light Peugeot 607 Dag 2009 Repair Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2009, Model line: 607 Dag, Model: Peugeot 607 Dag 2009Pages: 182, PDF Size: 10.7 MB
Page 119 of 182
1010
103
CHANGING A BULB
2 - Main beam headlamps: H1-55 W.
Turn the protective cover of the
faulty bulb a quarter of a turn and
remove it.
Disconnect the connector.
Press the end of the securing clip
to free it. Change the bulb.
W h e n fi t t i n g t h e n e w b u l b , e n s u r e
that the direction notches are po-
sitioned correctly and the securing
c l i p i s fi x e d p r o p e r l y .
Reconnect the connector.
R e fi t t h e p r o t e c t i v e c o v e r . 3 - S i d e l i g h t s : W 5 W .
Pull the socket rearwards.
Remove the bulb and change it.
Front foglamps: H1-55 W.
Handle the bulbs with a dry
cloth.
T h e h e a d l a m p s a r e fi t t e d w i t h
polycarbonate glass with a
protective coating. Do not clean them
with a dry or abrasive cloth, nor with a
detergent or solvent product.
Use a soft, damp cloth with soapy water.
In the engine compartment, remove
the style cover secured by one or two
b u t t e r fl y s c r e w s , a p l a s t i c r e t a i n e r c l i p
and two quarter turn screws.
On the left-hand side, remove the par-
tition by lifting it to gain access to the
lights.
W h e n y o u h a v e fi n i s h e d , d o n o t f o r g e t
to put everything back correctly.
W A R N I N G : R I S K O F E L E C -
TROCUTION
Xenon bulbs must be replaced
by a PEUGEOT dealer.
Front lights 1 - D i p p e d b e a m h e a d l a m p s : X e n o n b u l b . 4 - D i r e c t i o n i n d i c a t o r s :
PY 21 W (amber).
Turn the bulb holder a quarter turn
and remove it.
Remove the bulb and change it.
R e fi t t h e s t y l e c o v e r .
H i g h p r e s s u r e w a s h i n g
When using this type of washing on
stubborn dirt, do not persist on the
headlamps, the lights and their sur-
rounds to avoid damaging their var-
nish and their seal.
In certain climatic conditions
(low temperature, humidity),
condensation on the inside
surface of the glass of the
headlamps and rear lights is normal;
it disappears a few minutes after the
lights are switched on.
Page 120 of 182
1010
104
Integrated direction indicator
repeaters Amber coloured bulbs, such
as the direction indicators and
side repeaters, must be re-
placed with bulbs of identical
s p e c i fi c a t i o n a n d c o l o u r . Rear lights
R e m o v e t h e t w o b u t t e r fl y n u t s s e -
curing the light.
Remove the eyelet.
Take out the lamp.
Unclip the bulb holder.
Change the faulty bulb.
Clip the bulb holder.
W h e n r e fi t t i n g i t , e n s u r e t h a t t h e l a m p
is correctly positioned and secured.
1. D i r e c t i o n i n d i c a t o r s : H p 1 6 .
2. Brake lights/side lights: Hp16.
Detach the luggage net.
Lift the boot carpet with the lifting
hook. Secure this hook behind the
boot seal.
Unclip the lower part of the sill trim,
then dislodge it by pulling upwards.
Remove the plastic retainer clip
s e c u r i n g t h e s i d e t r i m t o t h e fl o o r .
Unclip the side trim.
Push the repeater forwards and re-
lease it.
Remove the repeater and change it.
This can be obtained from a PEUGEOT
dealer. Rear wing lights
Page 121 of 182
1010
104
Integrated direction indicator
repeaters Amber coloured bulbs, such
as the direction indicators and
side repeaters, must be re-
placed with bulbs of identical
s p e c i fi c a t i o n a n d c o l o u r . Rear lights
R e m o v e t h e t w o b u t t e r fl y n u t s s e -
curing the light.
Remove the eyelet.
Take out the lamp.
Unclip the bulb holder.
Change the faulty bulb.
Clip the bulb holder.
