battery replacement RENAULT SCENIC 2007 J84 / 2.G Electrical Equipment - Xenon Bulbs Workshop Manual

80C -9V2 MR-372-J84-80C000$030.mif
80C
Program No.: V010
Vdiag No.: 05
The xenon bulbs fitted to the system require a voltage of 20,000 V when switched on, then run on 85 V AC.
You must always disconnect the battery before doing any work on the headlights, bulbs, and high-voltage headlight
power transformer units.
To follow the method of removal-refitting of the constituent components of the system, see MR 370 (Scenic II)
or MR 361 (Espace IV) or MR 353 (Velsatis), Mechanical systems, 80C - Xenon Bulbs, Xenon bulb computer:
Removal – Refitting or MR 339 (Laguna II), Mechanical systems, 80 – Headlights, Xenon headlights.
It is forbidden to supply a bulb if it is not installed in the headlight (danger that you might damage your eyes).
The computer must be calibrated using CF001computer calibration (see Configuration and programming) each
time a front or rear level sensor is replaced.
The following procedure should be applied before adjusting the headlight beam:
–check that there are no faults
–configure the vehicle type using command CF003 Vehicle type (see Configuration and programming)
–calibrate the computer using command CF001 (see Configuration and programming)
Next adjust the headlights manually, (see MR 370 (Scenic II) or MR 361 (Espace IV) or MR 353 (Velsatis),
Mechanical systems, 80C - Xenon bulbs, Xenon headlight: Adjustment or MR 339 (Laguna II), Mechanical
systems, 80 – Headlights, Xenon headlights).
XENON BULBS
Fault finding – Component replacement