ad blue Peugeot 508 Hybrid 2014 Owner's Manual

.
.
508_en_Chap00a_sommaire_ed02-2014
Child seats 155
Deactivating the passenger's front airbag
1
58
ISOFIX child seats

1
64
Child lock

1
70
Child safety
Direction indicators 1 71
em

ergency or assistance call
1
72
H o r n


172
Warning triangle
1

73
Tyre under-inflation detection

1
74
e

SC system
1
76
Seat belts
1

79
Airbags
1

82
Safety
temporary puncture repair kit 186
Changing a wheel
1
92
Snow chains

1
99
Changing a bulb
2

00
Changing a fuse
2

07
12 V battery

2
11
Removing - refitting the battery

2
15
en

ergy economy mode
2
19
Changing a wiper blade
2

20
to

wing the vehicle
2
21
to

wing a trailer
2
23
Fitting roof bars

2
25
Very cold climate screen

2
26
Accessories


227
Practical information
Opening the bonnet 2 30
Running out of fuel (Diesel)
2
31
Petrol engines

2
32
Diesel engines
2

34
BlueHDi Diesel engines

2
36
Checking levels
23

7
Checks
240
AdBlue
® additive and SCR system
(BlueHDi Diesel) 2 42
Checks
Petrol engines 2 50
Petrol weights
2
52
Diesel engines
2

54
Diesel weights

2
58
Dimensions


262
Identification markings
2

64
technical data
emergency or assistance 2 65
JBL equipment
2
67
7-inch touch screen

2
69
Audio system

3
41
Audio equipment and telematics
Alphabetical indexVisual search
Contents

4
4 4, 10124262
120
508_en_Chap00b_vue-ensemble_ed02-2014
Over view
Electronic key: Keyless
Entry and Starting
this system allows you to unlock, lock
and start your vehicle while keeping
the key on your person and in the
recognition zone around the vehicle.
exterior
Stop & Start
this system puts the engine temporarily into
standby during stops in the traffic (red lights, traffic
jams, etc...). t
h
e engine restarts automatically as
soon as you want to move off.
t
h
e Stop & Start
system reduces fuel consumption and exhaust
emissions, and offers the comfort of complete
silence when stationary.
Panoramic sunroof (SW)
the glass roof makes the passenger compartment
brighter and is fitted with an electric blind.
AdBlue® additive (BlueHDi Diesel engines)
this system uses a catalytic converter which turns up to 85% of
nitrous oxides (NOx) into nitrogen and water, harmless to health
and the environment.
th

e AdBlue
® additive is held in a tank located under the boot at
the rear of the vehicle.
Its capacity is 17 litres, which gives a driving range of
approximately 12 000 miles (20 000 km).

6
15 4 12487 3 41 269
89
92
508_en_Chap00b_vue-ensemble_ed02-2014
Interior
Interior mood lighting
this subdued passenger compartment lighting
improves visibility inside the vehicle in low
lighting conditions.
Head-up display
this system projects speed and cruise control/
speed limiter information onto a smoked strip
in the driver's field of vision, so that they do not
need to take their eyes off the road.
Digital air conditioning
After setting the desired level of comfort, the
system then automatically controls this level
according to the ambient conditions.
Audio and communication
systems
these systems benefit from the latest
technology: MP3 compatible audio systems,
uS
B player, Bluetooth hands-free system,
satellite navigation system with colour screen,
auxiliary inputs, Hi-Fi audio system, ...
Audio system Touch screen
Manual
Dual-zone If your vehicle is fitted with a
JBL Hi-Fi audio system, this
is designed specifically for the
passenger compartment of your
vehicle.
Refer to the "Audio and telematics" section.
Quad-zone
Over view

12
Monitoring
Instrument panel
1. Rev counter (x 1 000 tr/min or rpm), graduation according to engine (petrol or
Diesel).
2.


e
n
gine oil temperature gauge.
3.
F

uel gauge.
4.


e
ng
ine coolant temperature gauge.
5.
Spe

edometer (mph or km/h).
6.
C

ruise control or speed limiter settings.
7.


g
e
ar shift indicator for a manual gearbox
or gear lever position and gear for an
electronic or automatic gearbox. A. M
ain lighting dimmer.
B. D isplay of alert log.
R

ecall of information:
●

o
n servicing,
●

o
n driving range for the emissions
control additive (AdBlue
®).
C. R
eset the trip distance recorder.
8.
D

isplay zone: alert messages or state of
functions, trip computer.
9.


