brake pads RENAULT KANGOO 1997 KC / 1.G Transmission Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 1997, Model line: KANGOO, Model: RENAULT KANGOO 1997 KC / 1.GPages: 22, PDF Size: 0.17 MB
Page 18 of 22
DRIVESHAFTS
Front driveshafts
REFITTING
Left side :
Fit the driveshaft as horizontally as possible.
Right side :
Coat the splines of the joint on the gearbox side
with
MOLYKOTE BR2 grease.
Fit the driveshaft and check its positioning : an-
gled pin B. Vi. 31-01.
Fit two new roll pins : B. Vi. 31-01. Seal the roll pin
holes using
RHODORSEAL 5661.
On both sides :
Fit the driveshaft stub axle into the hub, it should
go in easily.
Refitting is the reverse of removal. Observe the
tightening torques.
Top up the gearbox oil.
Press the brake pedal several times in order to
bring the piston into contact with the pads.
29
REMOVAL
Vehicle on a two post lift.
Drain the gearbox.
Remove :
- the brake assembly (suspend it from the
chassis),
- the driveshaft nut : tool Rou. 604-01.
Left side :
Remove the three bolts on the gearbox.
Right side :
Remove the roll pin : tool B. Vi. 31-01.
On both sides :
Remove :
- The track rod end nut and extract the shaft :
tool T. Av. 476,
- the upper bolt of the shock absorber base.
Push back the driveshaft : tool T. Av. 1050-02.
Remove the lower bolt of the shock absorber
base and extract the driveshaft.
99544R
SPECIAL TOOLING REQUIRED
B. Vi. 31-01Roll pin punch
Rou. 604-01Hub locking tool
T. Av. 476Ball joint extractor
T. Av. 1050-02Driveshaft extractor
Driveshaft nut 28
Mounting bolt of gaiter on gearbox. 2.5
Wheel bolts 9
Shock absorber base nuts 18
Brake caliper mounting bolts 10
Track rod end nut 3.7
TIGHTENING TORQUES (in daN.m)
29-2