RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual https://www.carmanualsonline.info/img/7/1719/w960_1719-0.png RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual

Page 231 of 281

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual 37A-52
MECHANICAL COMPONENT CONTROLS
Clutch pedal switch: Removal - Refitting
CRUISE CONTROL, and 5-SPEED MANUAL GEARBOX
37A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aRemove the dashboard glovebox.
a

Page 232 of 281

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual 37A-53
MECHANICAL COMPONENT CONTROLS
Clutch pedal switch: Removal - Refitting
CRUISE CONTROL, and 5-SPEED MANUAL GEARBOX
37A
REFITTING
I - REFITTING PREPARATIONS OPERATION
a
aMeasure dimension of the

Page 233 of 281

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual 37A-54
MECHANICAL COMPONENT CONTROLS
Clutch circuit: Bleed
JH3 or JR5
37A
Bleed in the event of:
-dead travel,
-pedal at mid-travel,
-pedal to the floor,
-poor gear changing.
I - PRECAUTIONS DURING RE

Page 234 of 281

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual 37A-55
MECHANICAL COMPONENT CONTROLS
Clutch circuit: Bleed
JH3 or JR5
37A
There are several versions of bleed screw:
Screw type bleed screw.
aTo open the bleed screw, hold the plastic union (1)
using

Page 235 of 281

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual 37A-56
MECHANICAL COMPONENT CONTROLS
Clutch circuit: Bleed
JH3 or JR5
37A
Bleed screw with two clips.
aTo open the bleed screw, lower the clip (6) and lift
the clip (7) while pulling by one notch.
III

Page 236 of 281

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual 37A-57
MECHANICAL COMPONENT CONTROLS
Clutch circuit: Bleed
JH3 or JR5
37A
2 -  Bleed using a new syringe.
aKeep the clutch pedal in the upper position using a
strap attached to the steering wheel to e

Page 237 of 281

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual 37A-58
MECHANICAL COMPONENT CONTROLS
Clutch circuit: Bleed
JH3 or JR5
37A
There are several versions of pipe with and without 
a filter:
Pipe without filter.
Filling position for pipe with filter.Fill

Page 238 of 281

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual 37A-59
MECHANICAL COMPONENT CONTROLS
Clutch circuit: Bleed
JH3 or JR5
37A
aPrefill the hydraulic tappet using the new syringe (by
gravity).
aRefit the part(s) concerned.V - BLEED PROCEDURE AFTER A REM

Page 239 of 281

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual 37A-60
MECHANICAL COMPONENT CONTROLS
Clutch circuit: Bleed
JH3 or JR5
37A
VI -  FINAL OPERATION
aRefit the engine undertray.
aRemove the vehicle from the two-post lift (see Vehi-
cle: Towing and lifti

Page 240 of 281

RENAULT TWINGO RS 2009 2.G Chasiss Workshop Manual 37A-61
MECHANICAL COMPONENT CONTROLS
Clutch master cylinder: Removal - Refitting
JH3
37A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aPosition the vehicle on a two-post lift (see Vehicle:
Towing and lif