t
r

ip distance recorder (miles or km).
10.
Aut

omatic wipers
S

ervice indicator (
miles or km) then, t
otal distance recorder.


t
h

ese two functions are displayed
successively when switching on the
ignition.
Dials and screens Control buttons

22
Warning or indicator lamp
in the instrument panelState
Cause Action / Observations
AdBlue
® additive
(BlueHDi Diesel) fixed, on switching
on the ignition,
accompanied by an
audible signal and a
message indicating the
remaining driving range.the
remaining driving range is
between 350 miles (600 km) and
1500 miles (2400 km). Have the AdBlue® additive tank topped up as soon
as possible: go to a dealer Pe ugeOt or a qualified
workshop, or carry out this operation yourself by
referring to the corresponding section.
+ flashing associated with
the S
eR

VIC
e
w

arning
lamp, accompanied by
an audible signal and a
message indicating the
remaining driving range.
the

remaining driving range is
between 0 and 375 miles (600 km). You must top-up the AdBlue
® additive tank to avoid
a breakdown : go to a dealer Pe
ugeOt or a qualified
workshop, or carry out this operation yourself by
referring to the corresponding section.
flashing, associated
with the S
eR

VIC
e

w

arning lamp,
accompanied by an
audible signal and a
message indicating that
starting is prevented.
th

e AdBlue
® tank is empty: the
starting inhibition system required
by legislation prevents starting of the
engine.to b e able to start the engine, you must top-up the
AdBlue® additive tank: go to a dealer Pe ugeOt or a
qualified workshop, or carry out this operation yourself
by referring to the corresponding section.
It is essential to add at least 3.8 litres of AdBlue
® to
the tank.
Monitoring

23
Warning or indicator lamp
in the instrument panelState
Cause Action / Observations
+
+ SCR emissions
control system

(BlueHDi Diesel) fixed, on switching on
the ignition, associated
with the S
eR

VIC e

an

d engine diagnostic
warning lamps,
accompanied by an
audible signal and a
message indicating an
emissions control fault. A fault with the SCR emissions
control system has been detected.
th

is alert disappears once the exhaust emissions
return to normal levels.
flashing, on switching
on the ignition,
associated with the
S
eR

VIC
e an
d engine
diagnostic warning
lamps, accompanied by
an audible signal and a
message indicating the
remaining driving range.
the

remaining driving range is
between 0 and 650 miles (1 100 km). Contact a P
e

uge
Ot
dealer or a qualified workshop
without delay , to avoid a breakdown .
flashing, on switching
on the ignition,
associated with the
S
eR

VIC
e an
d engine
diagnostic warning
lamps, accompanied by
an audible signal and a
message indicating that
starting is prevented. You have exceeded the authorised
driving limit: the starting inhibition
system prevents starting of the
engine.
to b

e able to start the engine, you must call on a
P
e

uge
Ot
dealer or a qualified workshop.
1
Monitoring

27
* According to country.
CHECK (vehicle autotest)
Automatic CHECK
With the key in the ignition on position, all of the
warning lamps for the functions tested are displayed.
th
ey are switched off after a few seconds.
At the same time, an automatic CHeC K
(vehicle autotest) is carried out.
In the presence of a fault
A "minor" fault has been detected: the warning
lamp(s) are displayed then go off.
You can start your vehicle; however, contact a
P
e

uge
Ot
dealer or a qualified workshop as
soon as possible.
A "major" fault has been detected: the
associated warning lamps(s) remain on
accompanied by the S
tO

P or S
eR
VIC
e

warning lamp.
Do not start your vehicle.
Call a P
e

uge
Ot
dealer or a qualified
workshop without delay.
Manual CHECK
Pressing the "CHECK" button on the
instrument panel starts the manual CHeC K
(vehicle autotest).
th

is function enables you to recall at any time
(with the key in the ignition on position or with
the engine running), the alerts present.
the passenger's airbag deactivated warning
lamp* remains on while the airbag is deactivated.
With the engine running and the vehicle
moving, the instrument panel displays the
warning lamps (in the event of a fault).
If no "major" fault is found, you can start your
vehicle.
Lighting dimmer control
With the headlamps on, press button B to
increase the brightness of the instruments
and controls and the interior mood lighting or
button
A to reduce it.
As soon as the lighting reaches the required
level of brightness, release the button.
If your vehicle has a BlueHDi engine,
pressing the " CHECK" button gives
you the distance that can be travelled
before engine starting is prevented
automatically.
For more information on the AdBlue
®
additive, refer to the corresponding
section.
1
Monitoring

