driver seat adjustment RENAULT TWINGO 2012 2.G Owners Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2012, Model line: TWINGO, Model: RENAULT TWINGO 2012 2.GPages: 220, PDF Size: 6.73 MB
Page 19 of 220
seatsadjustment ...................................... (up to the end of the DU)
heated seats .......................................................... (current page)
front seats ............................................. (up to the end of the DU)
front seat adjustment ............................................. (current page)
1.13
ENG_UD30508_8
Sièges avant (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
Front seats
FRONT sEATs (1/2)
To move forwards or
backwards
Move the lever 2 or handle 4 (passen -
ger side) to unlock. Once in the desired
position, release the lever or handle
and check that the seat is correctly
locked.
To tilt the seatbackMove handle 5 and tilt the seatback to
the desired position.
heated seats(depending on the vehicle)
With the ignition switched on, press
switch 1 on the required seat. The indi -
cator light in the switch lights up.
The system, which has a thermostat,
regulates the heating and deactivates it
if necessary.
Adjusting the height of the
driver’s seat
(depending on the vehicle)
Move lever 3.
For safety reasons, carry out any adjustments when the vehicle is not
being driven.
We would advise you not to recline the seatbacks too far to ensure that
the effectiveness of the seat belts is not reduced.
Nothing should be placed on the floor (area in front of driver) as such objects may
slide under the pedal during braking manoeuvres, thus obstructing its us\
e.
Make sure that the seat -
backs are correctly locked
in place.
2
3
4
5
1
Page 20 of 220
1.14
ENG_UD30508_8
Sièges avant (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
FRONT sEATs (2/2)
Access to the rear seats
Move handle 4 or 6 (depending on the
vehicle), move the seat back and slide
the seat forwards.
To return the seat to its original position
(as stored in the memory, depending on
the vehicle) on the driver’s side, slide
the seat backwards until it locks.
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
We would advise you not to recline
the seatbacks too far to ensure that
the effectiveness of the seat belts is
not reduced.
Nothing should be placed on the
floor (area in front of driver) as such
objects may slide under the pedal
during braking manoeuvres, thus
obstructing its use.
Make sure that the seatbacks are
correctly locked in place.
Check that no object or
person prevents the front
seat from locking. If so,
r e m o v e a n y o b s t a c l e s
behind the front seats. Adjust the
seat to allow sufficient room in the
rear. The rear occupants/objects
should then return to the vehicle.
Repeat the above until the seat is
locked correctly.
Risk of seat moving on its runners
during vehicle acceleration or brak-
ing.
Do not move handle 2 and handle 4
or 6 at the same time.
4
2
6