headlamp Peugeot 607 Dag 2002 Owner's Guide

PRACTICAL INFORMATION 143
CHANGING A BULB
Front lights
In the engine compartment, remove the style cover secured
by one or two butterfly screws, a plastic retainer clip and
two screws.
Note:
handle the bulbs with a dry cloth.
1 Dipped beam headlamps: H755W or Xenon bulb.
WARNING: RISK OF ELECTROCUTION
Xenon bulbs must be replaced by a PEUGEOT
dealer.
2 Main beam headlamps: H155W.
 Turn the protective cover of the faulty bulb a quarter
of a turn and remove it.
 Disconnect the connector.
 PPress the end of the securing clip to free it. Change
the bulb.
 When fitting the new bulb, ensure that the direction
notches are positioned correctly and the securing
clip is fixed properly. 
Reconnect the connector.
 Refit the protective cover.
The headlamps are fitted with polycarbonate glass with a
protective coating. Do not clean them with a dry or abra
sive cloth, nor with a detergent or solvent product.
3 Side lights: W 5 W.
 Pull the socket rearwards, remove the bulb and
change it.
4 Direction indicators: PY 21 W (amber).
 Turn the bulb holder a quarter turn and remove it.
 Change the bulb.
 Refit the style cover.
Front foglamps: H1 55 W.
Note: In certain climatic conditions (low temperature,
humidity), condensation on the inside surface of the
headlamp glass is normal ; it disappears a few minutes
after the lights are switched on.

PRACTICAL INFORMATION
148
Engine compartment fuses
Fuse box
To access the fuses located in the
engine compartment (next to the bat
tery) :
remove the style cover and unclip
the cover.
After carrying out the work, close
the cover very carefully and
replace the style cover.
The electrical system of
your vehicle is designed
to operate with standard
or optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT
dealer.
PEUGEOT will not accept respon
sibility for the cost incurred in
repairing your vehicle or for rectify
ing the malfunctions resulting from
the installation of accessories not
supplied and not recommended by
PEUGEOT and not installed in
accordance with its instructions, in
particular where the equipment
in question consumes more than
10 milliamperes.
*Maxi fuses provide additional
protection for electrical systems.
All work must be carried out by
your PEUGEOT dealer.
Fuse N° Rating Functions
1* 70 A Builtin systems interface ( heated rear screen
heated exterior mirrors windscreen wiper
screenwash headlamp wash).
2* 50 A Fan.
3* 50/60 A ESP pump motor / ABS hydraulic unit.
4* 40 A Air conditioning blower.
5 20 A Horn Horn control relay.
6 20 A Left front and rear heated seats.
7 20 A Right front and rear heated seats.
8* 70 A Builtin systems interface.
9* 30 A Passenger electric seat.

Fuse N° RatingFunctions
10* 20 AAutomatic headlamp lighting control unit.
11* 70 A Builtin systems interface.
12* 70 A Ignition supply (+ve accessories / ignition controlled +ve).
13* 20 A Automatic headlamp lighting control unit.
14 15 A Double injection relay supply.
15* Not used.
16* Not used.
17* 30 A ESP hydraulic unit.
18 30 A Ignition supply (+ starter).
19 20 A Variable suspension control unit.
20 10 A Fan unit relay Cruise control safety switch Manual gearbox clut ch switch
Manual gearbox reversing lights switch or automatic gearbox multifu nction switch
Automatic headlamp lighting control unit Vehicle speed senso r Coolant level sensor
Water in diesel sensor Power switch control unit relay.
21 5 A Automatic gearbox control unit Automatic gearbox multifunction sw itch.
22 25 A ESP control unit.
23 15 A Diesel heating.
24 5 A Engine management control unit – Dual control control unit.
25 10 A Fuel pump.
26 30 A Driver's seat memory control unit.
27 25 A Double injection relay supply.
28 10 A Throttle housing deicing resistor, Intake pilot solenoid val ve Flow meter Piston deactivator
injectionpump Oil heating.
29 30 A Air pump, diesel additive control unit Diesel additive inje ctor.
30 Cannot be used.
31 5 A Automatic gearbox shift lock.
32 10 A ESP or ABS control unit.
33 15 A Automatic gearbox control unit Automatic gearbox multifunction sw itch (except reversing lights) Automatic
gearbox sequential control.
34 5 A Oxygen sensors Exhaust gas recirculation solenoid valve, Exhaust gas reci rculation throttle solenoid valve
Turbo pressure regulation solenoid valve..
PRACTICAL INFORMATION 149

