display TOYOTA LAND CRUISER 2003 J100 Navigation Manual

98
2003 Land Cruiser 100 Navigation (OM60A00U)
The speech command system allows you
to operate the navigation system without
using your hands.
1. Push the speech command switch.
A beep sounds and an indicator is shown at
the top left of the display.
UNL302a
2. Give a command while an indicator is
shown in the display. (See ”Speech com-
mand list” on page 152.)
If the navigation system does not respond or
the confirmation screen does not disappear,
please push the speech command switch
and try again.
If no command is given, a beep sounds and
the indicator disappears 6 seconds later.
If the system does not recognize your
speech, the system will respond with this
message (“System does not recognize this
command, please rephrase your com-
mand.”). Start the operation from the begin-
ning.
 Microphone
It is unnecessary to speak directly into
the microphone when giving a command.
Speech command system

102
2003 Land Cruiser 100 Navigation (OM60A00U)
Trip information such as driving time,
driving distance, average vehicle speed,
fuel consumption, etc. can be displayed
on the screen.
1. Push the
”INFO” button to display
the information menu screen.
UNG403a
2. To u c h t h e ”Trip Information”switch.
UNG401
Consumption
The consumption is calculated and dis-
played based on the driving distance and
the fuel consumption for 2 seconds with
engine running.
The value is updated every 2 seconds.
If you are driving at low speeds just before
stopping, the accurate figure way not be
shown.
After Refueling
The consumption after refueling is calcu-
lated and displayed based on the total
driving distance and the total fuel con-
sumption after refueling.
The value is updated every 10 seconds. When refueling, be
sure to stop your vehicle
and turn the ignition switch off.
Cruising Range
How far you can drive with the remaining
fuel is displayed.
Even though the display indicates sufficient
miles to run, if the fuel level on the fuel gauge
approaches ”E” or the low fuel level warning
light comes on, fill the fuel tank as soon as
possible.
INFORMATION
 When you first start driving your new
vehicle, the correct cruising range
may not be shown. One or more re-
fills of 10 gallons or more may be re-
quired for the system to set its cal-
ibration.
 The cruising range displayed is cal-
culated based on past fuel consump-
tion and may vary according to your
driving style and road condition.
Trip information

103
2003 Land Cruiser 100 Navigation (OM60A00U)
Average Speed
The Average Speed is displayed. The av-
erage vehicle speed is calculated and dis-
played based on the total driving distance
and the total driving time after the engine
is started.
The displayed value is updated every 10
seconds.
To calculate from the beginning, touch the
”Reset” switch.
Distance
The distance after engine starting is dis-
played.
When refueling, be sure to stop your vehicle
and turn the ignition switch off.
To calculate from the beginning, touch the
”Reset” switch. The function returning to the previous
screen from the audio or air conditioner
screen is selectable.
1. Push
the
”INFO” button on the bezel
to display the Information menu screen
and touch the
”Screen Transition”switch.
UNG404
2. Select the ”ON” or ”OFF” and then
touch the
”OK”.
ON: The previous screen automatically re-
turns from the audio or air conditioner screen
20 seconds after the end of audio or air con-
ditioner screen operation.
OFF: The audio or air conditioner screen re-
mains on. You can adjust the brightness or contrast
of the screen depending on the bright-
ness of your surroundings. Y
ou also can
turn the display off.
Push the
”DISPLAY” button on the bez-
el to display the Display screen.
Screen transitionScreen adjustment

104
2003 Land Cruiser 100 Navigation (OM60A00U)
UNG405
Contrast and brightness adjustment
CONTRAST ”+”:
Strengthens the contrast of the screen.
CONTRAST ””:
Weakens the contrast of the screen.
BRIGHTNESS ”+”: Brightens the screen.
BRIGHTNESS ””: Darkens the screen.
The screen turns off when you push the
”SCREEN OFF”. To turn the display screen
back on, push any bezel switch such as
”INFO”, etc. The selected screen appears.
UNX401
Color and tone adjustment
You can adjust the color and the tone while
the DVD video and Video CD are being
played.
COLOR ”RED”:
Strengthens the red color of the screen.
COLOR ”GREEN”:
Strengthens the green color of the screen.
TONE ”+”: Strengthens the tone of the
screen.
TONE ””: Weakens the tone of the screen.
UNG407
Depending on the position of the head-
light switch, the screen changes to the
day mode or night mode.
To display the screen in the day mode even
with the head light switch on, touch ”DAY
MODE” on the adjustment screen for bright-
ness and contrast control.
However, if the instrument panel light control
switch is turned fully to the right, mode
switching cannot be done. It remains in the
day mode. In this case, ”DAY MODE” is not
shown on the screen.
If the screen is set in the day mode with the
headlight switch turned to on, this condition
is memorized in the system even with the en-
gine turned off.

106
2003 Land Cruiser 100 Navigation (OM60A00U)
Automatic air conditioning controls
Page
1. Air conditioning onoff switch 111 .
2. Air flow control switch 109 . . . . . . . .
3. Fan speed control switch 110 . . . . . .
4. Air intake control button 110 . . . . . . .
5. Air conditioning operation screen display button 108 . . . . . . . . .
6. Front windshield button 111 . . . . . . .
7. OFF button 108 . . . . . . . . . . . . . . . . . . .
8. Automatic control button 108 . . . . . .
9. Driver side temperature control button 109 . . . . . . . . . . . . . . . .

