light RENAULT WIND 2012 1.G Owner's Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2012, Model line: WIND, Model: RENAULT WIND 2012 1.GPages: 185, PDF Size: 5.52 MB
Page 46 of 185
control instruments ............................... (up to the end of the DU)
indicators: instrument panel ............................. (up to the end of the DU)
trip computer and warning system ........(up to the end of the DU)
instrument panel ................................... (up to the end of the DU)
warning lights ........................................ (up to the end of the DU)
instrument panel messages ..................(up to the end of the DU)
1.40
ENG_UD25518_3
Ordinateur de bord : généralités (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_1
on-board computer
TRIp COMpUTER: general information
Selection key 1 on display A
Press button 1 to repeatedly to scroll
through the following information:
a) total mileage and trip mileage re -
corder;
b) journey parameters:
– fuel used;
– average fuel consumption;
– current fuel consumption;
– estimated range;
– distance travelled;
– average speed;
c) oil change interval;
d) cruise control and speed limiter pro-
grammed speed;
e) dashboard and instrument panel
brightness management;
f) trip log, operating faults and informa-
tion message readout.
Refer to the tables on the following
pages for display examples.
Trip computer and warning
system A
This includes the following functions:
– distance travelled;
– instrument brightness;
– journey parameters;
– information messages;
– operating fault messages (associ -
ated with the
© warning light);
– warning messages (connected to the
® warning light).
All these functions are described on the
following pages.
General reset and trip
mileage recorder reset key 1
Press and hold button 1 to reset the trip
mileage recorder. The display must be
set to “Trip mileage recorder”.
Note: resetting is automatic when
the maximum capacity of any of the
memories is exceeded.
1
A
Page 48 of 185
1.42
ENG_UD25519_2
Ordinateur de bord : paramètres de voyage (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_1
Jaune NoirNoir texte
TRIp COMpUTER: trip settings (2/4)
The display of information shown below DEpENDS ON THE VEHICLE EQUIpMENT AND COUNTRY.
Examples of selections Interpreting the display selected
RANGE
Estimated range with remaining fuel
This range takes into account the average fuel consumption since the last time the
reset button was pressed.
The value is displayed after driving 400 metres.
Several minutes after the reserve light has come on (refer to the information on the
“Instrument panel”), the estimated range will no longer be displayed.
322 KM
DISTANCE
Distance travelled
since the last reset.
0.5 KM
AVERAGEAverage speed since the last reset.
The value is displayed after driving 400 metres.
78.9 KM/H
Page 49 of 185
JauneNoirNoir texte
1.43
ENG_UD25519_2
Ordinateur de bord : paramètres de voyage (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_1
TRIp COMpUTER: trip settings (3/4)
The display of information shown below DEpENDS ON THE VEHICLE EQUIpMENT AND COUNTRY.
Examples of selections Interpreting the display selected
c) Oil change interval
Distance/time remaining until the next oil change (displayed in miles/kilometres
and months), then when the service nears, several scenarios are possible:
– distance/time remaining less than 900 miles (1,500 km) or one month : de-
pending on the vehicle, the message “ SERVICE DUE SOON” is displayed;
– distance/time remaining 0 miles/km or oil change date reached: depending
on the vehicle, the message “SERVICE DUE” is displayed when the selected
display is “mileage before oil change”, accompanied by the
9 symbol and the
© warning light.
The vehicle requires an oil change as soon as possible.
OIL CHANGE DUE
13770 KM
NB: depending on the vehicle, the interval between oil changes varies according to the driving style (frequent driving at low
speed, door-to-door journeys, extensive use at idle speed, towing a trailer etc.). The distance remaining until the next oil
change can therefore decrease more quickly in some cases than the actual distance travelled.
The oil change intervals are independent of the vehicle’s maintenance schedule: please refer to your vehicle’s Maintenance
Document.
Resetting: to reset the mileage before an oil change, with the display showing “oil change”, press and hold one of the display
reset buttons for approximately 10 seconds until the display shows the interval permanently . Refer to the previous pages.
Page 50 of 185
1.44
ENG_UD25519_2
Ordinateur de bord : paramètres de voyage (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_1
TRIp COMpUTER: trip settings (4/4)
Examples of
selections Interpreting the display selected
BRIGHTNESS
d) Dashboard and instrument panel brightness management.
SPEED LIMITER
e) Cruise control/speed limiter programmed speed.
Refer to the information on the “Cruise control/speed limiter” in Section 2.
70 KM/H
CRUISE CONTROL 70 KM/H
NO MESSAGE AVAILABLE
f) Trip log
Successive display:
– information messages (automatic lighting, etc.),
– operating fault messages (check the injection system, etc.).
The display of information shown below DEpENDS ON THE VEHICLE EQUIpMENT AND COUNTRY.
Page 51 of 185
1.45
ENG_UD24361_1
Ordinateur de bord : messages d’information (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_1
TRIp COMpUTER AND WARNING SYSTEM: information messages
These can help in the vehicle starting phase, or give information about a selection or a driving status.
Examples of information messages are given in the following pages.
Examples of messages Interpretation of messages
“ESp OFF” Indicates that you have deactivated the ASR function.
“AUTO LIGHTS DEACTIVATED” Indicates that the automatic lights function is deactivated.
Page 52 of 185
1.46
ENG_UD24362_1
Ordinateur de bord : messages d’anomalies de fonctionnement (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_1
TRIp COMpUTER: operating fault messages
These appear with the © warning light and mean that you should drive very carefully to an authorised dealer as
soon as possible. If you fail to follow this recommendation, you risk damaging your vehicle.
They disappear when the display selection key is pressed or after several seconds and are stored in the computer log. The
© warning light stays on. Examples of operating fault messages are given on the following pages .
