ignition Peugeot RCZ 2015 Owner's Manual

6
RCZ_en_Chap00b_vue-ensemble_ed01-2015
Instrument panels 12-13
W arning lamps 14-20
Indicators
21-24
Buttons
25-26
-

Check / service indicator / trip distance
recorder
-


lighting dimmer
Headlamp height adjustment


81
Door mirrors


55-56
Electric windows


44-45
Dashboard fuses


177-180
Opening the bonnet


141Courtesy lamps

64
Seat belt / passenger's front airbag warning lamps display
96-97
Rear view mirror

57
Sun visor


68
Parking brake


1
19
Active spoiler control

93-94Ignition switch / Steering lock / Starting


1
16-118
Multifunction screens

30-36
Clock


26
P

EUGEOT
Connect Navigation (R
T6)
2
03-258
P
EUGEOT
Connect Sound (RD5)

259-278
V

entilation 59-60
Dual zone digital air conditioning

61-63
Automatic gearbox


122-125
Manual gearbox


121
Gear shift indicator


126
Hill start assist


120
INSTRUMENTS AND CONTROLS

13
RCZ_en_Chap01_controle-de-marche_ed01-2015
dISPLAYS
* According to engine.
** Only with the large central display screen.
Small display screen
A. Trip distance recorder.
(miles or km)
B.

d
istance recorder.
(miles or km)
C.


Service spanner
, if a service is due shortly or is overdue.
Central display screen
d. Speed limiter
(mph or km/h) or



Cruise control.
E.


Indication of:
-


a gear change*,



or
-

the programme or gear (automatic gearbox).
F

.
Engine oil level indicator
,
service indicator

.
(miles or km)
These two functions are displayed when the ignition is switched on,
then disappear after a few seconds.



W
arning and status indicator lamps / CHECK.


T
rip computer.


Alert messages**.



V
ehicle speed repeat**.


Navigation - Guidance**.
These functions are displayed according to the selection.
1/
MONITORING

14
RCZ_en_Chap01_controle-de-marche_ed01-2015
WARNING AN d IN d ICATOR LAMPS
Visual indicators which inform the driver of the occurrence of a
fault (warning lamp) or of the operation of a system (operation or
deactivation indicator lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when the ignition is
switched on.
When the engine is started, these warning lamps should go off.
If they remain on, before moving off, refer to the information for the
warning lamp concerned.
Associated warnings
The illumination, fixed or flashing, of certain warning lamps may be accompanied by an audible signal and a message in the screen.
Depending on your version of instrument panel, illumination of the
warning lamp is also accompanied by:
-

a symbol in the central instrument panel screen and a message in
the multi-function screen,


or
-

a symbol and a message in the central instrument panel screen.
Warning lamps
When the engine is running or the vehicle is being driven, the
illumination of one of the following warning lamps indicates a fault whi\
ch
requires action on the part of the driver.
The illumination of a warning lamp is always accompanied by the
display of an additional message, to assist you in identifying the
fault.
If you encounter any problems, contact a PEUGEOT dealer or a
qualified
workshop.

15
RCZ_en_Chap01_controle-de-marche_ed01-2015
Warning/indicator lamp is on CauseAction / Observations
STOP fixed,
alone
or associated
with another
warning lamp,
accompanied by
an audible signal
and a message
in the screen.Illumination of this warning lamp
is associated with a serious fault
with the braking system, power
steering, engine lubrication
system or cooling system.
Stop as soon as it is safe to do so as there is a risk that the
engine will cut out while driving.
Park, switch of

f the ignition and contact a PEUGEOT
dealer
or a qualified workshop.
Maximum
coolant
temperature fixed
with the
needle in the red
zone.The temperature of the cooling
system is too high. Stop as soon as it is safe to do so.
W

ait until the engine has cooled down before topping up
the level, if necessary.
If the problem persists, contact a PEUGEOT dealer or a
qualified
workshop.
Braking
fixed,
associated
with the ST

