headlights RENAULT SCENIC 2008 J84 / 2.G Electrical Equipment -Battery Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2008, Model line: SCENIC, Model: RENAULT SCENIC 2008 J84 / 2.GPages: 9, PDF Size: 0.05 MB
Page 5 of 9
80A-5V4 MR-372-J84-80A000$040.mif
80A
Test procedure using the MIDTRONICS tool
Test conditions
The measurement must be taken when the vehicle is stationary and the ignition is off.
If the engine has been run in the last hour, switch the battery status to test and carry out the following operations:
–engine switched off,
–switch on the main beam headlights for 2 minutes,
–switch off the main beam headlights,
–wait for 2 minutes,
–switch off the ignition.
Equipment to be used:
–Tester approved by the Service Department: MIDTRONICS MICRO R330.
–Tool available as part no.: Elé. 1593.
–Equipment available in France from the Parts Department.
–Tool available in 6 languages.
–For other countries, consult your contact in your country. Special tooling required
Elé. 1593 Battery tester
MIDTRONICS R330
WARNING
Failure to observe the procedure or poorly maintained equipment may result in incorrect measurements, which
could be:
–detrimental to the customer (the battery is not sound),
–detrimental to RENAULT (unnecessary replacement of a sound or rechargeable battery),
–detrimental to the dealership (if the battery is tested as sound or rechargeable for a part return under warranty,
the warranty reimbursement request will be cancelled).
BATTERY
Battery – Check
Page 8 of 9
80A-8V4 MR-372-J84-80A000$050.mif
BATTERY
Battery – Test80A
TEST1 Testing the battery
Has the engine been running in the past hour?
Switch off the engine and remove the key (or card) to interrupt the + after
ignition feed and switch the main beam headlights on for 2 minutes. Then
switch them off and wait 2 minutes.
Carry out a battery test using the MIDTRONICS tool (the information requested by the MIDTRONICS tool is
provided on the battery label).
What message is displayed by MITRONICS?
The device
does not light
up."Battery OK +
recharge" or
"Charge +
retest""Battery
sound""Incorrect component"
or "Replace battery""Test
impossible"
Test the test
equipment
on another
batteryRecharge the
battery (see
Technical Note
6512A,
Charging
batteries).The battery
is sound.Does the
message appear
for the first time?
Is the device
working?
Replace the
deviceCarry out a
charging circuit
test, Phase 1 (see
Technical Note
6014A), Phase 2
(see MR 372, 87G,
Engine
compartment
connection unit).
NO
YES
NO
YES
NO
YES
CAB