108
2003 Land Cruiser 100 Navigation (OM60A00U)
The automatic air conditioning auto-
matically maintains the set tempera-
ture.
This air conditioning features automatic
fan speed and air flow control which auto-
matically selects the most suitable fan
speed and air flow to control the tempera-
ture. The ignition key must be in the ”ON”
position.
CLIMATE: Push this button to display
switches for automatic air conditioning con-
trols.
NOTICE
To prevent the battery from being dis-
charged, do not leave the air condition-
ing on longer than necessary when the
engine is not running.
SETTING OPERATION automatic con-
trol
1. Push the ”AUTO” button.
Air flow quantity, switching of the diffusers,
on−off of the air conditioning, and switching
of the air intake between RECIRCULATED
AIR and OUTSIDE AIR are automatically ad-
justed. The operation status is shown by
each indicator.
When one of the manual control buttons is
depressed while operating in automatic
mode, the mode relevant to the depressed
button is set. Other conditions continue to be
adjusted automatically. Push
the ”OFF” button to turn the air condi-
tioning off.
It is recommended that you close the lower
vent. For details about this, see page 113.
(a) Climate control

111
2003 Land Cruiser 100 Navigation (OM60A00U)
In the following cases, the RECIRCULATED
mode may change to the OUTSIDE AIR
mode automatically to prevent interior fog.
When the outside temperature becomes
lower than 4 C (39 F).
 When the air conditioning compressor
malfunctions.
 When the air conditioning cooler refriger-
ant decreases. If manual onoff of the air conditioning is
desired
Push the ”A/C”
switch to turn the air condi-
tioning on and push it again to turn the air
conditioning off.
If the outside temperature is lowered down to
around 0 C (32 F), the air conditioning will
turn off automatically.
If the system is used for ventilation, heating
in dry weather or removing frost or exterior
fog on the windshie ld, turn the air condition-
ing off once it is no longer required. This will
improve fuel economy. The air conditioning
can be used for year −round automatic tem-
perature control including cooling and dehu-
midifying operation.
UNC504
To remove interior fog on the windshield
Push the ”FRONT WINDSHIELD” button.
To remove frost or exterior fog on the
windshield
1. Push the upper side of the temperature control button until maximum figure ap-
pears on the temperature display.
2. Push the ”FRONT WINDSHIELD” but- ton.
(b) Windshield defogging and
defrosting

11 6
2003 Land Cruiser 100 Navigation (OM60A00U)
Audio System
Quick reference for your audio system
Page
1. Audio operation screen display button 117
. . . . . . . . . . . . . . . . . . . . . . .
2. Function switch display screen 118
. . . . . . . . . . . . . . . . . . . . . .
3. Cassette tape slot 125 . . . . . . . . . . . .
4. Frequency turning knob 122 . . . . . . .
5. [Radio mode] Preset tuning 122 . . .
[Tape mode] Side change of
cassette tape 127 . . . . . . . . . . . . . . . .
[DISC mode] Disc selection 131 . . .
6. Traffic function button 123 . . . . . . . . .
7. Mode selectors 118 . . . . . . . . . . . . . . .
8. Stopping and ejecting a cassette tape 125 . . . . . . . . . . . . . . . .
9. [Radio mode] Seek tuning 123 . . . . .
[Tape/DISC mode] Direct access
to a desired program 127/131 . . . . .
10. Turning the system on and adjusting the volume 117 . . . . . . . . .

11 7
2003 Land Cruiser 100 Navigation (OM60A00U)
This section describes some of the basic fea-
tures of the audio system. Some information
may not pertain to your system.
Your audio system works when the ignition
key is in the ”ACC” or ”ON” position.
NOTICE
To prevent the battery from being
discharged, do not leave the car audio
on longer than necessary when the
engine is not running.
ocu002
Speech command system
Some descriptions in this manual are
marked with the above indicator. This
means that this function can be activated
using the speech command system.
For the operation of the speech command
system and the command list, see page 98
and 151.
POWERVOL: Push this knob to turn the
audio system on and off. Turn this knob to
adjust the volume. The system turns on in
the last mode used.
AUDIO: Push this button to display switches
for audio system.
Using your audio system:
s
ome basics
(a) Turning the system on and
off

11 8
2003 Land Cruiser 100 Navigation (OM60A00U)
Push the ”AM”, ”FM”, ”TAPE” or ”DISC”
button to turn on that mode. The selected
mode turns on directly.
Push these buttons if you want to switch from
one mode to another.
If the tape or disc is not set, the cassette play-
er or compact disc player does not turn on.
You can turn off the cassette player by eject-
ing the cassette tape. If the audio system
was previously off, then the entire audio sys-
tem will be turned off when you eject the cas-
sette tape. If another function was previously
playing, it will come on again.
UNG604
UNG605
The switches for radio, cassette tape and
disc player operation are displayed on
the liquid crystal display. Touch them
lightly and directly on the screen.