diagram PEUGEOT BOXER 2021 Owners Manual

160
Special features

– Never work under a tipper body that is not
supported,
–

Switch off the power supply to the electro-
hydraulic unit using the circuit breaker

,
–

V
ehicle stationary, engine off.
For safety reasons, we very strongly
advise against doing anything under the
tipper body while it is being operated or while
it is being serviced.
Maintenance
Reservoir
Regularly check and top up the engine oil level.
Change the oil once a year. If the oil contains
water, change it.
Regularly check the condition of the hose and
ensure the hydraulic system is properly sealed.
Pump and motor
No servicing required. The rolling elements are
permanently lubricated and the bearings are
lubricated by the pumped oil.
Lubrication
The pins of the tipper truck and the ram do not
contain lubricant. Regularly lubricate the hinges
and the grab handles of the side boards as well
as the retaining hooks of the rear board.
Sub-frame and tipper truck
For maximum service life, you are advised to
maintain your tipper truck by regularly washing it
using a power washer.
Carry out any required paint touch-ups quickly to
prevent the spread of rust.
After 8 months of use, check the tightening torque of the connection
between the chassis and the underbody (in
accordance with the manufacturer's
bodybuilding recommendations).
Cleaning the slide valve
► Loosen cap 244A, taking care with the ball
and retrieving it.
►

Using a wide screwdriver
, unscrew the banjo
bolt/piston assembly.
►

Check that the piston slides freely and
remove any foreign bodies. Use a magnet to
remove any metal filings.
►


Refit the assembly and make sure that the
piston slides freely

. Retain the ball with a little
grease on the cap for refitting.
►

Bleed the hydraulic unit.
Bleeding the hydraulic unit
► Unscrew hexagonal cap 257 .
► Loosen internal screw 587
by half a turn,
using a 6 mm hex key.
►

Operate the unit for a few seconds by
pressing the raise button.
The tipper does not rise or rises very slowly

.
When the oil exits through this opening, the unit
is bled.
►

Retighten screw 587

and refit cap 257. Check
that the tipper lowers correctly.
Detailed diagram of the UD2386 hydraulic
unit


Diagnostics
Electrical faults