ignition TOYOTA CAMRY 2020 Owners Manual (in English)

Steering wheel controls
2
OVERVIEWInstrument panel
Tilt and telescopic steering lock release lever
(below the steering wheel) Ignition switch
1
Headlight/turn signal/fog light control
Automatic High Beam (AHB) switch VSC OFF switch
Bird’s Eye View Camera ON/OFF switch
1,2Trunk opener switch
Fuel tank door release switchHeated steering wheel
switch
1
Odometer/trip meter
Instrument panel light control switch
“STOP/START/ENGINE” button
1
Hood release leverDynamic Radar Cruise
Control (DRCC) or Cruise
control switch
Dynamic Radar Cruise Control
(DRCC) vehicle-to-vehicle distance
button
Lane Departure Alert with Steering
Assist (LDA w/SA) switch
Audio volume
control switch
2
Telephone switch
Audio remote control
switches
2
Paddle shifters1
Windshield wiper and washer control
Meters/Multi-Information Display (MID)
Meter control switches
Voice command switch2
Parking brake1

5
Full-Speed Dynamic Radar Cruise
Control (DRCC) indicator/DRCC
SET indicator
Brake system warning1
Malfunction/
Check Engine indicator1
Driver’s and front passenger’s seat belt
reminder (alarm will sound when the
engine switch is “ON” position*/
”IGNITION ON”** mode)
Low Tire Pressure Warning1
Low fuel level warning
Security indicator
Fuel tank door position Master warning
1,2
Headlight low/high
beam indicators
Turn signal indicator
Pre-Collision System (PCS)
warning light1,2
Slip indicator1,3
Vehicle Stability Control (VSC)
OFF indicator1
Eco driving indicator1
Parking brake indicator2
Rear passenger seat belt reminder
indicator Type A
Rear passenger seat belt reminder
indicator Type B
Brake hold operated indicator1,2,4
Brake hold standby indicator1
BSM w/Rear Cross Traffic Alert
(RCTA) Indicator4
BSM outside rear view mirror
indicators4
Brake system warning
(yellow indicator)1,4
Lane Departure Alert (LDA) indicator
(white/green/yellow3)
Electric power steering warning1
(red/yellow indicator)
Sport mode driving indicator4
ECO MODE indicator4
Low outside temperature indicator
Constant speed cruise control
indicator/Constant speed
cruise control SET indicator
1 If the indicator does not turn off within a few seconds of starting the \�engine, there may be a
malfunction. Have the vehicle inspected by your Toyota dealer.
2 If the indicator flashes, there may be a malfunction. Refer to the Owner\�’s Manual.3 If the indicator flashes, it indicates that the system is operating.4 If equipped.
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
* Vehicles without a Smart Key system
** Vehicles with a Smart Key system

9
Automatic transmission
* The engine switch must be in the “ON” position (without Smart Key) / “IGNITION ON” mode (with Smart Key) and the brake pedal depressed to shift from Park.
Shift the shift lever to “S” position from “D” position.
Shift lever type:
+ : Upshift (push and release)
- : Downshift (pull and release) Paddle shifters type (if equipped):
+ : Upshift (pull and release)
- : Downshift (pull and release)
Downshifting increases power going uphill, or provides engine braking do\�wnhill. For
best fuel economy during normal driving conditions, always drive with th\�e shift lever
in the “D” position.
“S” (SEQUENTIAL) MODE
Auto lock/unlock
Automatic door locks can be programmed to operate in different modes, or\� turned
OFF.
Shift position linked door locking/unlocking function
-Doors lock when shifting from Park.
-Doors unlock when shifting into Park.
Speed linked door locking function
-Doors lock when the vehicle speed goes above approximately 12 mph (20 km/h).
Driver’s door linked door unlocking function
-Doors unlock when the engine switch is set to OFF and driver’s door i\�s opened.
Refer to the Owner’s Manual for more details.
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES+ (“S” mode)
Shift lever
Paddle shifters*
*If equipped
- (“S” mode)
- (“S” mode)
+ (“S” mode)
N
Park*
Reverse
Neutral
Drive
“S” mode
FEATURES & OPERATIONS

15
* Intermittent windshield wiper frequency adjustment Rotate to increase/decrease
wipe frequency.
Refer to the Owner’s Manual for more details.
Windshield wipers & washers
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
SEAT VENTILATORS (IF EQUIPPED)
SEAT HEATERS (IF EQUIPPED)
Without seat ventilatorsWith seat ventilators
The engine switch must be in the “ON” position (without Smart Key) / ”IGNITION
ON” mode (with Smart Key) for use.
The engine switch must be in the ”IGNITION ON” mode for use.
Adjust frequency*
Pull to wash and wipeMist
Interval wipe
Slow
Fast
Seat heaters/ventilators (if equipped)
Driver seat
Driver seat
Driver seat
Front passenger
seat
Front passenger
seat Front passenger
seat

18
FEATURES & OPERATIONS
The Blind Spot Monitor is a system that has two functions:
• The Blind Spot Monitor function (assists the driver in decision-making when to change lanes)
• The Rear Cross Traffic Alert function (assists the driver when backing up)
The system is designed to use radar sensors to detect vehicles traveling\� in the
Camry’s blind spot. If a vehicle is detected, the driver will be aler\�ted via the outside
rear view side mirror indicators.
Rear Cross Traffic Alert function:
While in reverse, when a vehicle approaching from the right or left rear\� of the
vehicle is detected, the outside rear view mirror indicators flash.
Refer to the Owner’s Manual for limitations and more details on this \�system before
attempting to use it.
Blind Spot Monitor with Rear Cross
Traffic Alert (BSM w/RCTA)
(if equipped)
The engine switch must be in the “ON” position (without Smart Key) / ”IGNITION
ON” mode (with Smart Key) for use.
Steering wheel-heater (if equipped)
Indicators
Indicators
RCTA function display Buzzer (RCTA only)
Outside rear view mirror indicators

