traction control RENAULT KANGOO 1997 KC / 1.G Chassis Workshop Manual

REAR AXLE
Bearing
SPECIAL TOOLING REQUIRED
Emb. 880 Inertia extraction tool
Rou. 943 Hub plug extractor
TIGHTENING TORQUES (in daN.m)
CHECKING
Check the end float using a dial gauge mounted
on the drum : 0 to 0.03 mm maximum.
REMOVAL
Remove:
- the hub plug using tools Rou. 943 + Emb. 880,
- the brake drum (see corresponding
paragraph).
From the drum, remove:
- the bearing retaining clip,
- the bearing using a tube.
Hub nut 17.5
Wheel bolts 9
33
REFITTING
Using a tube and a press, fit the bearing until it
touches the shoulder.
Fit:
-a new clip,
- the drum on the pre-lubricated stub axle,
-a new lock nut and tighten to the correct
torque,
- the hub plug.
Adjust:
- the brake shoes by repeatedly pressing the
brake pedal,
- the handbrake (see section 37 "Controls").
33-7