tow Peugeot RCZ 2015 User Guide
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2015, Model line: RCZ, Model: Peugeot RCZ 2015Pages: 292, PDF Size: 7.89 MB
Page 76 of 292

74
RCZ_en_Chap03_confort_ed01-2015
The duration of lighting varies, depending on the context:
-
when the ignition is of
f, approximately ten minutes,
-
in energy economy mode, approximately thirty seconds,
-
when the engine is running, no limit.
STORAGE BOX
This has areas for storing a box of spare bulbs, a first aid kit, the temporary puncture repair kit, a warning triangle, the removable ball
of the towbar system...
BOOT LAMPS
Your vehicle is fitted with two boot lamps; one in the right-hand boot side trim and a second in the centre under the rear shelf.
They come on automatically when the boot is opened and switch of f
automatically when the boot is closed.
They cannot be deactivated manually.
A second warning triangle can be stored in the boot lid trim.
For access to it:
F raise
the
floor
using
the
strap,
F
secure it in the vertical position behind the stops, located on
the sides of the boot.
Page 86 of 292

84
RCZ_en_Chap04_visibilite_ed01-2015
WINdSCREEN ANd HEA d LAMP WASH
F Pull the windscreen wiper stalk towards you. The windscreen wash
then the windscreen wipers operate for a fixed period.
The headlamp washers only operate when the dipped or main beam
headlamps are on, with the vehicle moving .
Screenwash/headlamp wash low
In the case of vehicles fitted with headlamp washers, when the minimum level of the reservoir is reached, this warning
lamp and/or the service warning lamp is displayed in the
instrument panel, accompanied by an audible signal and a
message in the screen.
Next
time
you stop, fill the screenwash / headlamp wash fluid reservoir.
The warning lamp is displayed when the ignition is switched on, or
every
time the stalk is operated, until the reservoir is filled.
To
reduce
the
consumption
of
the
fluid
by
the
headlamp
washers,
they operate only with every seventh use of the screenwash or
every 25 miles (40 km) during a given journey
.
Page 89 of 292

87
RCZ_en_Chap05_securite_ed01-2015
DIRECTION INDICATORS
If you forget to cancel the direction indicators for more than
twenty seconds, the volume of the audible signal will increase if
the speed is above 40 mph (60 km/h).
F
Left: lower the lighting stalk passing the point of resistance.
F
Right: raise the lighting stalk passing the point of resistance.
HAZARD WARNING LAMPS
A visual warning by means of the direction indicators to alert other road\
users to a vehicle breakdown, towing or accident.
F Press
this button, the direction indicators flash.
They can operate with the ignition off.
AUTOMATIC OPERA TION OF HAZAR d
W
ARNING LAMPS *
When braking in an emergency, depending on the deceleration, the
hazard warning lamps come on automatically.
They
switch off automatically the first time you accelerate.
F
Y
ou can also switch them off by pressing the button.
Deactivating the DSC/ASR systems also deactivates the automatic
operation of the hazard warning lamps; refer to the "Trajectory control
systems - Deactivation" section.
* Except for the 1.6 THP 270 hp version.
Three flashes of the direction indicators
F Press briefly upwards or downwards, without going beyond the point of resistance; the direction indicators will flash 3 times.
5/
SAFETY
Page 100 of 292

98
RCZ_en_Chap05_securite_ed01-2015
The driver must ensure that passengers use the seat belts
correctly and that they are all restrained securely before setting
off.
Wherever you are seated in the vehicle, always fasten your seat
belt, even for short journeys.
Do not interchange the seat belt buckles as they will not fulfil their
role fully
.
The
seat belts are fitted with an inertia reel permitting automatic
adjustment of the length of the strap to your size.
The seat belt is
stowed automatically when not in use.
Before and after use, ensure that the seat belt is reeled in
correctly.
The lower part of the strap must be positioned as low as possible
on the pelvis.
The upper part must be positioned in the hollow of the shoulder.
The
inertia reels are fitted with an automatic locking device which
comes into operation in the event of a collision, emergency
braking or if the vehicle rolls over
. You can release the device
by
pulling the strap firmly and then releasing it so that it reels in
slightly
.
In order to be effective, a seat belt must:
-
be tightened as close to the body as possible,
-
be pulled in front of you with a smooth movement, checking
that it does not twist,
-
be used to restrain only one person,
-
not bear any trace of cuts or fraying,
-
not be converted or modified to avoid affecting its
performance. In accordance with current safety regulations, for all repairs on your
vehicle's
seat belts, go to a qualified workshop with the skills and
equipment
needed, which a PEUGEOT
dealer is able to provide.
Have your seat belts checked regularly by a PEUGEOT dealer or a
qualified
workshop, particularly if the straps show signs of damage.
Clean the seat belt straps with soapy water or a textile cleaning
product, sold by PEUGEOT dealers.
After folding or moving a seat or rear bench seat, ensure that the
seat belt is positioned and reeled in correctly.
Recommendations for children
Use a suitable child seat if the passenger is less than 12 years old or \
shorter than one and a half metres.
Never use the same seat belt to secure more than one person.
Never allow a child to travel on your lap.
For more information, refer to the "Child seats" section.
In the event of an impact
depending on the nature and seriousness of the impact , the
pretensioning device may be deployed before and independently
of the airbags. Deployment of the pretensioners is accompanied
by a slight discharge of harmless smoke and a noise, due to the
activation of the pyrotechnic cartridge incorporated in the system.
In all cases, the airbag warning lamp comes on.
Following an impact, have the seat belts system checked, and if
necessary
replaced, by a PEUGEOT
dealer or a qualified workshop.
Page 101 of 292

