jacking PEUGEOT BOXER 2021 Owners Manual

121
In the event of a breakdown
8

► Install extended socket A , wheelbrace D and
wheel bar B on the retaining bolt.
►

T
urn the assembly anti-clockwise to lower the
wheel.
►

T
urn to the locking point of the winch,
indicated by the hardening of the manoeuvre and
notch G not visible.
►

After unrolling the cable completely
, take the
spare wheel out.
With steel wheels:


► Unscrew handle H . ►
Remove caliper

I
from the outer part of the
steel wheel.
With alloy wheels:


► Unscrew the three fixing bolts K .
► Unscrew handle H
.
►

Remove bracket J

from caliper I.
►

Remove the spare wheel and place it near
the wheel to be replaced.
►


If possible, place a chock under the wheel
diagonally opposite the wheel to be changed.
3 - Position the jack
Ensure that the jack is stable.
If the ground is slippery or loose, the jack
may collapse - Risk of injury!


Take care to place the jack strictly at jacking point 1 or 2 under the vehicle,
making sure that the jack head is centred at
the contact point on the vehicle. Otherwise,
there is a risk of damage to the vehicle and/or
the jack collapsing.
Make sure that any passengers are safe
(removed, away from the vehicle).
Never put your hands or your head in the
wheel arch.

122
In the event of a breakdown

Never go underneath a vehicle raised
using a jack (use an axle stand).
Do not use:
–

The jack for any other purpose than lifting
the vehicle.
–


A

jack other than the one supplied by the
manufacturer.
The jack must only be used to change a wheel with a damaged or punctured tyre.
The jack does not require any maintenance.
The jack meets European standards, as
defined in the Machinery Directive 2006/42/
CE.
Certain parts of the jack such as the
screw thread or the joints could cause
injury: avoid touching them.
Carefully remove all traces of lubrication
grease.
At the front

► Position jack C at jacking point 1 provided on
the underbody, near the front wheel.
At the rear

The jack must be placed approximately 60 cm from the edge of the rear wheel.


► Position jack C at jacking point 2 in the hole
provided for this purpose.
Special precautions with side door step


If the vehicle is so equipped, make sure to place
the jack at 45° so that it does not interfere with
the door step.