light Peugeot 508 RXH 2012 Owner's Guide

3
113
Comfort
) Press this "full fan"button to
increase the air flow.)Press the corresponding button for:
Windscreen and side windows.
Centre and side vents.
Footwells.
To s u i t
your requirements, you cancombine two distribution buttons or select the three distribution modes
simultaneously.
)
Press "empty fan"button to reduce the air flow.

)
Press this "empty fan"
air
flow button until the fan symbol
disappears and "--"
appears.
Automatic air intake modeIt is activated by default with automatic comfort regulation.
9. Air fl ow adjustment
The symbol for air flow, the fan, fills progressively according to the value requested.
Switching the system off
This action switches off all of the functions of
the air conditioning system.
Temperature related comfor t is no longer assured but a slight flow of air, due to the
for ward movement of the vehicle, can still be felt.
Avoid driving for long periods with the system
off (risk of condensation and deterioration of
the air quality). Pressing the "full fan"
buttonreactivates the system with the values in use at
the time it was switched off.


10. Air intake/Air recirculation
Air recirculation enables the passenger compar tment to be isolated from exterior odours and smoke. It is activated automatically
when operating the screenwash. It is inactive
when the ambient temperature is below 5 °C to
guard against the risk of misting in the vehicle. ) As soon as possible, press this button
again to permit the intake of outside air and prevent the formation of condensation.The indicator lamp in the button goes off.

3
115
Comfort

4. Air fl ow adjustment
)
Press this "full fan" button toincrease the air flow.
)
Press this "empty fan" button to
reduce the air flow. The air flow s
ymbol, the fan, fills progressivelyas the fan speed increases.
Deactivating the system
)
Press the "empty fan" air flow
button until the
fan disappears and "--" appears.
This action sto
ps all of the functions of the air conditioning system.
Thermal comfor t is no longer controlled.However, a slight air flow may still be felt,resulting from the for ward movement of the
vehicle.

4
121
!
Driving

Emergency braking

In the event of a failure of the main servicebrake, a continuous pull on the control lever Awill stop the vehicle.
The dynamic stability control provides stability
during emergency braking.
If the emergency braking malfunctions,
a message will be displayed.
I
f a failure of the DSC system is
signalled by the lighting of this warning lamp, then braking stability is
not guaranteed.
In this event, stability must be assured by the
driver by repeating alternate "pull-release" actions on the control lever A .
Emergency parking brake release
)if your vehicle has one, take out the vehicle chock B
, located behind the rear seats. )On a slope, immobilise the vehicle byplacing a chock in front or behind one of
the front wheels, opposing the slope.
On level ground, immobilise the vehicle byplacing a chock in front or behind one of
the front wheels. In the event o
f fault with the electric parking
brake or a battery failure, an emergency
mechanical control can be used to manuallyrelease the parking brake.)
Immobilise the vehicle (or chock it if the brake pedal has not been released), with
the hybrid system active, place the gear lever in position M or R.)
Switch of the hybrid system, but leave the
ignition on. If you are unable to immobilise
the vehicle, do not operate this control and contact a PEUGEOT dealer or a qualified
workshop as soon as possible.

The emergency braking must only be used in exceptional circumstances.

5
141 Visibility














Lighting controls System for selection and control of the various front and rear lamps providing the vehicle's lighting and signalling.


Main lighting

There are various lamps on the vehicle:


- sidelamps, to be seen,

- dipped beam headlamps to see without
dazzlin
g other drivers,

- main beam headlamps to see clearly when
the road is clear,

- directional headlamps for improved
visibility when cornering.

Additional lighting
Other lamps are installed to fulfil therequirements of particular driving conditions:
- rear foglamps to better signal the presence
of the vehicle in foggy conditions,
- daytime running lamps to be seen duringthe day.



Automatic lighting functions

Various automatic lighting functions are also
available depending on options:


- guide-me-home lighting,

- directional headlamps,

- welcome li
ghting,

- daytime lighting (daytime running lamps),

- automatic illumination of headlamps,

- adaptive lighting.

142
Visibility
Selection ring for main lighting mode
Turn the ring to position the symbol required
facing the mark.

Li
ghting off.

Automatic illumination of headlamps.


Sidelamps onl
y.

Dipped or main beam headlamps.


Stalk for switching headlamps

Pull the stalk to switch the lighting between
dipped/main beam headlamps.

In the li
ghting off and sidelamps modes, the driver can switch on the main beam headlamps
temporaril
y ("headlamp flash") by maintaining apull on the stalk.


Displays

Illumination of the corresponding indicator lamp
in the instrument panel confirms the lightingswitched on.

5
143
!
Visibility
Foglamps selection ring
The foglamps operate with dipped and main beam headlamps.

Rear foglamps
When the headlamps switch off with automatic illumination of headlamps (AUTO model) or when the dipped beam headlamps are switched
off manually, the foglamps and sidelampsremain on.) Turn the ring rear wards to switch off thefoglamps, the sidelamps will then switch off.

In good or rainy weather, both day andnight, use of the the rear foglamps is prohibited. In these situations, thepower of their beams may dazzle other drivers. They should only be used in fog or snow.
In these weather conditions, it is your responsibility to switch on the foglamps and dipped headlamps manually as the sunshine sensor may detect sufficientlight.
Do not forget to switch off the rear foglamps when they are no longer needed.
)Turn the ring for wards and release toswitch on the rear foglamps.