28
Service indicator
More than 1 800 miles (3 000 km)
remain before the next service is due
When the ignition is switched on, no service
information appears in the screen.
th

is is a check against the planned servicing
intervals in the manufacturer's servicing
schedule.
It is calculated from the last service indicator
reset according to the number of miles travelled
and the time elapsed since the last service.
For BlueHDi Diesel versions only (depending
on country of sale), the level of deterioration of
the engine oil is also taken into account.
Between 600 miles (1 000 km) and
1 800 miles (3 000 km) remain before
the next service is due
For 5 seconds after the ignition is switched on, the
spanner symbolising the service operations comes
on.
t
h
e distance recorder display line indicates the
distance remaining before the next service is due.
Example: 1 700 miles (2 800 km) remain before
the next service is due.
For 5 seconds after the ignition is switched on, the
screen indicates:
5 seconds after the ignition is switched on,
the spanner goes off ; the distance recorder
resumes its normal operation.
t
h
e screen then
indicates the total and trip distances.
Less than 600 miles (1 000 km)
remain before the next service is due
Example: 560 miles (900 km) remain before
the next service is due.
For 5 seconds after the ignition is switched on,
the screen indicates:
5 seconds after the ignition is switched on,
the distance recorder resumes its normal
operation. The spanner remains on to
indicate that a service must be carried out
soon.
Illumination of the key is accompanied
by a message in the instrument panel
screen.
With BlueHDi Diesel versions the
Service
warning lamp may come on as
soon as the ignition is switched on.
Monitoring

29
Service overdue
For 5 seconds after the ignition is switched on,
the spanner flashes to indicate that the service
must be carried out as soon as possible.
Example: the service is overdue by 186 miles
(3 0 0 k m).
For 5 seconds after the ignition is switched on,
the screen indicates:
th
e spanner may also come on if
you have exceeded the period since
the last service, as indicated in the
maintenance and warranty guide.
With BlueHDi Diesel versions, the
spanner can also come on in advance
of the service interval, according to the
level of deterioration of the engine oil,
which depends on the driving conditions
in which the vehicle is used.
Following this operation, if you wish to
disconnect the battery, lock the vehicle
and wait at least five minutes for the
zero reset to be registered.
5 seconds after the ignition is switched on, the
distance recorder resumes its normal operation.
The spanner remains on
.
Service indicator zero reset
After each service, the service indicator must
be reset to zero.
Retrieving the service
information
You can access the service information at any
time.
F

P
ress the trip distance recorder zero reset
button.


t
h
e service information is displayed for a
few seconds, then disappears.
If you have carried out the service on your
vehicle yourself:
F

s
witch off the ignition,
F
p
ress and hold the trip distance recorder
zero reset button,
F
s
witch on the ignition; the distance recorder
display begins a countdown,
F
w
hen the display indicates "=0"
, release
the button; the spanner disappears.
1
Monitoring

89
508_en_Chap03_confort_ed02-2014
Dual-zone digital air conditioning
Automatic operation
1. Automatic comfort programme
F Press this "AUTO" button. th e
indicator lamp comes on.
We recommend that you use this mode. It
automatically adjusts all settings to provide
optimum operation for the comfort level
chosen: passenger compartment temperature,
air flow, air distribution and air recirculation.
th

is system is designed to operate effectively
in all seasons, with the windows closed. When the engine is cold, to prevent
too great a distribution of cold air, the
air flow will reach its optimum level
gradually.
In cold weather, it favours the
distribution of warm air to the
windscreen, side windows and footwells
o n l y.
2 - 3. Driver-passenger side
adjustment
the driver and front passenger can each adjust
the temperature to their requirements.
th

e value indicated on the display corresponds
to a level of comfort and not to a temperature in
degrees Celsius or Fahrenheit.
F
t
u
rn control 2 or 3 to the left
(blue) or to the right (red)
respectively to decrease or
increase this value.
A setting around the value 21 provides
optimum comfort. However, depending on your
requirements, a setting between 18 and 24 is
normal.
It is recommended that the difference between
left and right should not be greater 3.
th

e air conditioning can only operate with the engine running.
3
Comfort