height SSANGYONG MUSSO 2003 Workshop Manual

9R-4 BODY FRONT END Adjustment Procedure
1. Alignment between hood striker and latch hole. Loosen the mounting bolt of hood latch slightly and adjust
hood in forward/rearward and left/right directions. Then align the center between hood striker and latch hole.
Notice
Tighten the bolt fully after alignment. Installation Notice
Tightening Toque 13 - 26 Nm
2. Adjusting the height of hood overslam bumper. Unlock the hood and check the clearance between hood and fender by adjusting the hood overslam bumper in left/ right directions.
Normal 20 - 22 Nm
3. Hood Hinge. Loosen the hood lock bolts.
Adjust the lock in forward/rearward and left/right
directions, align with the hood striker and adjust the hood height.

5-180 ELECTRICAL WIRING DIAGRAMS
38. POWER SEAT CIRCUITb. CONNECTOR IDENTIFICATION SYMBOL & PIN NUMBER POSITIONC102
W/H MAIN C204
W/H MAIN SLIDE MOTOR
a. CONNECTOR INFORMATION
C251
W/H DRIVER SEAT
TILT MOTOR HEIGHT
MOTOR POWER SEAT
SWITCH
RECLINE
MOTOR
12123412
21
212112
67891011 34
125
Main - Engine Main - Driver Seat Driver Seat - Driver Seat, AUX Main
C102 (2Pin, Colorless)C204 (10Pin, White) C251 (3Pin, Black) G205
CONNECTOR(NUMBER)
CONNECTING. WIRING HARNESSCONNECTOR POSITION
Inside The Engine Room Fuse Block Under The Driver Seat Under The Driver SeatBeside The TCCU
GND
IGN1
15
31G205
Ef9 60A
F10 20A
E
f2 80A
C102
3
RB YW BW
C204
10
8
Power Seat SwitchSlide
FRT RR
M
1 2
Slide Motor 4
3
BR Y
M
1 2
Tilt Motor 2
1
BR LB
Down Up
Down Up
M
1 2
Height Motor 12
11
BY G
FRT RR
M
1 2
Recline Motor 10
95
LY L G B B
Height
Recline
Tilt
C251
1C251
2
C204
3
2
3
4
7
1
6 8
59
10