99
RCZ_en_Chap05_securite_ed01-2015
AIRBAGS
The airbags have been designed to contribute towards improving
the safety of the occupants in the event of violent collisions. They
supplement the action of the force-limiting seat belts.
In this case, the electronic detectors record and analyse the front and \
side impacts suffered in the impact detection zones:
-
in the event of a serious impact, the airbags are deployed
instantaneously and contribute towards protecting the occupants of
the
vehicle; immediately after the impact, the airbags deflate rapidly
so that they do not hinder the visibility of the occupants or their
possible exit from the vehicle,
-
in the event of a minor impact or rear impact and in certain roll-over
conditions, the airbags may not be deployed; the seat belt alone
contributes towards providing your protection in these situations.
The airbags do not operate when the ignition is off.
This
equipment only operates once. If a second impact occurs
(during
the same or a subsequent accident), the airbag will not be
deployed again. The deployment of one or more airbags is accompanied by a
slight discharge of smoke and a noise, due to the activation of the
pyrotechnic cartridge incorporated in the system.
This smoke is not harmful, but sensitive individuals may
experience some irritation.
The noise of the detonation related to the deployment of one or
more airbags may result in a slight loss of hearing for a short time.
A.
Front impact zone.
B.
Side impact zone.
Impact detection zones
5/
SAFETY
Page 103 of 292

101
RCZ_en_Chap05_securite_ed01-2015
Reactivation
When you remove the child seat, turn the switch to the "ON" position to
reactivate the airbag and so assure the safety of your front passenger i\
n
the event of an impact.
With the ignition on, this warning lamp comes on in the seat
belt and passenger's front airbag warning lamps display for
approximately one minute, if the passenger's front airbag is
activated.
Operating fault
If this warning lamp comes on in the instrument panel,
accompanied by an audible warning and a message in the
screen, contact a PEUGEOT
dealer or a qualified workshop
to have the system checked.
The airbags may no longer be
deployed in the event of a serious impact.
LATERAL AIRBAGS
System which protects the driver and front passenger in the event of a
violent side impact in order to limit the risks of injury to the pelvis,\
chest
and head*.
The lateral airbags are installed on the outer side of the seat:
-
one part in the front seat frame (chest-pelvis airbag),
-
one part in the front head restraint* (head airbag).
deployment
It is deployed unilaterally in the event of a violent impact applied to \
all or part of the side impact zone B, operating at right angles to the
longitudinal axis of the vehicle in a horizontal plane and from the
exterior of the vehicle towards the interior.
The lateral airbag comes between the front occupant of the vehicle and
the corresponding door trim panel.
* Except for the 1.6 THP 270 hp version.
5/
SAFETY
Page 126 of 292

