run flat TOYOTA RAV4 1996 Service Repair Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 1996, Model line: RAV4, Model: TOYOTA RAV4 1996Pages: 1632, PDF Size: 41.64 MB
Page 47 of 1632

Installation
To install, reverse removal procedure. Ensure spiral cable is properly aligned. See SPIRAL CABLE under
ADJUSTMENTS. Connect air bag connector. Tighten 2 Torx screws to specification. See TORQUE
SPECIFICATIONS . Install steering wheel side covers. Perform SYSTEM OPERATION CHECK .
PASSENGER-SIDE AIR BAG
Removal & Installation
1. Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS . Turn ignition
switch to LOCK position. Disconnect and shield negative battery cable. Wait at least 90 seconds before
working on system.
2. Disable SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM
. Remove instrument panel.
Remove the 2 bolts securing passenger-side air bag. See Fig. 10
. Remove air bag. Remove 3 bolts and
pry up the 5 air bag door clips and remove the air bag door. See Fig. 11
.
3. To install, reverse removal procedure. Tighten passenger-side air bag bolts to specification. See
TORQUE SPECIFICATIONS
. Activate SRS. See DISABLING & ACTIVATING AIR BAG
SYSTEM . Check air bag warning light to ensure system is functioning properly. See SYSTEM
OPERATION CHECK . WARNING:During installation, if spiral cable mating mark is not properly aligned,
steering wheel may not turn completely, or flat cable inside spiral cable
may be severed, disabling SRS system.
1996 Toyota 4Runner
AIR BAG RESTRAINT SYSTEM 1996 ACCESSORIES/SAFETY EQUIPMENT Toyota Air Bag Restraint System
Microsoft
Tuesday, August 18, 2009 7:33:32 PMPage 13 © 2005 Mitchell Repair Information Company, LLC.
Page 926 of 1632

Fig. 22: Removing Instrument Panel (Sienna)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Removal & Installation (Tacoma)
1. Disable air bag system, remove driver's air bag and steering wheel. See AIR BAG RESTRAINT
SYSTEMS article. Remove lower finish panel. Remove steering column covers.
2. Remove starter switch bezel (if necessary). Remove cluster finish panel retaining screws. Using flat-
blade
screwdriver, pry instrument cluster finish panel loose from 3 retaining clips.
3. Remove 4 instrument cluster retaining screws. Pull instrument cluster out far enough to disconnect wiring
harness connectors. Remove instrument cluster. To install, reverse removal procedure.
Removal & Installation (Tundra)
Disable air bag system, remove driver's air bag and steering wheel. See AIR BAG RESTRAINT SYSTEMS
article. Remove steering column covers and combination switch. Remove combination meter finish panel.
Remove combination meter. To install, reverse removal procedure.
Removal & Installation (4Runner)
1. Disable air bag system, remove driver's air bag and steering wheel. See AIR BAG RESTRAINT
SYSTEMS article. Remove steering column covers. Remove 4 lower finish panel retaining bolts. Remove
hood release and fuel tank lid release lever.
2. Using a screwdriver, carefully remove instrument panel lower finish panel. Remove ignition switch bezel.
Disconnect air registers. Remove 4 retaining screws from instrument cluster finish panel. Carefully
remove cluster finish panel. Disconnect wiring harness connectors.
3. Remove instrument cluster retaining screws. Pull cluster outward enough to disconnect wiring harness
connectors. Remove instrument cluster. To install, reverse removal procedure.
WIRING DIAGRAMS
1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Instrument Panels - Trucks
Microsoft
Sunday, November 22, 2009 10:54:10 AMPage 36 © 2005 Mitchell Repair Information Company, LLC.