Examples of messages Interpretation of messages
“CHECK ESp” Indicates a fault with the traction control system (refer to the information on
the “Traction control system: ASR ” in Section 2).
“CHECK AUTO LIGHTS ”Indicates an automatic lighting operating fault; contact an approved Dealer .
Page 53 of 185
1.47
ENG_UD24363_1
Ordinateur de bord : messages d’alerte (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_1
These appear with the ® warning light and require you to stop immediately, for your own safety, as soon as traffic
conditions allow. Stop your engine and do not restart it. Contact an approved Dealer.
Examples of warning messages are given in the following pages. Note: the messages appear on the display either individually
or alternately (when there are several messages to be displayed), and may be accompanied by a warning light and/or a beep.
Examples of messages Interpretation of messages
“INJECTION FAULT” Indicates that the vehicle has a serious engine fault.
“STEERING FAULT” Indicates a fault in the vehicle’s power-assisted steering.
“LOW BATTERY” Indicates a fault with the battery charging circuit.
“BRAKING FAULT” Indicates a fault in the braking circuit.
“OIL pRESSURE FAULT” Indicates an oil pressure fault.
“ENGINE OVERHEATING” Indicates that the engine is overheating.
TRIp COMpUTER : warning messages
Page 56 of 185
rear view mirrors ................................... (up to the end of the DU)
1.50
ENG_UD11175_1
Rétroviseurs (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_1
Door mirrors
REAR VIEW MIRRORS
Door mirrors with electrical
adjustment:
With the ignition on, move button 1:
– position C to adjust the left-hand
door mirror;
– position E to adjust the right-hand
door mirror;
D is the inactive position.
Heated door mirrors(depending on vehicle)
The door mirrors are de-iced when the
rear screen demisting/de-icing is active.
The door mirror on the driv-
er’s side has two clearly de-
fined zones. Zone B shows
what can normally be seen
in an ordinary rear view mirror. For
your safety, zone A increases the
area you can see at the rear and to
the side of your vehicle.
The objects in zone A look much
further away than they really are.
Interior rear view mirror
Its position can be adjusted. When driv-
ing at night, to avoid being dazzled by
the headlights of the vehicle behind,
depress the little lever 2 located behind
rear view mirror.
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
2
CDE
AB
1
Page 57 of 185
warning buzzer ..................................... (up to the end of the DU)
headlight flashers ................................. (up to the end of the DU)
indicators .............................................. (up to the end of the DU)
lights: hazard warning ............................... (up to the end of the DU)
lights: direction indicators .......................... (up to the end of the DU)
indicators: direction indicators .......................... (up to the end of the DU)
hazard warning lights signal ................. (up to the end of the DU)
hazard warning lights signal ................. (up to the end of the DU)
horn ...................................................... (up to the end of the DU)
horn: flash ................................................................. (current page)
horn: sounding the horn ............................................ (current page)
horn ....................................................................... (current page)
audible and visual signals .....................(up to the end of the DU)
1.51
ENG_UD11176_1
Avertisseurs sonore et lumineux (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_1
Audible and visual signals
AUDIBLE AND VISUAL SIGNALS
Direction indicators
Move stalk 1 parallel to the steering
wheel and in the direction you are going
to turn it.
When driving on the motorway, the
steering wheel is not often turned
enough to return the stalk automatically
to 0 . There is an intermediate position
in which the stalk may be held when
changing lanes.
When the stalk is released, it automati-
cally returns to 0.éHazard warning lights
Press switch 2.
This switch activates all four direction
indicators and the side indicator lights
simultaneously. It must only be used in
an emergency to warn other drivers that
you have had to stop in an area where
stopping is prohibited or unexpected, or
that you are obliged to drive under spe-
cial conditions.
Depending on the vehicle, the hazard
warning lights may come on automati -
cally under deliberate heavy decelera -
tion. You can switch them off by press-
ing switch 2.
Horn
Press the end of the stalk 1.
Headlight flasher
Pull stalk 1 towards you to flash the
headlights.1
0
2
Page 58 of 185
lighting:exterior ............................................ (up to the end of the DU)
instrument panel .................................................... (current page)
lights: side lights ......................................................... (current page)
lights: dipped beam headlights ................................... (current page)
hazard warning lights signal .................................. (current page)
signals and lights .................................. (up to the end of the DU)
lighting: instrument panel .............................................. (current page)
daytime running lights ............................................ (current page)
1.52
ENG_UD21753_2
Éclairages et signalisations extérieurs (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_1
Jaune NoirNoir texte
áMain beam headlightsWith the dipped headlights lit,
pull stalk A towards you. An indicator
light on the instrument panel will come
on.
To return to the dipped headlights posi-
tion, pull stalk A towards you again.
eSwitching off the lightsReturn the stalk to its original
position.
Lights-on warning buzzer
If the lights are on after the engine is
switched off, a warning beep sounds
when the driver ’s door is opened to
warn you that the lights are still on.
Exterior lighting and signals
EXTERIOR LIGHTING AND SIGNALS (1/2)
uSide lights
Turn end 1 of stalk A until the
symbol is opposite mark 2.
The instrument panel will light up.
kDipped beam
headlights
Manual operation
Turn end 1 of stalk A until the symbol is
opposite mark 2.
An indicator light on the instrument
panel will come on.
A
Automatic operation
With the engine running on vehicles
fitted with a light sensor , the dipped
beam headlights come on automati -
cally as light begins to fade; the stalk
does not need to be turned (position 0).
To deactivate or reactivate this function,
move end 1 of stalk A twice consecu -
tively from 0 to the side lights position,
with the vehicle stopped and the igni -
tion on.
A bleep confirms the deactivation of this
function, and two bleeps confirm its re-
activation.
21