144
i
i
i
Visibility

Lighting left on audible signal
An audible signal when a front door is opened warns the driver that the vehicle's exterior lighting is on, with the ignition off and in manual lighting mode.
In this case, switching off the lighting stops the audible signal.
With the ignition off, if the dippedheadlamps remain on, the vehicle goes into "ECO" mode to avoid dischargingthe battery.

In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal sur face of theglass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.

Daytime lighting, compulsory in cer tain
countries, which comes on automatically when
the engine is star ted making the vehicle more
visible to other road users.
Daytime running lamps

This function is assured:


- in countries where it is imposed byregulations, by illumination of the dippedbeam headlamps with the sidelamps and number plate lamps.

- for other countries where it is provided, by
the use of dedicated lamps.

This function can be activated or deactivated via the vehicleconfiguration menu.



The lighting goes off when you switchoff the ignition, but you can always switch it on again using the lightingcontrol stalk.


*

f
unction that can be set in the vehicle
configuration menu.
LED lamps

They come on when the engine is started.
Depending on the destination country, they are used for:


- daytime running lamps *
in day mode andsidelamps in night mode (they are brighter
when daytime running lamps),
or


- sidelamps in day and night mode.
Where LED lamps are fitted, the filament bulbs
for the da
ytime running lamps/sidelamps in the front lamp units are not used.

5
145
Visibility
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only. ) Within one minute of switching off the
ignition, operate the lighting control stalk up
or down depending on the traffic side (for example: when parking on the left; lightingcontrol stalk upwards; the right handsidelamps are on).
This is confirmed by an audible signal andillumination of the corresponding direction indicator warning lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the middle position or
switch on the ignition.
Temporarily keeping the dipped beam
headlamps on after the ignition has beenswitched off makes the driver's exit easier when
the light is poor.
Manual guide-me-home
lighting

Switching on
)Within 30 seconds or a minute after switching of the ignition (according to theautomatic guide-me-home lighting durationprogrammed in the configuration menu),
"flash" the headlamps using the lightingstalk.)A further "headlamp flash" switches the
function off.



Switching off

The manual guide-me-home lighting switches
off automatically after about 30 seconds.

146
!
Visibility
The sidelamps and dipped beam headlamps are switched
on automaticall
y, without any action on the par t of the
driver, when a low level of external light is detected or in certain cases of activation of the windscreen wipers. As soon as the brightness returns to a sufficient
level or after the windscreen wipers are switched
off, the lamps are switched off automaticall
y.
Automatic illumination of
headlam
ps
Activation
) Turn the ring to the "AUTO"
position. The automatic
illumination of headlamps is accompanied by a
message in the instrument panel screen.
Deactivation
)Turn the ring to another position. Deactivation is accompanied by a message in the instrument panel screen.


Association with automatic guide-me-home lighting

Association with automatic illumination of
headlamps provides the guide-me-home lighting with the following additional options:


- selection of the lighting duration of 15, 30or 60 seconds,

- automatic activation of guide-me-home lighting when the automatic illumination of
headlamps is in operation.



Operating fault

In the event of a fault with the sunshine sensor, the lightingcomes on, this warning lamp
is displayed in the instrument panel and/or
a message appears in the instrument panel screen, accompanied by an audible signal.
Contact a PEUGEOT dealer or a qualified
workshop.
In fog or snow, the sunshine sensor maydetect sufficient light. In this case, the lighting will not come on automatically. Do not cover the sunshine sensor,coupled with the rain sensor and located in the centre of the windscreenbehind the rear view mirror; theassociated functions would no longer be controlled.


Programming
Selection of the duration of the guide-me-home lighting is done
in the configuration menu vehicleparameters, in the instrument panel screen.

5
147
i
i
Visibility

Adaptive lighting


Switching on
The driver can take over at any time, if the circumstances dictate:
System which automatically changes betweendipped and main beam according to the driving conditions, using a sensor in the rear viewmirror.
The system is active from 15 mph (25 km/h)
and is deactivated below 9 mph (15 km / h).
)put the lighting control stalk on the "AUTO"
or "Dipped/main beam headlamps"
position,
Switching off
) or by dipping the headlamps manually using the lighting control stalk, whether
in the "AUTO" or "Dipped/main beam
headlamps" position.
Flashing the headlamps does notdeactivate the system.The state of the system is stored in memory when switching off the ignition. This automatic headlamp dipping system is a driving aid. The driver remains responsible for the vehicle'slighting and its correct use for theprevailing conditions of light, visibility and traffic.

The system may suffer interference or not work correctly:


- under conditions of poor visibility(for example, snowfall, heavy rainor thick fog, ...),

- if the windscreen is dir ty, misted or obscured (by a sticker, ...) in front of the sensor,

- if the vehicle is facing highly reflective signs.



The system is not able to detect:


- road users that do not have their own lighting, such as pedestrians,

- road users whose lighting is obscured, such as vehicles running behind a safety barrier (on amotorway, for example),

- road users at the top or bottom of a steep slope, on twisty roads, on crossroads.


)press this button, the
warning lamp goes off,
) press this button, the
warning lamp comes on.