window TOYOTA PRIUS V 2013 Accessories, Audio & Navigation (in English)
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2013, Model line: PRIUS V, Model: TOYOTA PRIUS V 2013Pages: 14, PDF Size: 0.6 MB
Page 3 of 14

TOYOTA — RS3200 PLUS Security System Page 2
INTRODUCTION
Congratulations on your choice of the RS3200 PLUS add-on security system\
to pro-
tect your vehicle! To get the most from the system, we strongly recommend that you
read this Owner’s Guide completely to learn all of its features and functions.
The RS3200 PLUS provides security through point-of-entry monitoring, gla\
ss break-
age detection and ignition switch monitoring. While ARMED, the system will be
TRIGGERED and sound an ALARM when a door, trunk or hatch is forcibly unlocked
or opened*, or when a window is tapped on or broken. During the ALARM, the ve-
hicle’s horn sounds and the headlights, tail lights and front marker or turn s\
ignal lights
flash. Also, the vehicle’s starter is disabled, preventing engine start. In addition to the
comprehensive protection, the RS3200 PLUS works in conjunction with your\
vehicle’s
remote keyless entry system, enabling you to ARM and DISARM the security system
at the same time the doors are remotely locked and unlocked. In vehicles\
equipped
with a buzzer, it will chirp when the system is REMOTE ARMED and DISARMED.
An important note about your system:
Throughout this guide, there are references to the STATUS MONITOR for this sys-
tem. Illustrated below, this panel holds the LED indicator (for the system’s operating
status) and the GLASS BREAKAGE SENSOR’S microphone. In vehicles equi\
pped
with an engine immobilizer system, there is a LED already installed, so \
the RS3200
PLUS utilizes the vehicle’s engine immobilizer system LED instead and a microphone
mounted in a separate location. If your vehicle falls into this category\
, remember to
look at that LED when the information refers to the STATUS MONITOR. If you do
not know where the LED is located, refer to your vehicle’s owner’s guide for specific
information.
* When the system is PASSIVELY (AUTOMATICALLY) ARMED, there is an ENTRY
DELAY that will elapse when a door is opened before an ALARM is TRIGGERED.
123123123
Your engine immobilizer system led may look
different than the one illustrated here
Page 5 of 14

TOYOTA — RS3200 PLUS Security System Page 4
BRIEF DESCRIPTION–RS3200 PLUS FEATURES
FEATURESFUNCTIONS
GLASS
BREAKAGE
SENSOR The RS3200 PLUS utilizes a microphone (usually mounted in the
STATUS MONITOR) to sense the noise from tapping on window
glass, or glass breaking, and TRIGGER the system to sound
an ALARM. It is fine tuned to “listen” for this type of noise, and
ignore other sounds.
WARN AWAY
ALARM When the GLASS BREAKAGE SENSOR’S microphone picks
up tapping or breaking of window glass, it TRIGGERS a WARN
AWAY ALARM; the headlights and tail and marker or turn signal
lights flash, and the horn sounds for 20 seconds, but the starter
is not disabled. If there is another detection of glass tapping or
breaking, or if a door is opened or unlocked without a key, the
regular ALARM is TRIGGERED.
IGNITION
SWITCH
MONITORING While ARMED, the RS3200 PLUS monitors the ignition switch. If
an attempt is made to start the vehicle without a key, an ALARM
is TRIGGERED.
STARTER
DISABLE When an ALARM is TRIGGERED, the system disables the ve-
hicle’s starter and prevents engine start until the system is reset
(DISARMED).
FORCED LOCK
DURING ALARM During an ALARM, the system will lock the doors if one is un-
locked, and will continue to do so for the duration of the ALARM.
TRIGGER
MEMORY* The user is notified that an ALARM occurred. Upon DISARMING
the system after an ALARM was TRIGGERED, the vehicle’s tail
and marker lights will be turned on for 2 seconds.
EXTERIOR
LIGHT
ACTIVATION The RS3200 PLUS flashes the vehicle’s tail and marker or turn
signal lights during REMOTE ARMING and REMOTE DISARM-
ING, and during an ALARM. Also, during an ALARM the head-
lights flash.
BUZZER
ACTIVATION If your vehicle is equipped with a buzzer that chirps when the lock
and unlock buttons on the remote keyless entry system’s remote
controls are pressed, the buzzer will also chirp when the system
is REMOTE ARMED and DISARMED.
HORN
ACTIVATION During an ALARM, the RS3200 PLUS activates the vehicle’s
horn.
POWER LOSS
MEMORY If power to the RS3200 PLUS is disrupted while it is ARMED, an
ALARM is TRIGGERED once power is restored.
STATUS
MONITOR This panel houses the GLASS BREAKAGE SENSOR micro-
phone and the flashing LED that indicates the operating status
of the security system. (Some vehicle applications utilize the
vehicle’s engine immobilizer system LED and a separate micro-
phone, instead.)
* TRIGGER MEMORY is not available for Corolla / Matrix.
Page 12 of 14

Page 11 T OYOTA — RS3200 PLUS Security System
GLASS BREAKAGE SENSOR INFORMATION
The RS3200 PLUS provides protection for your vehicle above and beyond en\
try point
monitoring–it “listens” for the noise made by tapping on, or br\
eaking of glass. Using a
microphone designed specifically for this task, the GLASS BREAKAGE SENSOR is
capable of ignoring other noises, which helps to prevent “false alarm\
s” from occurring.
GLASS BREAKAGE SENSOR CHECK PROCEDURE
When the RS3200 PLUS was installed in your vehicle, care was taken to ad\
just the
sensitivity level of the GLASS BREAKAGE SENSOR. You may observe how it works
following the procedure listed below.
1.
ARM the system.
Press the lock button on the remote control or lock the doors
with the key.
(Remember, the system will not ARM if any door, the trunk or
hatch is open.)
2.
W
ait until the STATUS MONITOR’S LED starts flashing. The
LED will flash 30 seconds after the last door, the trunk or
hatch is closed.
* for some vehicles the LED will turn off instead of flashing after the 30 seconds.
3.
With the tip of a key
, tap the center of the driver’s door
window. Tap the glass with light to moderate force.
WARNING: Do not hit the glass with excessive force, especially in cold weather, or you may crack or break it.
A WARN AWAY ALARM should be TRIGGERED. If the
ALARM is not TRIGGERED, make sure you performed the
procedure correctly and try again. If you find that the system
did not perform as expected, contact your Toyota dealer for
more information.
4.
DISARM the system to stop the W
ARN AWAY ALARM. Press
the unlock button