bulb Peugeot 307 SW 2003 Owner's Manual

YOUR 307 SW AT A GLANCE1
Pages
Seats 88-102
Steering wheel controls 110-116
Instrument dials 28-29
Ventilation, air conditioning 82-87
Mirrors 118-119
Pages
Checks 136-140
Access 103-109
Changing a bulb 145-147
Changing a wheel 141-144
Fuel filler flap 109
Each model may only be fitted with some of the equipment shown, according to its specification and the technical requirements in the country of first registration of the vehicle.
14-04-2003

14-04-2003
CHANGING A BULB Front lights Note:on the right-hand side, remove the style cover, fixed
with two plastic screws, to access the bulbs. Handle the bulbs with a dry cloth.
1 - Dipped beam headlamps (H7-55W).
2 - Main beam headlamps (H1-55W).
3 - Front fog lamps (H1-55 W). Turn the protective cover corresponding to the faulty bulb a quarter of a turn and remove it.
 Disconnect the connector.
 Press the end of the securing clip to free it. Changethe bulb. When fitting the new bulb, ensure that the direction notches are positioned correctly and the securing clip
is fixed properly.
 Reconnect the connector.
 Refit the protective cover, positioning it with the arrowupwards, then turn it a quarter of a turn to the right. The headlamps are fitted with polycarbonate glass with aprotective coating.
Do not clean them with a dry or
abrasive cloth, nor with a detergent or solvent product. Use a sponge and soapy water.
4 - Side lights W 5 W.  Pull the socket rearwards, remove the bulb and chan- ge it.
5 - Direction indicators (PY 21 W amber).  Turn the bulb holder a quarter of a turn and remove it.
 Change the bulb.
Note: In certain climatic conditions (low temperature,
humidity), condensation inside the headlamp glass is
normal ; it disappears a few minutes after the lights are
switched on.
PRACTICAL INFORMATION 145

14-04-2003
Direction indicator side
repeaters (WY 5W amber). Push the repeater forwards and
release the assembly.
 Hold the connector and turn thelens a quarter turn.
 Change the bulb.
PRACTICAL INFORMATION
146
Amber coloured bulbs (direction indicators andside repeaters), must bereplaced with bulbs ofidentical specification
and colour.

14-04-2003
PRACTICAL INFORMATION147
Third brake light: 4 W 5 W bulbs.  Remove the tailgate upper trim carefully by unclipping it on eitherside, perpendicular to its direc-tion of engagement.
 Insert a screwdriver into the twoouter holes Bto press on the two
tabs C.
 Push the light unit outwards whilemaintaining the pressure on thetabs.
 Pull the light unit outwards whiletilting it.
 Change the faulty bulb.
 When refitting, ensure that thelight unit tabs are engaged cor-rectly and that the tailgate uppertrim has been put back in place
correctly.
Press the tab Aand remove the
bulb holder.
 Change the faulty bulb.
Note: if necessary use the wheelbra-
ce to remove the bolts. When refitting, take care to position
the bulb holder and the bulb correctly. Number plate lights (W 5 W)  Insert a small screwdriver in one of the external holes of the lens.
 Push the lens outwards to unclipit.
 Remove the lens.
 Change the faulty bulb.
Rear lights
1 - Brake lights (P 21 W).
2 - Side lights (R 5 W).
3 - Direction indicators (P 21 W).
4 - Reversing lights (P 21 W), left
side.
Fog lamp (P 21 W), right side.
These 5 bulbs are changed by remo- ving the light:  Remove the respective boot side trim to access the light.
 Remove the mounting nut for thelight inside the boot.
 Remove the mounting nut for thelight outside the boot.
 Remove the light.
 Unclip the harness.