6) While detaching snap lock carefully, remove
cover (A). Pass outer belt center tongue (B)
through hole on roof trim, then remove roof trim.
S5M0410A
S5M0413
7) Install in the reverse order of removal.
CAUTION:
When removing clip, use great care to prevent
damaging the roof trim.
NOTE:
When installing roof trim, pass the outer belt cen-
ter tongue through hole on roof trim.
15
[W5A4]5-3SERVICE PROCEDURE
5. Inner Trim Panel
6) Using T40 TORXTbit (Tamper resistant type),
remove the four TORXTbolts in numerical
sequence shown in figure. Discard the old TORXT
bolts.
CAUTION:
Use new TORXTbolts during re-assembly.
S5M0219A
7) Install in the reverse order of removal.
7. Side Airbag Sensor
A: REMOVAL AND INSTALLATION
CAUTION:
IIf the side of the vehicle body is damaged by
a collision, be sure to check the left and right
side airbag sensors, even if the airbag was not
inflated. If any damage to the sensor or any
deformation of the sensor mount is found,
replace with a new genuine part.
IWhen painting or performing sheet metal
work on the side part of vehicle body, including
the side sill, center pillar, front and rear doors,
take utmost care not to apply dryer heat, paint-
ing mist, or the flame of the welding burner
directly to the side airbag sensors and wire
harness of the airbag system.
1) Turn ignition switch off.
2) Disconnect ground cable from battery and wait
for at least 20 seconds before starting work.
3) Remove center pillar lower trim.
[W5A1].>
4) Detach ELR of front seat belt.
[W3A0].>
5) Remove the two TORXTbolts and then detach
side airbag sensor while disconnecting connector.
S5M0308
6) Install in the reverse order of removal.
13
[W7A0]5-5SERVICE PROCEDURE
7. Side Airbag Sensor
2. Generator
A: REMOVAL AND INSTALLATION
1) Disconnect battery ground cable.
G6M0095
2) Disconnect connector and terminal from gen-
erator.
S2M0941
3) Remove V-belt cover.
S2M0896
4) Remove front side V-belt.
G2M0286
5) Remove bolts which install generator onto
bracket.
S2M0942
6) Install in the reverse order of removal.
CAUTION:
Check and adjust V-belt tension.
[G2A0].>
S2M0942
B: DISASSEMBLY
1) Remove the four through bolts. Then insert the
tip of a flat-head screwdriver into the gap between
the stator core and front bracket. Pry then apart to
disassemble.
S6M0404
12
6-1[W2A0]SERVICE PROCEDURE
2. Generator
