jack points RENAULT MEGANE SCENIC 1995 Service Repair Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 1995, Model line: MEGANE SCENIC, Model: RENAULT MEGANE SCENIC 1995Pages: 2492, PDF Size: 32.28 MB
Page 8 of 2492
LIFTING
Trolley jack - Axle stands
AXLE STANDS
When putting the vehicle on axle stands, they
must be positioned:
- either under the reinforcements designed for
lifting the vehicle using the vehicle’s jack,
- or under the points located behind the
reinforcements.
Axle stands are positioned at the rear when the
vehicle is lifted from the side.
02
98699R
Safety symbol (special precautions to be taken when carrying out operations).
SPECIAL TOOLING REQUIRED
Cha. 280 -02 Adaptable cross piece for trolley
jack
Cha. 408 -01
or Adaptable socket for trolley jack
Cha. 408 -02
If a trolley jack is used, appropriate axle
stands must always be used.
It is forbidden to lift the vehicle by supporting its
weight under the front suspension arm or under
the V shaped part of the rear axle.
Depending on the type of trolley jack, use sockets
Cha. 408-01 or Cha. 408-02 to position the cross
piece Cha. 280-02.
To lift the front or rear, support the vehicle’s
weight under the vehicle’s jacking points .
TROLLEY JACK USED FROM THE SIDE
Use cross piece Cha. 280-02.
Take the weight under the sill, level with the front
door.
Position the flange correctly in the groove of the
cross piece.
98336G85679-1G7
02-1
Page 9 of 2492
LIFTING
Vehicle lifts
02
SAFETY INSTRUCTIONS
Several scenarios should be considered:
1 - WHEN REMOVING COMPONENTS
In general, never use a 2 post lift, if a four post lift
can be used.
If this is not possible, position the lifting pads
under the body sill, level with the vehicle’s jacking
points.2 - SPECIAL CASE - REMOVING AND REFITTING
THE ENGINE AND TRANSMISSION ASSEMBLY
In this special case, the body of the vehicle must
be firmly attached to the arms of the two post lift
using the special pads.
FOG
Reference FOG 449 8111 - 449 8411
or
CHEMICO
Reference 39 2550 0001
or
SCHENCH
Reference 776 684
98703S
FRONT
98704S
REAR
These must be positioned in line with the vehicle’s
jacking points. They must be clipped into the
holes in the body sill.
02-2