steering Peugeot RCZ 2015 Owner's Guide

181
RCZ_en_Chap08_info-pratiques_ed01-2015
ENGINE COMPARTMENT FUSES
The fusebox is placed in the engine compartment near the battery
(left-hand side).
Access to the fuses
F Unclip the cover.
F
Change the fuse (see corresponding paragraph).
F

When you have finished, close the cover carefully to assure the
sealing of the fusebox.
Fuse table
Fuse N° RatingFunctions
F2 15 AHorn.
F3 10 AFront wash-wipe.
F4 20 ADaytime running lamps.
F5 15 AAir
flow sensor, coolant pump, oil pump,
thermostat, blow-by heater (petrol),
by-pass and EGR electrovalves (Diesel),
diesel heater (Diesel).
F6 10 ASteering wheel angle sensor

, ABS/DSC
control unit, DSC sensor.
F7 10 APower steering control unit, automatic
gearbox, dual function brake switch.
F8 25 AStarter motor control.
F9 10 ADiagnostic socket, directional
headlamps,
particle emission filter pump
(Diesel).
F

11 40 AAir conditioning blower.
8/
PRACTICAL INFORMATION

184
RCZ_en_Chap08_info-pratiques_ed01-2015
TOWING A VEHICLE
TOWING EYE
This is stored in the boot under the floor.
For access to it:
F

open the boot,
F

raise the floor using the strap,
F

secure it in the vertical position beyond the stops, located on the
sides of the boot,
F


remove the towing eye from the storage box.
GENERAL RECOMMEN d ATIONS
Observe the legislation in force in your country.
Ensure that the weight of the towing vehicle is higher than that of
the towed vehicle.
The driver must remain at the wheel of the towed vehicle and
must have a valid driving licence.
When towing a vehicle with all four wheels on the ground, always
use an approved towing arm; rope and straps are prohibited.
The towing vehicle must move off gently.
When towing a vehicle with the engine off, there is no longer any
power assistance for braking or steering.
In the following cases, you must always call on a professional
recovery service:
-

vehicle broken down on a motorway or fast road,
-


four-wheel drive vehicle,
-


when it is not possible to put the gearbox into neutral, unlock
the steering, or release the parking brake,
-


towing with only two wheels on the ground,
-


where there is no approved towing arm available...

185
RCZ_en_Chap08_info-pratiques_ed01-2015
TOWING YOUR VEHICLE
Towing from the front
F On the front bumper , unclip the cover by pressing on the left.
F
Screw the towing eye in fully
.
F

Install the towing arm.
F


Place the gear lever in neutral (position N

for an automatic
gearbox).
Failure to follow this advice could result in damage to certain
components (braking, transmission...) and the absence of
braking assistance the next time the engine is started.
F


Unlock the steering by turning the ignition key one notch and
release the parking brake.
F


Switch on the hazard warning lamps on both vehicles.
F


Move of
f gently and drive slowly and for a short distance only.
Towing from the rear
It is also possible to pull your vehicle from the rear, but only in
exceptional circumstances (vehicle in a parking space, off the road...).
F
On the rear bumper
, unclip the cover by pressing on the left.
F

Screw the towing eye in fully
.
F

Install the towing bar
.
F

Place the gear lever in neutral (position N

for an automatic
gearbox).
F

Switch on the hazard warning lamps on both vehicles.
F


Move of
f very gently to pull the vehicle out.
* Except version with symmetrical twin exhaust tailpipes.
TOWING ANOTHER VEHICLE *
F On the rear bumper, unclip the cover by pressing on the left.
F
Screw the towing eye in fully
.
F

Install the towing bar
.
F

Switch on the hazard warning lamps on both vehicles.
F


Move of
f gently and drive slowly and for a short distance only.
8/
PRACTICAL INFORMATION

190
RCZ_en_Chap08_info-pratiques_ed01-2015
ACCESSORIES
A wide range of accessories and genuine parts is available from the
PEUGEOT dealer network.
These accessories and parts are all suitable for your vehicle and benefit
from PEUGEOT's recommendation and warranty

.
"Comfort":
front parking sensors, cool box...
"Transport solutions":
boot tray, boot spacers, towbar bicycle carrier, towbar with quickly detachable ball, towbar harnesses...
"Style":
leather and alcantara sport steering wheel, alcantara gear lever gaiter,
alloy wheels, door mirror shells in carbon fibre...
"Safety and security":
anti-theft alarm, window etching, wheel security bolts, breathalyser, first aid kit, fire extinguisher, warning triangle, high visibility jacket, booster
cushions and child seats, stolen vehicle tracking system, snow chains,
anti-skid tyre covers...
"Protection":
boot liner, mats*, bumper protective strips, vehicle protective cover...
*

T
o avoid any risk of jamming of the pedals:
-

ensure that the mat is positioned and secured correctly
,
- never
fit one mat on top of another.
When

fitting

a

trailer

towbar

and

its

harness

outside

the

PEUGEOT

dealer network, this must be done following the
manufacturer's recommendations.