PRACTICAL INFORMATION 147
Fuse no. Rating
Functions
7 10 A Switches, rear lighter illumination, front courtesy light, rear co urtesy light, rear lighter,
number plate lighting, headlamp height adjustment.
8 10 A Diagnostic connector, headlamp height adjustment control uni t, HF locking receiver,
passenger compartment air temperature sensor, HF tyre underinflatio n receiver.
9 20 A Headlamp wash.
10 20 A Glove box lighting, front lighter, front and rear courtesy li ght, electrochrome interior mirror,
electric exterior mirrors.
11 5 A Control unit for automatic lighting of headlamps, air bags control unit, safety relay for
automatic lighting of headlamps.
12 30 A Rear window switches on driver's pad, rear windows.
13 30 A Windscreen wiper.
14 15 A Not used.
15 15 A Driver's door pad, passenger's door pad.
16 15 A Rear lighter.
17 5 A Heated exterior mirrors.
18 15 A Rear left brake light, additional brake light.
19 10 A Parking assistance control unit, navigation control unit.
20 15 A Alarm siren, monochrome screen or colour screen control unit, HF receiver, audio system /
telephone, monochrome or colour navigation control unit, diese l additive control unit.
21 15 A Dignostic connector, caravan socket, trailer sidelights relay.
22 15 A Diesel additive control unit, driver's seat memory control unit, d river's door pad,
passenger's door pad.
23 30 A Driver's window, passenger's window, sunroof safety autoreverse, pa ssenger window swit
ch on driver's door pad andpassenger's door pad.
24 10 A Rear fog lamp.
25 40 A PARC shunt.
26 40 A Heated rear screen, radio aerial amplifier.

PRACTICAL INFORMATION
154
T
OWING A TRAILER,
CARAVAN, BOAT ETC...
Only use original PEUGEOTtow
bars which have been tested and
approved from the design stage of
your vehicle.
The tow bar must be fitted by a
PEUGEOTdealer.
Driving advice
Distribution of loads: distribute the
load in the trailer so that the heaviest
loads are as close as possible to the
axle and the nose weight is close to
the maximum authorised without,
however, exceeding it.
Cooling: towing a trailer on a slope
increases the coolant temperature.
As the fan is electronically con
trolled, its cooling capacity is not
dependent on the engine speed.
On the contrary, use a high gear to
lower the engine speed, and reduce
your speed. In all cases, pay attention to the
coolant temperature.
Note:
in certain cases of particularly
arduous use (towing the maximum
load up a steep slope in high tem
peratures), the engine automatically
limits its power. In this case, cutting
off the air conditioning allows the
engine power to be recovered, and
therefore the towing speed to be sig
nificantly increased (approximately
12mph [20 km/h] more).
If the coolant temperature warning
light comes on, stop the vehicle and
switch off the engine as soon as pos
sible.
Tyres: check the tyre pressures of
the towing vehicle and of the trailer,
observing the recommended pres
sure.
Brakes: towing increases the brak
ing distance. Drive at a moderate
speed, change down early and brake
gradually.
Side wind: sensitivity to side wind is
increased. Drive smoothly and at a
moderate speed. Lighting
Manual adjustment
Adjust your headlamps so as not to
dazzle other road users (see section
on ''Manual adjustment of head
lamps''). Check the electrical sig
nalling of the trailer.
Automatic beam correction
For vehicles with Xenon bulbs, this
system automatically corrects the
height of the beam, whatever the
load of the vehicle. The driver is then
assured of having optimum lighting
and not causing a nuisance to other
road users.
In cases of malfunction, the driver is
alerted by means of the warning light
on the instrument panel.
In this situation the system adjusts
your headlamps to the low position.