warning TOYOTA PRIUS V 2013 Accessories, Audio & Navigation (in English)

Page 1 T OYOTA — RS3200 PLUS Security System
TABLE OF CONTENTS
To better understand the features and functions of this security system, \
please read this
Owner’s Guide completely prior to use.
DESCRIPTION P AGE
INTRODUCTION
2
BRIEF DESCRIPTION–RS3200 PLUS FEA

TURES
3, 4
OPERA

TION
ARMING

THE RS3200 PLUS (except PASSIVE ARMING)
5
DISARMING

THE RS3200 PLUS (except PASSIVE DISARMING)
6
P

ASSIVE (AUTOMATIC) ARMING & DISARMING
7
AUT

OMATIC REARMING
8
ARMING SUSPENSION


8
ALARM INFORMA

TION
ALARM TRIGGERS 9
ALARM DESCRIPTIONS


10
ST

OPPING AN ALARM
10
GLASS BREAKAGE SENSOR INFORMA

TION
GLASS BREAKAGE SENSOR CHECK PROCEDURE


1
1
PROGRAMMING
P

ASSIVE (AUTOMATIC) ARMING AND ENTRY DELAY
12
(Not applicable to Highlander and Sienna. Please consult
your

Toyota Dealer for programming information.)
WARNING and CAUTION INFORMATION

13

Page 11 T OYOTA — RS3200 PLUS Security System
GLASS BREAKAGE SENSOR INFORMATION
The RS3200 PLUS provides protection for your vehicle above and beyond en\
try point
monitoring–it “listens” for the noise made by tapping on, or br\
eaking of glass. Using a
microphone designed specifically for this task, the GLASS BREAKAGE SENSOR is
capable of ignoring other noises, which helps to prevent “false alarm\
s” from occurring.
GLASS BREAKAGE SENSOR CHECK PROCEDURE
When the RS3200 PLUS was installed in your vehicle, care was taken to ad\
just the
sensitivity level of the GLASS BREAKAGE SENSOR. You may observe how it works
following the procedure listed below.
1.

ARM the system.

Press the lock button on the remote control or lock the doors
with the key.
(Remember, the system will not ARM if any door, the trunk or
hatch is open.)

2.

W
ait until the STATUS MONITOR’S LED starts flashing. The
LED will flash 30 seconds after the last door, the trunk or
hatch is closed.
* for some vehicles the LED will turn off instead of flashing after the 30 seconds.



3.

With the tip of a key
, tap the center of the driver’s door
window. Tap the glass with light to moderate force.
WARNING: Do not hit the glass with excessive force, especially in cold weather, or you may crack or break it.
A WARN AWAY ALARM should be TRIGGERED. If the
ALARM is not TRIGGERED, make sure you performed the
procedure correctly and try again. If you find that the system
did not perform as expected, contact your Toyota dealer for
more information.
4.

DISARM the system to stop the W
ARN AWAY ALARM. Press
the unlock button

Page 13 T OYOTA — RS3200 PLUS Security System
Warning
• This product is applicable only to vehicles with 12V DC, negative ground\
ing
specifications. Do not use in vehicles with 24V specifications. Otherwis\
e, damage
to the unit or a fire may result.
•

Never attempt to disassemble or modify the product. Otherwise, an accide\
nt, fire
or electric shock may result.
•


When replacing fuses, be sure to use fuses with the same specified capac\
ity
(amperage.) Otherwise, damage to the unit or vehicle, fire or electric\
shock may
result.
•


If an abnormal condition occurs, such as liquids spilling onto the produ\
ct, or the
product emitting smoke or strange odors, stop using it immediately and c\
onsult
the dealer from whom you purchased the product. Continued use of the pro\
duct
before corrective actions are taken may result in an accident, injury or\
fire.
•


Never pull the plastic bag over your head. Otherwise, a serious injury o\
r death
from suf

focation may occur.

Caution
• Do not use this product for applications other than in-vehicle use. Othe\
rwise, an
electric shock or injury may result.
•

Do not allow children to play with the remote controls. Otherwise, the d\
oors may
be locked or unlocked, the security system armed or disarmed, or an alar\
m
triggered unintentionally

.
•

If this product is dropped or its case is damaged, disconnect the power \
supply
lead and contact the dealer from whom you purchased it to obtain service\
. Other-
wise, a fire or electric shock may result.