3
3
124
RCZ_en_Chap06_conduite_ed01-2015
AUTOMATIC OPERATION
F Select position d for automatic changing of the six gears.
Never select position N while the vehicle is moving.
Never select positions P or R unless the vehicle is completely
stationary.
The gearbox then operates in auto-adaptive mode, without any
intervention on the part of the driver. It continuously selects the most
suitable
gear according to the style of driving, the profile of the road and
the load in the vehicle.
d
and the gears selected automatically appear in succession in the
instrument panel.
For maximum acceleration without touching the selector, press the
accelerator pedal down fully (kick down). The gearbox changes down
automatically or maintains the gear selected until the maximum engine
speed is reached.
On braking, the gearbox changes down automatically to provide
efficient
engine braking.
If you release the accelerator sharply, the gearbox will not change to a
higher gear for safety reasons.
SPORT AN d SNOW PROGRAMMES
These two special programmes supplement the automatic operation in
very
specific conditions of use.
Sport programme "S"
F Press button "S", after starting the engine.
The gearbox automatically favours a dynamic style of driving.
S appears in the instrument panel.
Snow programme "T"
F Press button " T", after starting the engine.
The gearbox adapts to driving on slippery roads.
This programme improves starting and drive when traction is poor.
T appears in the instrument panel.
RETURN TO AUT OMATIC OPERA TION
F At any time, press the button selected again to quit the programme engaged and return to auto-adaptive mode.
MANUAL OPERATION
F Select position M for sequential changing of the six gears.
F
Push the selector towards the +
sign to change up a gear.
F
Pull the selector towards the -
sign to change down a gear.
Page 139 of 292

137
RCZ_en_Chap06_conduite_ed01-2015
deactivation / Activation of the rear parking sensors
The function is deactivated or activated via the vehicle configuration menu.
The status of the function is stored when the ignition is switched off.
OPERATING FAULT
In the event of a malfunction of the system, when reverse gear
is engaged this warning lamp is displayed in the instrument
panel and/or a message appears in the screen, accompanied
by an audible signal (short beep).
Contact
a PEUGEOT
dealer or a qualified workshop.
In bad weather or in winter, ensure that the sensors are not
covered with mud, ice or snow. When reverse gear is engaged, an
audible signal (long beep) indicates that the sensors may be dirty.
Certain sound sources (motorcycle, lorry, pneumatic drill, etc.)
may trigger the audible signals of the parking sensor system.
The function will be deactivated automatically if a trailer is being
towed
or
a
bicycle
carrier
is
fitted
(vehicle
fitted
with
a
towbar
or
bicycle carrier recommended by PEUGEOT).
6/
DRIVING
Page 140 of 292

138
RCZ_en_Chap07_verifications_ed01-2015
PEUGEOT & TOTAL,
A PARTNERSHIP TO DELIVER
B
ETTER
PERFORMANCE
!
Innovation, the key to success
The TOTAL Research and Development and
PEUGEOT teams work together to develop high
quality
l
ubricants
t
hat
m
eet
t
he
r
equirements
o
f
P
EUGEOT vehicles. For you, this is the assurance
that the performance of your engine is optimised
while also ensuring its durability.
The 208 HYbrid FE demonstrates the ability of
PEUGEOT and TOTAL to develop innovative
technologies and provide other ways of moving
towards the future.
208 HYbrid FE, a technology demonstrator with exceptional characteristics: 1.9 l/100 km
(148.7 mpg) and 0 to 100 km/h (0 to 62 mph) in 8 seconds.
Reduced exhaust emissions,
a true reality
TOTAL lubricants are formulated to optimise the
efficiency of engines and the protection of the
emissions post-treatment systems. It is important
to observe the servicing recommendations made
by PEUGEOT to assure correct operation.
RECOMMENdS
Page 141 of 292

139
RCZ_en_Chap07_verifications_ed01-2015
FUEL TANK
Fuel tank capacity: approximately 55 litres.
LOW FUEL LEVEL
R
EFUELLING
When the fuel tank minimum level is reached this warning
lamp comes on on the instrument panel, accompanied by an
audible signal and an alert message. When it first comes on
there remains approximately 5 litres
of fuel in the tank.
Until
sufficient fuel is added, this warning lamp appears every time
the ignition is switched on, accompanied by an audible signal and a
message. When driving, this audible signal and display of the alert
message
are repeated with increasing frequency as the fuel level drops
towards
"0".
Refuel as soon as possible to avoid running out of fuel.
If you run out of fuel (Diesel), refer also to the "Running out of fue\
l
(Diesel)" section.
A
label
affixed to the inside of the flap reminds you of the type of fuel to
be used depending on your engine.
Additions of fuel must be of at least 5 litres, in order to be registere\
d by
the fuel gauge. T
o fill the tank in complete safety:
F the engine must be switched off,
F
press the rear part of the flap, then raise it to open it,
F
turn the cap to the left,
F
remove the cap and hook it onto the clip located on the inside of the
flap,
F
fill the tank, but do not continue after the 3rd cut-off of the
pump; this could cause malfunctions.
Opening
the filler cap may create a noise a caused by an inrush
of air
. This vacuum is entirely normal, resulting from the sealing of
the fuel system.
7/
CHECKS