light Peugeot Partner VU 2001 Owner's Manual

AB
Remote controls
The remote control uses a high-frequency transmitter, which has the following advantages :
- it is not necessary to aim directly at the receiver in the vehicle.
- it operates through all materials (panels, load)
- it has a very long range. Central locking by remote control. The remote control locks and unlocks the doors and tailgate. Press once on but- ton Ato lock, or on button Bto unlock.
If this does not work the first time, press again. Locking or unlocking is confirmed by the direction indicators :- Locking = Indicators light up for approx. two seconds.
- Unlocking = Indicators flash rapidly.
If a door is open or incorrectly closed, the central locking will not operate. I
t is not necessary to keep the button pressed.
If the remote control does not function, reinitialise it. See the paragraph below on ÒChanging the remote control batteriesÓ.
If the remote control is lost or should fail, it is still possible to open the doors using the key.
The remote control key has been designed with a snap-off key. In an accident, the key will snap off to prevent knee injury.Unlocking also switches on the interior lamps.
Electronic engine immobiliser The ELECTRONIC ENGINE IMMOBILISER locks the engine control system. The system is automatically activated when the key is taken out of the ignition.All the keys contain an electronic device.Only your keys can start your vehicle.Insert your key in the ignitionAfter switching on the ignition, a dialogue is established between the key and the
electronic engine immobiliser. If the key is not recognised, starting is not possible.
NOTE : simultaneous use of other high frequency equipment (mobile telephones, domestic alarms
etc.) may interfere with the operation of the remote control. If it entirely ceases to function, it needs to be reinitialised. See ÒChanging the remote control batteryÓ.
* According to specification or country
5I-1KEYS, REMOTE CONTROL *

1
To release the bonnet, pull the red
lever, which is on the door sideunder the dashboard, towardsyou.Place your hand under the bonnet,slightly to the left of the centrepoint. Push latch
1, under the edge of
the bonnet, to the right.Raise the bonnet.Use the bonnet stay to lock the bonnet in position, as shownabove. Closing the bonnet Replace the bonnet stay in its hol- der by pressing it. Lower the bon-net and then allow it to drop shut. Make sure that it has latched
securely.
WARNING : As the bonnet is fit-
ted with sound-proofing it is
heavy, take care when openingand closing.
13I-3OPENING THE BONNET
Bonnet

17I-6SEATS
head restraint Slide to adjust the
height. The headrestsare fitted with a catch.
To remove them fromthe seat, pull fullyupwards, then press therelease catches.
Forwards-backwards Lift the bar on the left-hand side and adjust to the desired position. Handbook pack storage This is above the drawer under the driver's seat. Drawer under driver's seat
To open, raise the drawer slightly and pull it forwards. Heated seats*
(see ÒINSTRUMENTS AND CONTROLSÓ)
* According to specification or country. Backrest angle*
Turn the knurled wheel to adjust the angle of the seat back.

De-activating the passengerÕs airbag *
- With the ignition switched off, insert the key into the switch A.
- Turn the key to the Ò OFFÓ position. The passengerÕs airbag is now de-activated.
- The warning lamp, on the instrument panel, lights up when the ignition is switched on (if it flashes, there is a problem).
To re-activate the passengerÕs airbag
- Do not forget to re-activate the passengerÕs airbag. To do so, with the ignition switched off :
- Insert the key into the switch and turn to the Ò ONÓ position. The passengerÕs
airbag is now re-activated.
- The warning light in the instrument panel lights for six seconds on switching on the ignition.
* According to specification.
19I-8THE AIRBAG SYSTEM*
Never place a rearwards facing child seat on the front passenger seat when the vehicle is fitted with an airbag.
Depending on the vehicleÕs equipment, it may be possible to de-activate the
front passengerÕs airbag (see below).
The wearing of seat belts is compulsory in conjunction with the front airbags.Never deactivate the passenger's airbag when the front passenger is present
(with the exception of the use of a rear- facing child seat).
A

You can adjust the height of the steering wheel.
With the vehicle stationary,firstly adjust your seat to the best position.
Release the steering wheel by pushing the handle forwards.
18I-7ADJUSTING THE STEERING WHEEL
Adjust the steering wheel to the desired height, then lock it in position by pulling the handle fully towards you. Make sure that the instrument panel dials and indicator lights remain clear- ly visible.
IMPORTANT
For safety reasons, these manoeuvres must not be performed while driving.

