spare wheel RENAULT SCENIC 2006 J84 / 2.G Tyre Pressure Monitoring Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2006, Model line: SCENIC, Model: RENAULT SCENIC 2006 J84 / 2.GPages: 37, PDF Size: 0.15 MB
Page 10 of 37
TYRE PRESSURE MONITOR
Fault finding - System operation
35B
UCH
Program no.: 350 and higher
Vdiag No: 48-4C-4D-4F-50TYRE PRESSURE MONITOR
Fault finding - System operation
SYSTEM COMPOSITION
The tyre pressure monitor system consists of the following components:
–four sensors (one on each wheel but not on the emergency spare wheel)
–a computer (UCH)
–a receiver aerial (17-cm bare wire connected to the UCH)
–an instrument panel display for the driver
In addition to these components, the PAX system is comprised of four special tyres with a support ring to allow flat
tyre driving following a puncture over a maximum distance of 120 miles (200 km), at a maximum speed of 48 mph
(80 km/h).
WARNING
It is forbidden to install PAX System tyres on a vehicle without PAX System tyres as standard.
Edition 435B-9
Page 34 of 37
TYRE PRESSURE MONITOR
Fault finding - Fault Finding Chart
35B
UCH
Program no.: 350 and higher
Vdiag No: 48-4C-4D-4F-50
ALP 4"Tyre sensor inoperative" message lights up (wheel warning light
disappears)
NOTESCheck that all the faulty tyres are fitted with tyre pressure monitor valves.
Has one of the wheels been replaced with
the spare?YES
NO
Program the four valve codes with command
SC002 Program the four valve codes.
Did the programming procedure go
properly?
NO YES
End of fault finding
Replace the faulty valve.
Do the necessary work
on the wheel with a tyre
pressure monitor valve,
then refit it on the vehicle
AFTER REPAIRCarry out a complete check with the diagnostic tool.
35B-33
SSPP_V48_ALP04 /SSPP_V4C_ALP04/SSPP_V4D_ALP04/SSPP_V4F_ALP04/SSPP_V50_ALP04
Edition 4