25
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Power outlet-12V DC
USB media port
Open lid
The engine switch must be in the “ACC” or “ON” position (without Smart Key) /
“ACCESSORY” or ”IGNITION ON” mode (with Smart Key) for use.
USB charge-ports (if equipped)
The engine switch must be in the “ACC” or “ON” position (without Smart Key) /
“ACCESSORY” or ”IGNITION ON” mode (with Smart Key) for use.
Connecting a compatible device and cable into the USB media port will su\�pport
charging and music playback through the audio multimedia system.
(Charge only)

28
FEATURES & OPERATIONS
Power switchCharge areaOperation indicator light
Qi Wireless charger (if equipped)
A mobile device can be charged wirelessly on the tray. (1) Press the wireless
charger power switch and the green operation indicator light turns on. (2) Place
a compatible mobile device on the tray as shown in the illustration. An \�amber
indicator illuminates while charging is in progress. When charging is co\�mplete, the
indicator illuminates green. Some phones, cases or cover type wireless c\�hargers
may not cause the green indicator to illuminate even though it is fully \�charged.
The engine switch must be in the “ACC” or “ON” position (without Smart Key) /
“ACCESSORY” or ”IGNITION ON” mode (with Smart Key) for use.
Refer to the Owner’s Manual for limitations and more details on this \�system before
attempting to use it.
Press (1)
When the engine is turned off, the last state (ON/
OFF) of the charger is memorized.
Place device nearest the center of charging area for
best results. Moving device may result in stopping
or restarting the charging process.
Place (2)

32
TOYOTA SAFETY SENSE™
CHANGING PCS ALERT TIMING
FarMiddle
(default) Near
(1) Press “” switches and select or from the Multi-Information Display
(MID).
(2) Press “
” switches and select “Warning sensitivity” from the MID and th\�en
press “
”. The setting screen is displayed.
(3) Press “
” each time to change the setting. Each time it is pressed, the
response to the PCS alert timing changes as shown above. You can press “\�
” to
go back to the menu.
Note: PCS is enabled each time the engine switch is turned to Ignition On.
The system can be disabled/enabled and the alert timing of the system can be
changed. (Alert timing only, brake operation remains the same).
Monocular front camera
Millimeter
wave radar
As part of the Pre-Collision System, this function is also designed to f\�irst provide an
alert and then automatic braking if needed.
Refer to the Toyota Owner’s Manual for additional limitations and inf\�ormation.Under certain conditions, the PCS system included with the TSS-P package\� may
also help to detect a pedestrian in front of your vehicle using the in-v\�ehicle camera
and front grille-mounted radar. The in-vehicle camera of PCS detects a p\�otential
pedestrian based on size, profile, and motion of the detected pedestrian\�. However,
a pedestrian may not be detected depending on the conditions, including \�the
surrounding brightness and the motion, posture, size, and angle of the p\�otential
detected pedestrian, preventing the system from operating or engaging.
PCS PEDESTRIAN DETECTION

34
TOYOTA SAFETY SENSE™
TURNING THE LDA SYSTEM ON/OFF
Press the LDA switch to turn the LDA system on. Depress again to turn it\� off.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
Refer to the Toyota Owner’s Manual for additional information on LDA \�operation,
settings adjustments, limitations, and precautions before attempting to \�use it.
LANE DEPARTURE ALERT
LDA function display
Steering assist indicatorLDA indicatorLane markers
(2)
(1)
Lane Departure Alert (LDA) indicator’s illumination shows the system operation
status.

35
The LDA function
displays when the Multi-Information Display (MID) is switched
to the driving assist system information screen.
(1) The system displays white solid lines and a white LDA indicator when visible lane
markers on the road are detected and system is operating. Both the LDA i\�ndicator
and a side line flashes yellow to alert the driver when the vehicle devi\�ates from its
lane.
(2) The LDA indicator is green when steering assist function is operating.
(3) The system displays outlines on the LDA indicator when lane markers on the road
are not detected or the function is temporarily cancelled.
Note: When operation conditions are no longer met, a function may be
temporarily canceled. However, when the operation conditions are met again,
operation of the function is automatically restored. For example, LDA may not
function on the side(s) where white/yellow lines are not detectable.
Refer to the Toyota Owner’s Manual for additional information on LDA \�operation,
settings adjustments, limitations, and precautions before attempting to \�use it.
ADJUSTING LDA ALERT SENSITIVITY
DISABLING STEERING ASSIST
The driver can adjust the sensitivity of the LDA (warning) function from the
Multi-Information Display (MID) customization screen.
High - Is designed to warn approximately before the front
tire crosses the lane marker.
Normal - Is designed to warn approximately when the front
tire crosses the lane marker.
(1) Press “
” switches and select or from the Multi-Information Display
(MID).
(2) Press “
” switches and select the “Alert sensitivity” setting function \�and then
press “
.”
(3) Press “
” each time to change the setting.
(4) Press “
” to go back to the menu.
(1) Press “
” switches and select or from the Multi-Information Display
(MID).
(2) Press “
” switches and select the “Steering Assist” setting function an\�d then
press “
.”
(3) Press “
” each time to change the setting.
(4) Press “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
LANE DEPARTURE ALERT (CONTINUED)
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES