivation of the rear parking
sensors
Deactivation of the DSC/ASR
system
Deactivation of Stop & Start Reinitialisation of the tyre under-
inflation detection (without the
touch screen)
Deactivating the volumetric
monitoring
Turning on the electric child lock
Headlamp beam height adjustment
Over view

22
Warning / indicator lampStateCause Action / Observations
Automatic
wiping Fixed.
The wiper control stalk has been
pushed down. Automatic front wiping is activated.
To deactivate automatic wiping, operate the control
stalk downwards or put the stalk into another position.
Left-hand
direction
indicator Flashing with audible
signal.
The lighting control stalk has
been moved down.
Right-hand
direction
indicator Flashing with audible
signal.
The lighting control stalk has
been moved up.
Sidelamps Fixed. The lighting control stalk is in the
"Sidelamps" position.
Front foglamps Fixed. The front foglamps are switched
on using the ring on the lighting
control stalk. Turn the ring on the lighting control stalk rear ward
once to switch off the front foglamps.
Dipped beam
headlamps Fixed.
The lighting lever is in the
"Dipped beam headlamps"
position.
Main beam
headlamps Fixed.
The lighting lever has been pulled
towards you. Pull the lever to return to dipped beam headlamps.
Dashboard instruments

47
Electric adjustments
F Move control A to the right or to the left to select the corresponding mirror.
F

M
ove control B in any of the four directions
to adjust.
F

R
eturn control A to its home position
(c e nt r e).
Folding / unfolding When locking the vehicle, the mirrors
fold automatically.
When unlocking the vehicle, the
mirrors unfold automatically.
F

W
ith the ignition on, pull control A
rear wards to fold the mirrors.
F

P
ull it again to unfold them. If the mirrors are folded using control A
,
they will not unfold when the vehicle is
unlocked. Pull again on control A .
Objects seen in the mirror are in reality
closer than they appear.
Take this into account when assessing
the distance of vehicles approaching from
behind.
The folding and unfolding of the door
mirrors using the remote control can be
deactivated by a PEUGEOT dealer or a
qualified workshop.
Fold the mirrors when putting your vehicle
through an automatic car wash.
If necessary, the mirrors can be folded
manually.
Rear view mirror
Equipped with an anti-dazzle system, which
darkens the mirror glass and reduces the
nuisance to the driver caused by the sun,
headlamps from other vehicles, etc.
Manual model
Adjustment
F A djust the mirror so that the mirror is
directed correctly in the "day" position.
Day / night position
F

P
ull the lever to change to the "night" anti-
dazzle position.
F

P
ush the lever to change to the normal
"day" position.
3
Ease of use and comfort

67
Lighting control stalk
Travelling abroad
If planning to use your vehicle in a country
that drives on the other side of the road,
the headlamp dipped beams must be
adjusted to avoid dazzling oncoming
drivers. Contact a PEUGEOT dealer or a
qualified workshop.
Selection of main lighting
mode
Turn the ring to align the desired symbol with
the marking.Lighting off (ignition off) / Front
daytime running lamps (engine
running).
Sidelamps only.
Dipped or main beam headlamps.
Automatic illumination of headlamps.
Dipping the headlamps
Pull the lever to switch the lighting between
dipped and main beam headlamps.
In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily ("headlamp flash") by keeping the
lever pulled.
Display
Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
lighting selected is on.
Foglamps
The foglamps operate with dipped or main
beam headlamps on.
Rear foglamp only
F To switch it on, turn the ring for wards.
When the lighting is switched off automatically
(version with AUTO lighting), the foglamp and
the dipped beam headlamps will remain on.
F

T
o switch it off, turn the ring rear wards.
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps is
normal; it disappears after the lamps have
been on for a few minutes.
4
Lighting and visibility

68
Front foglamps and rear foglamp
Rotate and release the ring:
F o nce for wards to switch on the front
foglamps,
F

f
or wards a second time to switch on the rear
foglamp,
F

o
nce rear wards to switch off the rear
foglamp,
F

r
ear wards a second time to switch off the
front foglamps.
If the lighting is switched off automatically
(version with AUTO lighting) or the dipped
beams are switched off manually, the foglamps
and sidelamps remain on.
F

T
urn the ring rear wards to switch off the
foglamps, the sidelamps will then switch off. In good or rainy weather, both day and
night, using the front foglamps and the
rear foglamp is prohibited. In these
situations, the power of their beams may
dazzle other drivers. They should only be
used in fog or falling snow.
In these weather conditions, it is your
responsibility to switch on the foglamps
and dipped beam headlamps manually as
the sunshine sensor may detect sufficient
light.
Do not forget to turn off the front foglamps
and the rear foglamp as soon as they are
no longer necessary.
Switching off of the lighting when the
ignition is switched off
On switching off the ignition, all of the
lighting turns off immediately, except for
dipped beam if automatic guide-me-home
lighting is activated.
Switching on the lighting after the
ignition is switched off
To reactivate the lighting control, set the
ring to 0 – lamps off, then to the desired
position.
When the driver's door is opened, a
temporary audible signal warns you that
the vehicle's lighting is on.
The lamps, with the exception of the
sidelamps, switch off automatically after
a maximum duration of 30
minutes to
prevent discharging of the battery.
Direction indicators
F Lower the lighting control stalk fully when turning left.
F

R
aise the lighting control stalk fully when
turning right.
Lighting and visibility

69
Three flashes
Move the stalk briefly upwards or downwards,
without going beyond the point of resistance;
the corresponding direction indicators will flash
three times.This function can be used at any speed,
but it is particularly useful for changing
lane on fast roads.
Automatic illumination of
headlampsIf you forget to cancel the direction
indicators for more than 20 seconds, the
volume of the audible signal will increase if
the speed is above 40
mph (60 km/h).When a low level of ambient light is detected
by a sunshine sensor, the number plate lamps,
sidelamps and dipped beam headlamps are
switched on automatically, without any action
on the part of the driver. They can also come
on if rain is detected, at the same time as
automatic operation of the windscreen wipers.
As soon as the brightness returns to a
sufficient level or after the windscreen wipers
are switched off, the lamps are switched off
automatically.
Switching on
F Turn the ring to the AUTO
position.
Activation of the function is accompanied by
a message in the screen.
Switching off
F Turn the ring to another position. Deactivation of the function is accompanied
by a message in the screen.
In fog or snow, the sunshine sensor may
detect sufficient light. In this case, the
lighting will not come on automatically.
Do not cover the sunshine sensor, linked
with the rain sensor and located in the
centre of the windscreen behind the rear
view mirror; the associated functions
would no longer be controlled.
Automatic guide-me-home
lighting
Association with automatic illumination of
headlamps provides the guide-me-home
lighting with the following additional options:
-

s
election of the lighting duration of 15, 30 or
60


seconds,
-

a
utomatic activation of guide-me-home
lighting when the automatic illumination of
headlamps is in operation.
4
Lighting and visibility

70
The guide-me-home lighting can be
configured in the menu Driving /
Vehicle.
In the event of a malfunction of the
sunshine sensor, the lighting comes
on, this warning lamp is displayed
in the instrument panel and/or a
message appears in the screen,
accompanied by an audible signal.
Contact a PEUGEOT dealer or a
qualified workshop.
Manual guide-me-home
lighting
Temporarily keeping the dipped beam
headlamps on after the vehicle's ignition has
been switched off makes the driver's exit easier
when the light is poor.
Switching on
F With the ignition off, "flash" the headlamps using the lighting stalk.
F

A f
urther "headlamp flash" switches the
function off.
Manual guide-me-home lighting
is also available from the remote
control lighting button.
Switching off
Manual guide-me-home lighting goes off
automatically at the end of a given period of
time.
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.
F

W
ithin one minute after switching off the
ignition, operate the lighting control stalk
up or down depending on the traffic side
(example: parked on the right; lighting
control stalk downwards; the left-hand
sidelamp comes on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the middle position or
switch on the ignition.
Lighting and visibility

71
Headlamp adjustment
To avoid causing a nuisance to other road
users, the height of the headlamp beams
should be adjusted according to the load in the
vehicle.
0.1 or 2 people in the front seats.
-. Intermediate setting.
1. 5 people.
-. 5 people + maximum authorised load.
2. Driver + maximum authorised load.
The initial setting is position 0 .
Daytime running lamps/
Sidelamps
In daytime running lamps, the diodes are
b r i g h t e r.
The front and rear lamps light up automatically
when the engine starts.
They provide the following functions:
-

D
aytime running lamps (lighting control
stalk at position " 0" or " AUTO " with
adequate light level).
-

S
idelamps (lighting control stalk in "
AUTO"
position with low light levels or "Sidelamps
only" or "dipped/main beam headlamps").
Cornering lighting
With dipped or main beams, this system
makes use of the beam from a front foglamp
to illuminate the inside of a bend, when the
vehicle speed is below 25


mph (approximately
40
km/h) (urban driving, winding road,
intersections, parking manoeuvres, etc.).
4
Lighting and visibility

104
Eco-driving
Eco-driving is a range of everyday practices
that allow the motorist to optimise their fuel
consumption and CO
2 emissions.
Optimise the use of your gearbox
With a manual gearbox, move off gently and
change up without waiting. During acceleration
change up early.
With an automatic or electronic gearbox,
give preference to automatic mode and avoid
pressing the accelerator pedal heavily or
suddenly.
The gear shift indicator invites you to engage
the most suitable gear: as soon as the
indication is displayed in the instrument panel,
follow it straight away.
For vehicles fitted with an electronic or
automatic gearbox, this indicator appears only
in manual mode.
Drive smoothly
Maintain a safe distance between vehicles, use
engine braking rather than the brake pedal,
and press the accelerator progressively. These
practices contribute towards a reduction in fuel
consumption and CO
2 emissions and also help
reduce the background traffic noise.
If your vehicle has cruise control, make use of
the system at speeds above 25
mph (40 km/h)
when the traffic is flowing well.
Control the use of your electrical
equipment
Before moving off, if the passenger
compartment is too warm, ventilate it by
opening the windows and air vents before using
the air conditioning.
Above 30
mph (50 km/h), close the windows
and leave the air vents open.
Consider using equipment that can help keep
the temperature in the passenger compartment
down (sunroof and window blinds, etc.).
Unless it has automatic regulation, switch off
the air conditioning as soon as the desired
temperature has been reached.
Switch off the demisting and defrosting
controls, if not automatic.
Switch off the heated seat as soon as possible. Switch off the headlamps and front foglamps
when the ambient light level does not require
their use.
Avoid running the engine before moving off,
particularly in winter; your vehicle will warm up
much faster while driving.
As a passenger, if you avoid connecting your
multimedia devices (film, music, video game
etc.), you will contribute towards limiting the
consumption of electrical energy, and so of
fuel.
Disconnect your portable devices before
leaving the vehicle.
Limit the causes of excess
consumption
Spread loads throughout the vehicle; place the
heaviest items in the bottom of the boot, as
close as possible to the rear seats.
Limit the loads carried in the vehicle and
reduce wind resistance (roof bars, roof rack,
bicycle carrier, trailer, etc.). Use a roof box in
preference.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and
refit your summer tyres.
Driving