mirror TOYOTA LAND CRUISER 2012 User Guide

75
1
Before driving
L/C200_EE (OM60G38E)
1-3. Adjustable components (seats, mirrors, steering wheel)
Front seats
Manual seat
Seat position adjustment
lever
Seatback angle adjustment
lever
Vertical height adjustment
lever
*
Seat cushion (front) angle
adjustment knob
*
Lumbar support control
switch
*
*
: Driver’s side only2134
5
ITY13C003

76 1-3. Adjustable components (seats, mirrors, steering wheel)
L/C200_EE (OM60G38E)
Active head restraint
When the occupant’s lower back
presses against the seatback
during a rear-end collision, the
head restraint moves slightly for-
ward and upward to help reduce
the risk of whiplash on the seat
occupant.
Power seat
Seat position fore/aft control
switch
Seatback angle control
switch
Seat cushion (front) angle
control switch
Vertical height control
switch
Lumber support control
switch (driver’s side only)

77 1-3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
L/C200_EE (OM60G38E)
Active head restraint
Even small forces applied to the seatback may cause the head restraint to
move. Pushing up a locked head restraint forcibly may make the inner struc-
ture of the head restraint appear. This does not indicate a problem.
CAUTION
Seat adjustment
Be careful that the seat does not hit passengers or luggage.
Do not recline the seat more than necessary when the vehicle is in motion
to reduce the risk of sliding under the lap belt.
If the seat is too reclined, during an accident the lap belt may slide past the
hips and apply restraint forces directly to the abdomen or your neck may
contact the shoulder belt, increasing the risk of death or serious injury.
Adjustments should not be made while driving as the seat may unexpect-
edly move and cause the driver to lose control of the vehicle.
After adjusting the seat, make sure that the seat is locked in position.
(manual seat only)
Inner structureDuring
rear-end
collision

78
1-3. Adjustable components (seats, mirrors, steering wheel)
L/C200_EE (OM60G38E)
Rear seats
Second seat
Seatback angle adjustment
lever
Seat position adjustment
lever
Third seat (if equipped)

79 1-3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
L/C200_EE (OM60G38E)
Tumbling the second seats and third seat entry
Vehicles with third seat: For easy access to the third seat, perform
in “Tumbling the second seats” (P. 8 0 ) .
Before tumbling the second seats
Stow the seat belt buckles and
lower the head restraints to the
lowest position.
Pass the outer seat belts through
the seat belt hangers and secure
the seat belt plates.
This prevents the shoulder belt
from being damage.
Make sure that the seat belts are
removed from the hangers before
using them.
STEP1
STEP1
ITY13C013a
STEP2

80 1-3. Adjustable components (seats, mirrors, steering wheel)
L/C200_EE (OM60G38E)Tumbling the second seats
Fold down the seatback while
pulling the seatback angle
adjustment lever, and swing the
whole seat up and forward.
Hook the holding strap to the
assist grip and secure the seat
by pulling its free end.
When returning the second seat
to its original position, stow the
holding strap.
Remove the seat hook covers
from the back of the seat cush-
ion, and install them on the seat
hooks.
When returning the second seat
to its original position, remove the
seat hook covers from the floor
and install them in the back of the
seat cushion.
STEP1
STEP2
ITY13C025
STEP3

81 1-3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
L/C200_EE (OM60G38E)
Folding up the third seats
Before folding up the third seats
Stow the seat belts buckles.
If you cannot raise the seatback
Lift the seatback until it stops.
Lower the seatback a little then lift it
again.
ITY13C139a
STEP1
STEP2
STEP1

82 1-3. Adjustable components (seats, mirrors, steering wheel)
L/C200_EE (OM60G38E)Pass the outer seat belts through
the seat belt hangers and secure
the seat belt plates.
This prevents the shoulder belt
from being damage.
Make sure that the seat belts are
removed from the hangers before
using them.
Folding up the third seats
Fold down the head restraints
while pulling the head restraint
angle levers.
Push the seatback angle levers
and fold the third seats.
ITY13C021a
STEP2
ITY13C022
STEP1
STEP2

83 1-3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
L/C200_EE (OM60G38E)Pull the seat leg lock release
levers.
The seat will rise, and the seat-
back striker will also automatically
sit up.
Before raising, make sure that the
handle on the rear of the seat-
back is secure.
Secure the seats by the strikers.
Remove the seat hook covers
from the back of the seat cush-
ion, and install them on the seat
hooks.
Returning the third seats
Remove the seat hook covers
from the floor and install them
into the back of the seat cushion.
STEP3
STEP4
ITY13C030
STEP5
STEP1

84 1-3. Adjustable components (seats, mirrors, steering wheel)
L/C200_EE (OM60G38E)Unlock the seats by pulling the
stowed seat lock release levers
and lower the seats to its original
position.
Secure the seats by the strikers.
Pull the handle and raise the
seatbacks.
Fix the handle securely in its orig-
inal position after use.
Raise the head restraints.
STEP2
STEP3
STEP4
STEP5