audio RENAULT SCENIC 2007 J84 / 2.G Electrical Equipment - Radio Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2007, Model line: SCENIC, Model: RENAULT SCENIC 2007 J84 / 2.GPages: 34, PDF Size: 0.23 MB
Page 4 of 34
RADIO
General Information
86A
86A - 4V2 MR-372-J84-86A000$099_eng.mif
The radio features allow you to:
–listen to the radio (four geographical zones can be
programmed for FM radio)
–display the name of the station using RDS which
automatically switches to the best transmitter (AF
function),
–receive traffic news (I Traffic function),
–receive news flashes and emergency bulletins
(I News function).
–receive public safety emergency bulletins (PTY 31).
RADIO FUNCTION
The tuner has three selection modes displayed on the
screen and accessible from the radio front panel:
–manual mode (MANU),
–preset mode (PRESET),
–alphabetical mode (LIST).CASSETTE FUNCTION
The cassette plays automatically once cassette mode
has been selected using the steering wheel control or
the front panel.
Only the Dolby fast-forward and rewind with search
controls can be selected by specific buttons.
CD FUNCTION
The CD player can play conventional discs and any
audio tracks on a CD-ROM.
CDs can be played in order or tracks can be chosen at
random.
If a CD changer is being used, random play is possible
on only one of the possible 6 compact discs.
THERMAL PROTECTION
If the radio temperature is too high for it to function
properly, the volume is automatically reduced (without
changing the volume shown in the display).
Should one of the speaker tracks short circuit, the
supply to the amplifier will be cut off.Note:
The Mute function, accessed via the voice
synthesiser or the steering wheel control, stops the
cassette playing.
Page 12 of 34
RADIO
Self-test procedure
86A
86A - 12V2 MR-372-J84-86A000$594_eng.mif
RADIO
Self-test procedure
The self-test procedure mode of the previous generation radios (PN0-6) allows certain main functions to be tested:
●by pressing buttons 2 and 4 at the same time, the speakers can be tested. They are supplied one by one; the
display enables the connections and signals from each speaker to be checked,
●by pressing buttons 1 and 6 at the same time, the reception level can be tested (after frequency is displayed),
–9 or letter: good reception,
–less than 3: poor reception,
–if 2: total loss of stereo.
The self-test procedure mode of the new generation radios (NR4/5) enables certain main functions to be tested
using the combination of buttons 1, 6 and i. The messages will be displayed in the following way:
●Radio pre-code displays one letter and 3 digits to avoid removal of the radio,
●speaker test with two bleeps (bass - treble) from the speakers, with the tested speakers shown on the display
(front left-hand H01, front right-hand H02, rear right-hand H03, rear left-hand H04),
●displays the frequencies and levels of the tuner sensors,
●software version displayed, displays fault finding for the connected aerial if the aerial is supplied by a coaxial
cable; in this case, the display shows H15 with X = 0, 1 or 2 depending on the aerial status (0: open circuit, 1:
short circuit to earth, 2: power consumption),
●audio test loudness OFF (H08), cuts any loudness for an audio test.
Note:
Also displays source use time and total time in 10 minute slots (Tuner (H09)/CD (H10)/cassette (H11)/CD changer
(H12)/auxiliary (13)/MP (H14)/Total (H15)).
MR-372-J84-86A000$594_eng.mif
Page 24 of 34
RADIO
Fault finding chart
86A
86A - 24V2 MR-372-J84-86A000$792_eng.mif
ALP 7 The volume does not increase with the vehicle speed.
The SDVC (speed-dependent volume
control) function does not work.
Check the audio equipment
configuration (Expert mode). Set the
SPEED curve to 5 and run a test when
driving at a speed greater than 48 mph
(80 km/h).
No
Does the volume change?
Yes
The fault has been rectified. Check the signal on
connection 47F (see wiring
diagrams Technical Note,
vehicle, code 261) using a
multimeter. The voltage should
vary depending on vehicle
speed. Reset the control to: CURVE 2.
Yes
No
Does the signal increase?
YES
The fault is not associated with
the audio equipment. See MR
Fault finding corresponding to
vehicle, 38C, ABS, Conformity
check.Replace the radio with the
approval of your Techline.
Page 25 of 34
RADIO
Fault finding chart
86A
86A - 25V2 MR-372-J84-86A000$792_eng.mif
ALP 8Lighting does not change when the vehicle lights are switched on
Lighting does not change when the
vehicle lights are switched on.
Check for + 12 V on connection LPG
(only lights are on).
No
Is there + 12 V feed?
Yes
Replace the radio. The fault is not associated with
the audio equipment. Check the
continuity and insulation of
connection LPG using a
multimeter (See Wiring
diagrams Technical Note,
vehicle, code 261).
No
Test OK?Replace the wiring or repair it if
the procedure exists
Yes