RENAULT MEGANE SCENIC 1995 Service Repair Manual

INTERIOR SAFETY ACCESSORIES
Front seat belts
59A
RECOMMENDATIONS FOR FITTING SEAT BELT INERTIA REELS
14340R
Following the triggering of the pretensioners, the
front seat belt or belts must be systematically re-
placed (if there was any doubt about whether the
seat belt was being worn, it must be replaced).
IMPORTANT
These vehicles are fitted with a new passive safety assembly comprising, amongst other components, new
front air bags and specific front seat belts with a new programmed restraint system (SRP).
The programmed restraint system is not calibrated in the same way according to whether the seat belts are
fitted with an SRP air bag or not (the Part Number for each part must be checked before replacement).
It is strictly forbidden:
- to fit new SRP air bag cushions and / or their specific seat belts to vehicles originally fitted with old type
equipment,
- to fit components from an old type system to a vehicle fitted with this new restraint system.
NOTE : for more information on fitting the new SRP seat belts, refer to the instructions below.
New SRP programmed restraint system.
This new force limiter system
L.E.I. is integral in
the inertia reel.
The force limitation applied to the diagonal strap
of the seat belt occurs by controlled release of the
strap (1), ensured by the plastic deformation of a
torsion bar (2) integrated into the inertia reel.
59-1

INTERIOR SAFETY ACCESSORIES
Front seat belts
59A
15396S
59-2

INTERIOR SAFETY ACCESSORIES
Rear seat belts
59B
REMOVAL
Remove:
- the front quarter panel lining (see section
71C),
- the rear quarter panel lining (see section
71D),
- the lower quarter panel lining (see section
71E).
PRE5901
15413-3R1
- the inertia reel mounting bolt (A),
- the seat belt strap lower mounting bolt (B).
REMOVING THE THIRD SEAT BELT INERTIA REEL
Pull on the lining / inertia reel assembly to release
the clip (C).
Using a screwdriver with a Torx 40 socket, slacken
the mounting bolt (B).
NOTE : the inertia reel is positioned on the roof
using the index pin (D).
The strap guide (E) and the plastic housing (F) can-
not be removed.
If the inertia reel is being replaced, the complete
third seat belt assembly must be replaced, which is
available from the Parts Department.
Seat belt mounting bolt 2.5
TIGHTENING TORQUE (in daN.m)
15414R
59-3

Sealing and soundproofing
OPENING ELEMENT SEALING
77 11 204 192 MARCH 1999Edition Anglaise
KA0X
"The repair methods given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories
from which his vehicles are constructed."All copyrights reserved by Renault.
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of
Renault.
CRenault 1999

EXPLODED VIEW
DI60.1R

Page
Contents
OPENING ELEMENT SEALING
Rear door pillar seal65
Sealing and
soundproofing
65-1

OPENING ELEMENTS SEALING
Rear door pillar seal
65A
Remove the rear quarter panel window (see sec-
tion 54C).
Using unpicking pliers, remove the three retaining
clips (A).
Remove the seal.
NOTE : the retaining clips are located in plastic
holders (B) mounted to the body.
REMOVAL
15403R
PRE6501R
65-1

Upholstery and trim
NON-SIDE OPENING ELEMENTS TRIM
INTERIOR BODY TRIM
77 11 204 192 MARCH 1999Edition Anglaise
KA0X
"The repair methods given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories
from which his vehicles are constructed."All copyrights reserved by Renault.
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of
Renault.
CRenault 1999

EXPLODED VIEW
PRG70.1R

Contents
Page
Upholstery and trim
Boot carpet
Headlining
Front rear quarter panel lining
Rear rear quarter panel lining
Lower rear quarter panel lining
Wheel arch lining71-1
71-2
71-5
71-6
71-7
71-8
73-1 Tailgate lining INTERIOR BODY TRIM
NON-SIDE OPENING ELEMENTS TRIM
71
73