OP
warning lamp. The
braking system fluid level is
too low

.You must stop as soon as it is safe to do so.
Top
up with brake fluid recommended by PEUGEOT.
If the problem persists, have the system checked by a
PEUGEOT


dealer or a qualified workshop.
+ fixed,
associated
with the ST

OP
and ABS warning
lamps. The electronic brake force
distribution (EBFD) system has
a fault.
You must stop as soon as it is safe to do so.
Have
it checked by a PEUGEOT

dealer or a qualified
workshop.
1/
MONITORING

16
RCZ_en_Chap01_controle-de-marche_ed01-2015
Engine
autodiagnosis
systemflashing.
The engine management system
has a fault. Risk of destruction of the catalytic converter.
Have
it checked by a PEUGEOT dealer or a qualified workshop.
fixed. The emission control system has
a fault. The warning lamp should go of
f when the engine is started.
If
it does not go off, contact a PEUGEOT

dealer or qualified
workshop without delay

.
Low fuel level fixed
with the
needle in the
red zone,
accompanied by
an audible signal
and a message.When

it first comes on there
remains approximately 5 litres

of
fuel in the tank.
At this point, you begin to use the
fuel reserve. Refuel as soon as possible to avoid running out of fuel.
Until
sufficient fuel has been added, this warning lamp
will come on every time the ignition is switched on,
accompanied by an audible signal and a message.
The audible signal and message are repeated with
increasing

frequency as the fuel level drops towards
"0"
.
Fuel tank capacity: approximately 55 litres.
Never continue to drive until you run out of fuel, as this
could damage the emission control and injection systems.
Warning/indicator
lamp is on CauseAction / Observations
Service on temporarily.
A minor fault has occurred for
which there is no specific warning
lamp.
Identify the fault by reading the message shown in the
screen, such as, for example:
-

opening of the doors, boot or bonnet,
-

low engine oil level,
-

low screenwash level,
-
flat remote control battery,
- saturation of the particle emission filter (Diesel)
As soon as traffic conditions permit, regenerate the
filter

by driving at a speed of at least 36 mph (60 km/h)
until the service warning lamp goes of

f.
- a fault with the tyre under-inflation detection system,
- ...
For any other faults, contact a PEUGEOT dealer or a
qualified workshop.
fixed. A major fault has occurred for
which there is no specific warning
lamp.
Identify the fault by reading the message shown on the
screen
and contact a PEUGEOT

dealer or a qualified
workshop.

19
RCZ_en_Chap01_controle-de-marche_ed01-2015
Warning/indicator lamp is on CauseAction / Observations
Rear foglamp fixed.The rear foglamp has been
switched on using the ring on the
lighting control stalk. Turn the ring on the lighting control stalk to the rear to
switch off the rear foglamp.
d

iesel engine
pre-heating fixed.The key is at position 2
(ignition on) in the ignition switch. Wait until the warning lamp goes off before starting.
The period of illumination of the warning lamp is
determined by the ambient conditions (up to about thirty
seconds in very low temperatures).
If the engine does not start, switch the ignition off and then
on, wait until the warning lamp goes off again, then start
the engine.
Parking brake fixed.The parking brake is applied or
not properly released. Release the parking brake to switch off the warning lamp,
keeping your foot on the brake pedal.
Observe the safety recommendations.
For more information on the parking brake, refer to the
corresponding section.
Passenger's
front airbag fixed
on the
seat belt and
passenger's front
airbag warning
lamps display

.The control switch, located on
the passenger's side of the
dashboard, has been placed in
the "ON" position.
The passenger's front airbag is
activated.
In this case, do not install
a
"rearward facing" child seat. While
you do not have a rearward facing child seat fitted
to the front passenger seat, it is recommended that the
passenger's front airbag be activated.
On

the other hand, before fitting a rearward facing child
seat, you must turn the control switch to the