1Left air vent
2 Left speaker
3 Upper glove box or passenger's airbag
4 Location of radio or glove compartment
5 Controls :
¥ Electric windows
¥ Rear screen /exterior mirror
demister
¥ Air-conditioning
¥ Hazard warning lights
¥ Heated seats
6 Location of radio / CB, car phone
7 Central air vents
8 Controls :
¥ Horn
¥ Headlamps
¥ Direction indicators
¥ Rear fog lamp
9 Instrument panel
10 Controls :
¥ Windscreen wipers
¥ Rear screen wiper
¥ Windscreen wash 11
Right speaker
12 Right air vent
13 Key-operated switch :
¥ Activation/de-activation of
the passengerÕs airbag
14 Controls :
¥ Passenger's side electric mirror
¥ Headlamp angle adjuster
15 Fusebox access flap
16 Ignition lock
17 Driver's airbag
18 Steering wheel adjustment
19 Heating controls
20 Handbrake
21 Ashtray
22 Gear lever
23 Lighter
24 Lower glove box
25 Courtesy light
* According to specification.
25I-13INSTRUMENTS AND CONTROLS *

Display :¥ Digital clock.
¥ Maintenance indicator.
¥ Engine oil level indicator (Diesel).
¥ Total mileage recorder.
26I-14INSTRUMENT PANEL*
Tachometer
Coolant temperature gauge Fuel gauge
Display control : ¥ Total mileage recorder.
¥ Trip mileage recorder
¥ Resetting the trip mileage recorder to zero.
Dashboard lighting rheostat see ÒI-14Ó Changing the time see ÒI-14Ó
* According to model or country

1
11
Maintenance intervals If your vehicle is used in particular- ly harsh conditions, it is necessaryto select the maintenance sche-dules for arduous conditions (seethe Maintenance Guide) whichconsist of more frequent services.Note : if the maximum time bet-
ween two oil changes is reachedbefore the mileage is up, the span-ner symbol lights. To change the maintenanceintervals :
- Switch off the ignition. - Press and hold down button
1.
- Switch on the ignition
- The distance remaining until the next service flashes.
- Release the button immediately.
- The maintenance interval is dis- played.
- Pressing button 1briefly allows
the maintenance intervals to be alternated - When the desired maintenance
interval is displayed, press but-ton 1for ten seconds to validate
(the selected maintenance inter-val will flash for ten seconds).
Release the button to validatewhen the display stops flashing. Resetting the maintenance indi- cator to zero
Your dealer will perform this ope-
ration after each service. However,if you intend to service the vehicleyourself, the procedure for reset-ting the maintenance indicator isas follows:
- Switch off the ignition.- Press and hold down button 1.
- Switch on the ignition.
- The distance remaining until the next service flashes.
- Holdbutton 1down for ten
seconds.
- The display will read Ò=0Óand
the spanner will disappear.
29I-14INSTRUMENT PANEL*
* According to model or country.

1
11
Maintenance intervals If your vehicle is used in particular- ly harsh conditions, it is necessaryto select the maintenance sche-dules for arduous conditions (seethe Maintenance Guide) whichconsist of more frequent services.Note : if the maximum time bet-
ween two oil changes is reachedbefore the mileage is up, the span-ner symbol lights. To change the maintenanceintervals :
- Switch off the ignition. - Press and hold down button
1.
- Switch on the ignition
- The distance remaining until the next service flashes.
- Release the button immediately.
- The maintenance interval is dis- played.
- Pressing button 1briefly allows
the maintenance intervals to be alternated - When the desired maintenance
interval is displayed, press but-ton 1for ten seconds to validate
(the selected maintenance inter-val will flash for ten seconds).
Release the button to validatewhen the display stops flashing. Resetting the maintenance indi- cator to zero
Your dealer will perform this ope-
ration after each service. However,if you intend to service the vehicleyourself, the procedure for reset-ting the maintenance indicator isas follows:
- Switch off the ignition.- Press and hold down button 1.
- Switch on the ignition.
- The distance remaining until the next service flashes.
- Holdbutton 1down for ten
seconds.
- The display will read Ò=0Óand
the spanner will disappear.
29I-14INSTRUMENT PANEL*
* According to model or country.

B
Adjust with theengine running and the sidelamps
on by pressing the control B.
- Press the button successively : the level of lighting
of the instrument panel changes progressively.
- Keep the button pressed down : the level of ligh-
ting of the instrument panel changes rapidly
33I-14INSTRUMENT PANEL*
Dashboard lighting
* According to model or country