W h e n r e fi t t i n g i t , e n s u r e t h a t t h e l a m p
is correctly positioned and secured.
1. D i r e c t i o n i n d i c a t o r s : H p 1 6 .
2. Brake lights/side lights: Hp16.
Detach the luggage net.
Lift the boot carpet with the lifting
hook. Secure this hook behind the
boot seal.
Unclip the lower part of the sill trim,
then dislodge it by pulling upwards.
Remove the plastic retainer clip
s e c u r i n g t h e s i d e t r i m t o t h e fl o o r .
Unclip the side trim.
Push the repeater forwards and re-
lease it.
Remove the repeater and change it.
This can be obtained from a PEUGEOT
dealer. Rear wing lights
Page 122 of 182
1010
105
Remove the three plastic retainer
clips securing the cover trim (those
nearest to the lamp).
Move aside the trim.
Disconnect the lamp harness.
Extract the lamp from its housing.
R e m o v e t h e fl a t s e a l .
Unclip the bulb holder.
Change the faulty bulb.
Clip the bulb holder.
P u t t h e fl a t s e a l b a c k i n p l a c e .
W h e n r e fi t t i n g i t , e n s u r e t h a t t h e l a m p
is correctly positioned and secured.
N u m b e r p l a t e l i g h t s : W 5 W.
Remove the transparent cover using
a screwdriver blade.
Change the faulty bulb.
Boot lid lights
1. Reversing lights: Hp16.
2. S i d e l i g h t s : H p 1 6 .
3. Fog lamps: Hp16.
I f y o u e n c o u n t e r a n y d i f fi c u l t i e s ,
contact a PEUGEOT dealer.
Page 123 of 182
1010
106
C H A N G I N G A F U S E
The fuse boxes are placed in the lower
part of the fascia (driver's side), in the
engine compartment (left-hand side)
and in the left boot trim.
R e p l a c i n g a f u s e
Before replacing a fuse, the cause of
the incident must be found and recti-
fi e d . T h e f u s e n u m b e r s a r e i n d i c a t e d
on the fuse box.
Correct Incorrect
F u s e N ° Rating F u n c t i o n s
F31 5 A Right-hand brake light.
F32 5 A Left-hand brake light.
F33 5 A Third brake light.
F34 - Not used.
F35 5 A
T y r e u n d e r - i n fl a t i o n d e t e c t i o n c o n t r o l u n i t , C D c h a n g e r .
F36 30 A Passenger seat relay.
F37 30 A Passenger and rear right heated seats.
F38 30 A Driver's and rear left heated seats.
F39 30 A Driver's seat relay.
F40 5 A Diagnostics socket.
Always replace a faulty fuse
with a fuse of the same rating
(same colour).
Use the special pliers located
on the support next to the fuse box,
this support also contains the replace-
ment fuses.
F a s c i a f u s e s
To access the fuses, open the cover
of the storage compartment on the
driver's side. Tilt the fuse box down-
wards.
Page 124 of 182
1010
106
C H A N G I N G A F U S E
The fuse boxes are placed in the lower
part of the fascia (driver's side), in the
engine compartment (left-hand side)
and in the left boot trim.
R e p l a c i n g a f u s e
Before replacing a fuse, the cause of
the incident must be found and recti-
fi e d . T h e f u s e n u m b e r s a r e i n d i c a t e d
on the fuse box.
Correct Incorrect
F u s e N ° Rating F u n c t i o n s
F31 5 A Right-hand brake light.
F32 5 A Left-hand brake light.
F33 5 A Third brake light.
F34 - Not used.
F35 5 A
T y r e u n d e r - i n fl a t i o n d e t e c t i o n c o n t r o l u n i t , C D c h a n g e r .
F36 30 A Passenger seat relay.
F37 30 A Passenger and rear right heated seats.
F38 30 A Driver's and rear left heated seats.
F39 30 A Driver's seat relay.
F40 5 A Diagnostics socket.
Always replace a faulty fuse
with a fuse of the same rating
(same colour).
Use the special pliers located
on the support next to the fuse box,
this support also contains the replace-
ment fuses.
