dashboard RENAULT KANGOO 2013 X61 / 2.G Mechanism And Accessories Workshop Manual

NON-SIDE OPENING ELEMENT
MECHANISMS
Exterior handle for rear door
Rear screen wiper motor
Rear door lock
Rear door latches
Exterior handle for tailgate
Hinged rear roof flap cross member51-1
51-2
51-3
51-4
51-5
51-6
51-7
51-8
51-9
51-10
51-12 Pages
Contents
Safety
Tooling
SIDE OPENING ELEMENT
MECHANISMS
Window winder handle on front
door
Door opening handle - interior,
front door
Door opening handle - exterior,
front door
Front door lock
Front door window riser
Door barrels
Interior handle for opening the
sliding door
Exterior handle for sliding door
Locking warning light and sliding
door lock
Sliding door runners
Adjusting the sliding doorWINDOWS
Tilting or fixed windows in sliding
door
Fixed or moving side window
Window in rear door and window in
tailgate
Moving window/latch
EXTERIOR PROTECTION
Roof protection strip
Bumpers
Side protection strips
Protective panel at rear
51
55
54
Mechanisms and
accessories
50-1
50-2 54-4
54-5
54-6
54-7
55-1
55-3
55-4
55-5 GENERAL
50
52
52-1
52-2
52-3
52-4
52-5
52-6Exterior rear view mirror
Rear view mirror
Rear screen washer jet
Number plate light56-1
56-2
56-3
56-4 EXTERIOR ACCESSORIES
Dashboard 57-1 LOWER INTERIOR ACCESSORIES
56
57
Pages
59-1
59-2 Upper storage compartment in cab
Front seat belts
Rear seat belts
59
58-1 UPPER INTERIOR ACCESSORIES
58
INTERIOR SAFETY ACCESSORIES WINDOWS
Windscreen
Front door window54
54-1
54-3

LOWER INTERIOR ACCESSORIES
Dashboard
Remove the two bolts behind the steering wheel.
Disconnect the connectors (air bag, horn).
Remove:
- the air bag,
- the steering wheel bolt (when refitting, use a
new bolt with adhesive applied and tightened
to a torque of 4.5 daN.m),
- the steering wheel (with the wheels in the
straight ahead position).
Removing steering wheel (without air bag).
Remove:
- the centre boss,
- the steering wheel bolt (when refitting, use a
new bolt with adhesive applied and tightened
to a torque of 4.5 daN.m),
- the steering wheel (with the wheels in
straight ahead position).
57
REMOVING
Disconnect the battery.
Remove steering wheel (with air bag).
PRB5702
12973S
57-1

LOWER INTERIOR ACCESSORIES
Dashboard
- the instrument panel (four screws).
57
Remove :
- the half cowling (three bolts),
12969-1R12971R
12970-1R
- the instrument panel binnacle (six screws) and
the dashboard cowling (two screws),Disconnect the connectors.
12968S
57-2

LOWER INTERIOR ACCESSORIES
Dashboard
- lower section of dashboard (four screws, two
clips).
57
Special instructions for vehicles with air bags
Before removing the assembly, it is essential to
mark the position of the rotating switch under the
steering wheel :
- Make sure the wheels are in the straight ahead
position when the assembly is removed so that
the length of the the ribbon can be positioned
in the centre,
- By immobilising the rotating switch rotor, using
adhesive tape .
Undo the screw and then give the screwdriver a
sharp tap to release the cone.
Disconnect the connectors.
12966R12967-1R
Remove:
- lower protector (four screws).
12971-1R
57-3

LOWER INTERIOR ACCESSORIES
Dashboard
- the ashtray and its bracket (two screws).
Disconnect connectors.
57
Remove fuse holder (five screws).
Unclip diagnostic socket.
12963R12965-1R
12965-1R1
Remove :
- fittings securing steering column (two nuts,
two bolts),Remove :
- heating control panel (two screws).
12963R1
57-4

LOWER INTERIOR ACCESSORIES
Dashboard
Unclip gear lever gaiter.
Remove the four mounting bolts.
Disconnect connectors.
57
Take out speaker grilles.
Remove fittings securing dashboard.
Pull dashboard gently.
Detach clips holding wiring harness.
Disconnect:
- connectors for headlight height adjustment
and hazard warning lights,
- remaining connectors (e.g. decoder).
Remove dashboard.
12964R
PRB5701
CONSOLE
57-5