remove seats Peugeot RCZ 2014 Owner's Manual

11172
72
FAMILIARISATION
RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
- Insert the tongue A in the buckle
A in the
middle of the rear seat.
- Insert the tongue B in the outer buckle B .
REAR SEAT BELTS FOLDING DOWN THE REAR
BACKREST
1. Release the backrest by pulling the
handle from the boot.
ACCESS TO THE REAR SEATS
1. Releasing the backrest.
2. Tilting the backrest.
AT THE REAR
2. Fold the backrest onto the seat cushion from the passenger compartment.
Press the red button
B then the black button A
to remove the seat belt.
The control giving access to the rear
seats does not release the seat.

RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
LIMIT THE CAUSES OF EXCESS
CONSUMPTION
Spread loads throughout the vehicle; place the heaviest items in the
bottom of the boot, as close as possible to the rear seats.
Limit the loads carried in the vehicle and reduce wind resistance (roof\

bars, roof rack, bicycle carrier, trailer...). Use a roof box in preference.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and refi t your summer tyres.
OBSERVE THE RECOMMENDATIONS ON
MAINTENANCE
Check the tyre pressures regularly, when cold, referring to the label in
the door aperture, driver's side.
Carry out this check in particular:
- before a long journey,
- at each change of season,
- after a long period out of use.
Don't forget the spare wheel and the tyres on any trailer or caravan.
Have your vehicle serviced regularly (engine oil, oil fi lter, air fi lter,
passenger compartment fi lter...) and observe the schedule of
operations recommended in the warranty and maintenance record.
When refuelling, do not continue after the third cut-off of the nozzle to
avoid any overfl ow.
At the wheel of your new vehicle, it is only after the fi rst 1 800 miles
(3 000 kilometres) that you will see the fuel consumption settle down \
to a consistent average.

8/
PRACTICAL INFORMATION
TOOLS AND SPARE WHEEL *
Depending on the country of sale, the vehicle is equipped with the tools\

needed to change a wheel and may also be equipped with a spare
wheel.
The spare wheel is stowed in a protective cover, secured to the boot
fl oor with Velcro
®.
The tools are held in a storage box under the boot fl oor.
Never drive with the rear seat folded when the
spare wheel - or a punctured wheel - is present
in the boot.
Warning marking
"Do not release the backrest of the rear seats!"
* According to country.
Access to the spare wheel *
 Open the boot lid.
 Remove the spare wheel by grasping the grip of its protective cover.
 Position the wheel vertically so as to read the warning markings.
 Remove the Velcro
® located on the tyre tread.
 Detach the straps, located on each sidewall, then slacken them.
 Remove the wheel from its protective cover.
When refi tting the wheel into its cover, place it so that the valve is
opposite the strap fi xings.