keyless entry TOYOTA MR2 SPYDER 2001 Accessories, Audio & Navigation (in English)

REMOTE CONTROL PROGRAMMING RS3200/ REMOTE KEYLESS ENTRY FOR MR2-SPYDER
1 . Before you begin: 2. Start the Programming Procedure.
Open the driver’s door. (Complete these steps within 40 seconds.)
Remove the key from the ignition switch.
Note: If the system does not activate the lights and buzzer, start over.\
Page 1

a . Insert the key into,
and remove it
from the ignition
switch 2 times.

e . Insert the key into
the ignition and
leave it in.
c. Insert the key into,
and remove it
from the ignition
switch 1 time.

g . Turn the key from
LOCK to ON 1
times (ending at
LOCK.)
h. Remove the key
from the ignition
switch.
i . The tail and
marker lights
flash 1 times and
the buzzer
chirps 1 times.
j . The doors will lock
and unlock 1 time.

b. Close, then open
the driver’s door
2 times.

f. Close the driver’s
door.
d. Close, then open
the driver’s door .

The RS3200 ECU of the MR2 Spyder Remote Keyless Entry (RKE) system can\
be programmed to be
operated with as many as 4 remote controls. To add or delete remote con\
trols, you must follow the
procedure below. This procedure also applies when replacing the RKE ECU.\

NOTE: The RKE is factory-set to unlock the driver's door when the UNLOCK\
button is pressed on the
remote control, then unlock the remaining doors when the UNLOCK\
button is pressed again within 3 seconds.