charging RENAULT CLIO 2009 X85 / 3.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine
1.68
ENG_UD13453_3Ordinateur de bord (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
TRIP COMPUTER AND WARNING SYSTEM (10/10)
Warning messages
These appear with the ® warning light and require you to stop immediately, for your own safety, as soon as traffic conditions allow. Stop your engine and do not restart it. Contact an approved Dealer.Examples of warning messages are given in the following pages. Note: the messages appear on the display either individually or alternately (when there are several messages to be displayed), and \
may be accompanied by a warning light and/or a beep.
Examples of messagesInterpretation of messages
‘Injection fault’Indicates that the vehicle has a serious engine fault.
‘Engine overheating’Indicates that the engine is overheating.
‘Battery recharging fault’Indicates a fault with the battery charging circuit.
‘Steering fault’Indicates a fault in the vehicle’s power assisted steering.
‘Gearbox overheating’Indicates that the gearbox is overheating.
‘Braking fault’Indicates a fault in the braking circuit.
‘Oil pressure fault’Indicates an oil pressure fault.

Downloaded from www.Manualslib.com manuals search engine
battery...................................................(up to the end of the DU)
5.27
ENG_UD12592_2Batterie : dépannage (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_5
To avoid all risk of sparks:
– ensure that any consumers are switched off before disconnecting or reconnecting the battery;
– when charging, stop the charger
before connecting or disconnecting the battery;
– to avoid creating a short circuit be
- tween the terminals, do not place metal objects on the battery;
– always wait at least one minute after

the engine has been switched off before disconnecting a battery;
– make sure that you reconnect the
battery terminals after refitting.
Battery
Refitting the battery covers
– position cover C in its hinges and clip it in place;
– then position cover
B in its hinges and clip it in place;
Check that the two covers
B and C are correctly locked.
Depending on the vehicle, reposition block A, clipping first the rear, then the front. Ensure it is correctly locked in place.
Access to the battery
Depending on the vehicle, press tab 1
and tilt block A backwards to unclip it.
Unclip cover
B and remove it, then
unclip cover C and remove it.
BATTERY: troubleshooting (1/4)
AB
C
1
The engine may be hot during operations in close proximity. In addition, the engine cooling fan may
start at any moment.
Risk of injury.