driver seat adjustment PEUGEOT LANDTREK 2023 Owners Manual

31
Ease of use and comfort
3â–º Raise the control bar and slide the seat
forwards or backwards.
â–º

Release the control bar to lock the seat in
position on one of the notches.
Backrest angle

â–º Pull the control all the way up and tilt the
backrest forwards or backwards to adjust it.
Height
(driver only)

â–º Pull the control upwards to raise or push it
downwards to lower , until you obtain the position
required.
Electrically-adjustable seats
Longitudinal

â–º Push the control forwards or backwards to
slide the seat.
Backrest angle

â–º Tilt the control forwards or rearwards.
Cushion height and angle
(driver only)

â–º Tilt the rear of the control upwards or
downwards to obtain the required height and
angle.
Electric lumbar adjustment
(driver only)

â–º Press and hold the front or rear of the
control to increase or reduce the lumbar
support.
2-seat front bench seat
It includes 2 fixed cushions with 2 independent
backrests (adjustable and foldable in the table
position).
The backrest of the seat located next to the
driver, once in the table position, can also be
used as an armrest and has 2 cup/can holders
and a support strap.
For more information on the Seat belts,
refer to the corresponding section. CarM an uals 2 .c o m

58
Safety
Height adjustment



â–º To adjust the height of the anchorage point,
squeeze control A and slide it to the notch
desired.
2-seat front bench seat

If the vehicle is fitted with a front bench seat,
ensure that each seat belt is used with its correct
buckle. Depending on version, the centre seat is fitted
with a lap belt without inertia reel, a three-point
seat belt with inertia reel or has no seat belt.
Do not interchange the driver's seat belt or
buckle with the centre seat belt or buckle
(depending on version).
Rear seat belts



Each of the rear seats has a three-point seat belt
with inertia reel.
The outer seats are fitted, depending on the
version, with a pyrotechnic pretensioning and
force limiting system.
Fastening
â–º Pull the strap, then insert the tongue into the
buckle.
â–º

With a 2-seat front bench seat, pull the strap
of the lap belt to eliminate play (depending on
version).
â–º


Check that the seat belt is fastened correctly
by pulling on the strap.
Unfastening
â–º Press the red button on the buckle.
â–º Guide the seat belt as it is reeled in.
â–º

With a 2-seat front bench seat, fasten the lap
belt so that it does not interfere with the driver
(depending on version).
Seat belt not fastened/
unfastened alerts
A. Front seat belt(s) not fastened/unfastened
warning lamp.
B. Rear seat belt(s) not fastened/unfastened
warning lamps (depending on version).
At speeds above approximately 6 mph (10
km/h),
the warning lamp(s) flash(es) for about 1
minute, accompanied by an audible signal. After CarM an uals 2 .c o m