F a s c i a f u s e s
To access the fuses, open the cover
of the storage compartment on the
driver's side. Tilt the fuse box down-
wards.
Page 125 of 182
1010
107
F u s e N ° Rating
F u n c t i o n s
F1 15 A F r o n t w a s h - w i p e p u m p a n d w a s h - w i p e fl u i d l e v e l s e n s o r .
F2 30 A Locking and deadlocking earth.
F3 5 A Air bags.
F4 10 A Clutch switch, brake dual-function switch, diagnostic connector
, ESP sensor,
electrochromatic mirror.
F5 30 A Front electric windows and sunroof supply.
F6 30 A Rear electric windows supply.
F7 5 A Glove box switch, courtesy lights, map reading lights, courtesy mirrors.
F8 20 A Multifunction display supply, steering wheel control, alarm si
ren, trailer fusebox supply,
PC Com, electric mirror and front and rear electric window controls.
F9 30 A Front and rear lighters (100 W max.).
F10 15 A Additive reservoir control unit supply.
F11 15 A Automatic gearbox control unit, automatic gearbo x positions selection switch, ignition switch.
F12 15 A Trailer fusebox supply, hands-free kit, seats relay, seat memory un
it, rain and brightness
sensor.
F13 5 A Engine fusebox supply.
F14 15 A Parking assistance control unit supply, instrument panel, air co
nditioning, air bags and
pre-tensioners unit.
F15 30 A Locking and deadlocking supply.
F17 40 A H i - F i a m p l i fi e r , h e a t e d m i r r o r s .
Page 132 of 182
1010
113
TOWING A TRAILER,
CARAVAN, BOAT, ETC...
We recommend the use of original
PEUGEOT towbars and their harnesses
which have been tested and approved
from the design stage of your vehicle and
t h a t y o u e n t r u s t t h e fi t t i n g o f t h e t o w b a r t o
a PEUGEOT dealer.
I f t h e t o w b a r i s n o t fi t t e d b y a P E U G E O T
d e a l e r , i t i s i m p e r a t i v e t h a t i t i s fi t t e d u s -
ing the electrical pre-equipment installed
at the rear of the vehicle, in accordance
with the manufacturer's instructions.
Note: in certain cases of par-
ticularly arduous use (towing
the maximum load in high
temperatures on a steep
slope), the engine automatically lim-
its its power and selects the appropri-
ate automatic gearbox gear in manual
mode. In this case, cutting off the air
conditioning allows the engine power
to be recovered, and therefore the
towing capacity to be increased. A u t o m a t i c a d j u s t m e n t
To avoid causing a nuisance to other
road users, this system automatical-
ly corrects the height of the beam of
xenon bulbs in relation to the vehicle
load after approximately 2 minutes.
The driver is then assured of having
optimum lighting.
D r i v i n g a d v i c e
D i s t r i b u t i o n o f l o a d s : distribute the
load in the trailer so that the heavi-
est loads are as close as possible to
the axle and the nose weight is close
to the maximum authorised without,
however, exceeding it.
Lighting
Tyres: check the tyre pressures of the
towing vehicle (label on the central
door pillar on the driver's side) and of
the trailer towed, observing the recom-
mended pressure.
If the coolant temperature
warning light comes on, stop
the vehicle and switch off the
engine as soon as possible.
I n t h e c a s e o f v e h i c l e s fi t t e d w i t h a n
HDI engine, it is advisable, following
intensive use (towing on a motorway,
prolonged driving, ...), to leave the en-
gine running at idle for approximately
20 seconds before switching off the
ignition. This limits any increase in the
temperature of the engine after it has
been switched off.
In all cases, pay attention to the coolant
temperature.
Brakes: towing increases the braking
distance. Drive at a moderate speed,
change down early and brake gradually.
S i d e w i n d : sensitivity to side wind is
increased. Drive smoothly and at a
moderate speed.
Cooling: towing a trailer on a slope in-
creases the coolant temperature.
As the fan is electrically controlled, its
cooling capacity is not dependent on
the engine speed.