steering RENAULT KANGOO 1997 KC / 1.G Foult Finding - Injection User Guide

1EC761.0
AIRBAG - SEAT BELT PRETENSIONERS
Fault finding - Interpretation of XR25 bargraphs
Bargraph 5 right hand side illuminated Fiche n° 49
Insulation of driver’s airbag line
XR25 aid :*25 : CC.1 : Short circuit at 12 volts
CC.0 : Short circuit to earth
5
Never carry out measurements on the trigger lines with equipment other than the
XRBAG.NOTES
Lock the computer using command G80* on the XR25.
Switch off the ignition and remove the two mounting bolts of the steering wheel cushion .
Check the condition of the trigger wire.
The XRBAG tool MUST be use for measuring insulation appropriate to the type of fault at point C2 of the
driver’s airbag circuit .
If the value obtained is not correct , replace the rotary switch under the steering wheel .
Reconnect the rotary switch under the steering wheel , disconnect the computer connector and fit the 30
track adaptor.
The XRBAG tool MUST be used for measuring insulation appropriate to the type of fault on the wire
marked B on the adaptor.
If the value obtained is not correct , check the 30 track connector connection (tracks 10 and 11) and
replace the wiring if necessary.
If the checks carried out have not proven the existence of a fault, replace the airbag computer (consult
the section "Aid" for this operation).
Reconnect the driver’s airbag ignition module and remount the steering wheel cushion.
Erase the computer memory using the command G0** then switch off the ignition.
Carry out another XR25 check and if there is no fault, unlock the computer using
command G81*.
Destroy the airbag cushion if it has been replaced (tool Elé. 1287).
AFTER REPAIR
88
88-11