"OFF"
position.
1/
MONITORING

21
RCZ_en_Chap01_controle-de-marche_ed01-2015
COOLANT TEMPERATURE IN d ICATOR
With the engine running, when the needle is:
-

in zone
A, the temperature is correct,
-

in zone
B, the temperature is too high; the maximum temperature
warning lamp and the central STOP warning lamp come on,
accompanied by an audible signal and the display of an alert
message.
You MUST stop as soon as it is safe to do so.
Wait a few minutes before switching off the engine.
Contact
a PEUGEOT

dealer or a qualified workshop.
ENGINE OIL LEVEL IN d ICATOR
This information is displayed for a few seconds when the ignition is
switched on, at the same time as the service information.
The check of this level is only valid if the vehicle is on a level
surface, with the engine having been off for more than 30 minutes.
After driving for a few minutes, the temperature and pressure in the
cooling system increase.
To top up the level:
F

wait for the engine to cool,
F

unscrew the cap by two turns to allow the pressure to drop,
F

when the pressure has dropped, remove the cap,
F

top up the level to the "MA
x " mark.
1/
MONITORING

23
RCZ_en_Chap01_controle-de-marche_ed01-2015
SERVICE INdICATOR
This information is displayed for a few seconds when the ignition is
switched on. It informs the driver when the next service is due, in
accordance with the manufacturer's service schedule.
The point at which the service is due is calculated from the last indica\
tor
zero reset. It is determined by two parameters:
-
the distance travelled,
-


the time elapsed since the last service (only on HDi Diesel
versions).
More than 1 800 miles (3 000 km) remain before the next service is due\
When the ignition is switched on, no service information appears on the \
instrument panel central screen.
Between 600 miles (1 000 km) and 1 800 miles (3 000 km)
remain before the next service is due
For a few seconds after the ignition is switched on, the spanner
symbolising the service operations comes on. The instrument panel central
screen indicates the distance remaining before the next service is due.
Example: 1 700 miles (2 800 km) remain before the next service is due.
For a few seconds after the ignition is switched on, the central screen
indicates:
Less than 600 miles (1 000 km) remain before the next service is due
Example: 500 miles (900 km) remain before the next service is due.
For a few seconds after the ignition is switched on, the central screen \
indicates:
The spanner remains on in the small screen
to indicate that a service must be carried out
soon.
1/
MONITORING

24
RCZ_en_Chap01_controle-de-marche_ed01-2015
Service overdue
For a few seconds after the ignition is switched on, the spanner
flashes to indicate that the service must be carried out as soon as
possible.
Example: the service is overdue by 300 miles (300
km).
For a few seconds after the ignition is switched on, the central screen \
indicates:
The spanner remains on in the small screen
to indicate that a service should have been
carried out.
The distance remaining may be weighted by the time factor,
depending on the type of motoring the vehicle is used for.
Therefore, the spanner may also come on if you have exceeded
the
period since the last service specified in the manufacturer's
service schedule.
This indication applies only to HDi Diesel engines.
Service indicator reset
Retrieving the service information
You can access the service information at any time.
This information appears when running through the manual check
procedure.
F Briefly press the "CHECK/000" button.
The service information is displayed for a few seconds on the
instrument panel central screen, then disappears.
Following this operation, if you wish to disconnect the battery

,
lock the vehicle and wait at least five minutes for the reset to be
registered.
After each service, the service indicator must be reset.
If you have carried out the service on your vehicle yourself:
F

switch of
f the ignition,
F
press and hold the
"CHECK/000" button,
F

switch on the ignition; the distance recorder display begins a
countdown,
F

when the instrument panel central screen indicates
"=0"
, release
the button; the spanner disappears from the small screen.

25
RCZ_en_Chap01_controle-de-marche_ed01-2015
MANUAL CHECK
This function allows you to check the status of the vehicle (reminder o\
f
the active alert warnings) and the service information.
F With
the engine running, to start a manual check, briefly press the
"CHECK/000" button on the instrument panel.
If no faults have been detected,

"CHECK OK" appears in the
instrument panel central screen.
If a "minor" fault has been detected, the warning lamp concerned then
"CHECK OK" appear in the instrument panel central screen. Contact a
PEUGEOT


or a qualified workshop.
If a "major" fault has been detected, only the warning lamps concerned
appear in the instrument panel central screen. Have it checked by a
PEUGEOT


dealer or a qualified workshop.
dISTANCE RECORdERS
The total and trip distances are displayed for thirty seconds when the
ignition is switched off, when the driver's door is opened and when the
vehicle is locked or unlocked.
Measures the total distance travelled by the vehicle since its first
registration.
Total distance recorder
F With the ignition on, press and hold this button until zeros appear .
Trip distance recorder
Measures the distance travelled since it was last reset to zero by the
driver.
1/
MONITORING