203
RCZ_en_Chap10b_RT6-2-8_ed01-2015
The system is protected in such a way that it will only
operate in your vehicle.
PEUGEOT Connect Navigation (RT6)
01 First steps - Control panel
For safety reasons, the driver must only carry out
operations
which require prolonged attention while the
vehicle is stationary

.
When the engine is switched off and to prevent
discharging of the battery, the system switches off
following the activation of the energy economy mode.
CONTENTS
02

Steering mounted
controls
03

General operation
04


Navigation
- Guidance
05

T
raffic information
06

Using
the telephone
07
Radio
08

Music media players
09


Audio
settings
10
Configuration
11

Screen menu
map p.
p.
p.
p.
p.
p.
p.
p.
p.
p.
p. 204
206
207
209
222
225
235
240
246
247
248
GPS navigation system
Multimedia audio system
Bluetooth
® telephone
Frequently asked questions p. 252

02
206
RCZ_en_Chap10b_RT6-2-8_ed01-2015
RADIO: select the previous/next preset
station.
Select the next entry in the address book.SRC/TEL button:
change the audio source,
start a call from the address book,
call/end call on the telephone,
press for more than 2 seconds: access
to the address book.
RADIO: change to the previous radio
station in the list.
Long press: automatic search for a
lower frequency.
CD: select the previous track.
CD: continuous press: fast reverse.
RADIO: change to the next radio station in the list.
Long
press: automatic search for a higher frequency.
CD: select the next track.
CD: continuous press: fast forward play.
Volume increase.
Volume decrease.Mute: press the volume
increase and decrease
buttons simultaneously.
Restore the sound by
pressing one of the
two volume buttons.
STEERING MOUNTEd CONTROLS

06
230
RCZ_en_Chap10b_RT6-2-8_ed01-2015
USING THE TELEPHONE
Press PHONE twice.
Select "d ial" then confirm. Select "
d irectory of contacts" then
confirm.
Dial the telephone number using the
virtual keypad selecting each number
in turn.
Confirm
"OK" to make the call. Press TEL or twice on PHONE.
Calling a new number
Calling a contact
Select the desired contact and confirm.
If access was via the PHONE button,
select "Call"
and confirm.
Select
the number and confirm to start
the call.
Making a callUse of the telephone is not recommended while driving. We recommended
that you park safely or make use of the steering mounted controls.

06
231
RCZ_en_Chap10b_RT6-2-8_ed01-2015
USING THE TELEPHONE
Calling a recently entered numberPress TEL, select "Call list" and
confirm,
Select
the desired number and confirm.
To erase the calls log, press PHONE twice, select "Phone
functions"
and confirm then select " d elete calls log" and confirm.
Ending a call
Press PHONE then select "OK" to end
the call.
Or make a long press on TEL at the
steering mounted controls.
Or make two short presses on TEL at
the steering mounted controls.
Or press the MOd E button, as many
times as necessary, until the telephone
screen is displayed.
Press PHONE to display the calls log. or
Press "OK" to display the contextual
menu then select "Hang up"

and

confirm.
It is always possible to start a call directly from the telephone; park \
the vehicle as a safety measure.

07
236
RCZ_en_Chap10b_RT6-2-8_ed01-2015
By alphabetical list
Press RAd IO, select the station of your
choice
and confirm.
By automatic frequency search
Press 7 or 8 for the automatic search
for
a lower or higher radio frequency.
Or turn the thumb wheel at the steering
mounted controls.
By manual frequency search
Press 5 or 6 to adjust the radio
frequency
step by step.
Selecting a station
The external environment (hill, building, tunnel, underground car park.\
..) may interfere with the reception, including in RDS station tracking mode.
This phenomenon is a normal result of the way in which radio waves are transm\
itted and does not in any way indicate a fault with the audio system.
The
quality of reception is represented by the number of
active waves in this symbol.
Press

RA d IO or OK to display the
contextual menu.
Changing waveband
Select "Change waveband".
Select "FM /
d AB / AM" and confirm.
RAdIO

07
237
RCZ_en_Chap10b_RT6-2-8_ed01-2015
Press the button on the numerical keypad to recall a
preset station.
Or press then turn the thumb wheel at the steering
mounted controls.
Presetting a station
After selecting a station, press one of the buttons on the
numerical keypad for 2 seconds to preset the current
station.
An audible signal confirms that the station has been preset.
Press RAdIO.
Activate / deactivate R d S
RDS, if activated, allows you to continue listening to the same
station
by automatic retuning to alternative frequencies. However,
in certain conditions, coverage of an RDS station may not be
assured throughout the entire country as radio stations do not
cover 100 % of the territory

. This explains the loss of reception of
the station during a journey.
Select "Guidance options " then
confirm.
Activate or deactivate "R
d S" then
confirm.
RAdIO